熱氣流調節器 的英文怎麼說

中文拼音 [rèqìliúdiàojiéqì]
熱氣流調節器 英文
dampers
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 調 : Ⅰ動詞1 （配合得均勻合適） harmonize; suit well; fit in perfectly 2 （使配合得均勻合適） mix; adju...
  • 節 : 節構詞成分。
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 氣流 : 1 [氣象學] air current; airflow; wind current; airstream2 [語言學] breath氣流紡紗 open end spinni...
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. The control system of furnace " s temperature has been widely used in every walk of life, as an important link of repair and manufacture of the electrical equipment such as electromotor transformer etc., soaking lacquer drying craft has some especial requests on drying crafto this article starts with the analysis of drying chamber " s configuration, analyzed its configuration limitation and control function limitation according to the factory " s situation and advances the conception of heated air drying circulation, in addition, this article adopts an intellectualize a / d module, a development sampling tuning - voltage circuit, and presents the method to measure online the insulation resistance of products in order to improve constantly products quality

    而浸漆乾燥工藝作為電機、變壓器等電氣設備的修理、製造中的重要環節之一，對乾燥過程的質量要求有一定的特殊性。該文從乾燥爐的結構分析入手，聯繫到工廠的實際情況分析了結構功能缺陷和控制功能缺陷，提出了熱風循環乾燥的概念，同時，選擇了較為先進的a d板卡、熱電阻信號調理板等專業化智能卡，運用數字pid控制技術，構成了一個較有特色的計算機控制系統。此外，該文還從保證乾燥品質量的角度，採用智能化交流模塊和自製采樣調壓電路的方法，提出了在線檢測產修品的絕緣電阻的方法和手段，以確保企業產品質量不斷提高。
  2. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。
  3. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變；實驗臺的流量測量採用風機動力性能測試標準中流量方法等。
  4. Our factory increase a set of intensifier with non - grade - adjustable rating speed to form the intensive air drying, the wet material mixed with hot air fully by screw feeder in the intensifier and material surface is crashed into fine granules and moving to the outlet as well as drying, under rapid rotating hitting and pushing. in the long run, the materials get a further even drying in the dryer pulled by the wind force and those wet and weighty granules the wind force can not pull continue to be crashed, dried until they are pulled by the wind force into the dryer

    我廠強化型氣流乾燥是在基本型上增加一套轉速可以無級調節的強化器組成，濕物料通過螺旋加料器進入強化器后和熱氣流充分混合，在飛速旋轉的擊刀擊碎和推進下，物料被破碎成細顆粒，在乾燥同時向出口移動，最後在風力吸引下進入乾燥管，進一步均勻乾燥，風力無法吸引的濕重顆粒繼續被擊碎、乾燥、直至能被風吸起進入乾燥管。
  5. In order to save oil for ignition and raise cyclic operation capability of utility boilers, eih for oil - free ignition and stable combustion is adopted to de ? gn the burner and experimental system in this thesis

    本文根據煤粉氣流的著火理論，針對火電廠節約點火用油和提高調峰能力，採用了電磁感應加熱無油直接點火與穩燃技術設計燃燒器結構和實驗系統。
  6. To improve the performance of ashp, an improved ashp system is presented. different from the original system, the new one can control the refrigerant flow rate by the sub - cooling of condenser and adjust the sup - heating of the compressor inlet vapor by the heater in accumulator. the simulation shows the new system not only has better dynamic characteristic of frost and defrost of ashp, but also has higher coefficient of performance

    為改善空氣源熱泵機組的結霜除霜動態性能，提出了一種利用冷凝器過冷度來調節製冷劑流量，在氣液分離器里增加電熱裝置保持壓縮機進口過熱度的改進型系統，結果表明這種改進型系統不但可以改善系統的運行性能，同時能改善系統運行的經濟性，為機組的技術升級和產品更新提供了一個新的途徑。
  7. Air conditioners, liquid chilling packages and heat pumps with electrically driven compressors for space heating and cooling - testing and rating at part load conditions

    對流式供暖和製冷用帶有電動壓縮機的空氣調節器液體製冷包和熱泵.部分負載條件下的檢驗和額定
  8. This system is utilized the programmable controller ( plc ) bearing of substitution rule ( the figure is apparent the form, writing instrument, individual loop controller, the hand is holded the utensil and is reached to assist the bearing unit and await ), achieve the 29mw ' s cycle stream of water warmhearted water boiler, oxygen remover, warmhearted net system control system together with monitoring voluntarily of electric section together with control being living, the rule to call off greats quantity displays the bearing in that system, boiler, oxygen remover, the warmhearted net operation is achieved crt and is supervised completely, manipulates personnel staff is living inner place the control cabin completely completees failure - free operation and trouble removal operation. the predictive target of putting ino production queen is the boiler, oxygen remover, the warmhearted net is achieved comprehensive self - regulation, moreover be able to be over a long period of time, steady secure operation

    本系統利用可編程式控制制器（ plc ）替代常規的儀表（數顯表、記錄儀、單迴路控制器、手操器及輔助儀表裝置等） ，實現29mw循環流化床熱水鍋爐、除氧器、熱網系統控制系統與電氣部分的自動監測與控制。在該系統中取消大量的常規顯示儀表，鍋爐、除氧器、熱網的運行實現crt全面監控，操作人員在控制室內全部完成正常運行及事故處理操作。投產后的預期目標是鍋爐、除氧器、熱網實現全面自動調節，並能長期、穩定、安全運行。
分享友人
分享到 Line

分享到臉書