熱沉降 的英文怎麼說

中文拼音 [rèchénjiàng]
熱沉降 英文
thermal precipitation
  • 沉 : Ⅰ動詞1 （沉沒; 墜落） sink 2 （沉下 多指抽象事物） keep down; lower 3 [方言] （停止） rest Ⅱ形容...
  • 降 : 降動詞1. （投降） surrender; capitulate 2. （降伏） subdue; vanquish; tame
  1. Keywords : moisture distribution, bound water content, bonding energy, solid - liquid separation, gravitational sedimentation, filtration and expression, centrifugal separation, thermal pyrolysis, and resource reuse and utilization

    關鍵詞：水份分佈、結合水量、水份鍵結能、固液分離、重力沉降、過濾壓榨、離心分離、無氧熱分解、資源回收利用。
  2. Ferritic - pealitic steels for precipitation hardening from hot - working temperatures

    用熱處理溫度進行沉降硬化的珠光體型鐵素體鋼
  3. The other effect brings about by coat on a large scale is discussed preliminary which including increasing the " hot island effect " of cities ; increasing the hydrous of the roads after rain and increasing the sinkage of ground surface in the city

    同時初步探討用水泥以及瀝青大規模地覆蓋土壤所造成的其他影響，這些影響包括加重了城市的「熱島效應」 、加重了城市由於雨後道路積水所導致的交通堵塞、加重了城市地面的沉降。
  4. Through summarization for complicated geohydrology and engineering geology condition of research area, the non - stability 3 - dimension flow model of ground water and land subsidence model were established in this thesis. the coupled models of ground water and land subsidence were combined with a large series of water level observation and land subsidence information to debug the parameters and ascertain the models

    兩者通過含水層的水位內在聯系耦合在一起，並根據研究區水文地質條件及抽水試驗資料，結合大量的水位觀測序列資料及地面沉降觀測資料對模型進行調參，標定地下熱水運移的三維有限元數值模型，所建模型可以對地下水水位及地面沉降同時進行模擬預測。
  5. Compared to the basins in east guangxi, the basin of north guangxi is characterized by lower depositional and tectonic subsidence rate during rifting, longer thermal subsidence, later inflexion point from rifting to foreland buckling, as well as later inflexion point separating stable stage from active stage during foreland - buckling

    但與桂東大瑤山地區相比，桂北興安地區在裂陷階段的沉積速率和構造沉降速率明顯偏低；熱沉降階段的持續時間偏長；裂陷階段與前陸撓曲階段的分界拐點偏晚；前陸撓曲階段，由構造寧靜期的緩慢沉降向構造活動期的快速沉降轉化的分界拐點也偏晚。
  6. Of the currently available coolers for electronic products with a high heat flux, micro - jets impingement cooling heat sinks are able to provide the best heat transfer performance : lowering the maxmal temperature and the temperature difference. the heat transfer for multiple jets impingement has been studied firstly for summarizing a few rules. and then a copper micro - jets impingement cooling heat sink consisting of five copper sheets is designed in this paper and the jet diameter is 0. 15mm

    本文首先對陣列射流沖擊進行了實驗研究，總結了陣列射流沖擊的一些規律和特性，在此基礎上，根據數值模擬優化結果設計和製作了微射流陣列冷卻熱沉（射流孔直徑d = 0 . 15mm ） ，並採用去離子水和氮氣作為工質，對熱沉內流體壓降和傳熱特性進行了研究。
  7. The results are of great practical significance on the efficient development of geothermal water and the control of land subsidence in practice. the models can also be applied to the areas with homologous hydrogeological condition

    研究成果對于進一步揭示福州溫泉區地下熱水動態特徵，對于福州地區地下熱水資源合理開發利用，有效控制地面沉降具有重要的實際意義。
  8. Design specification of thermo - chemical setting dehydration for crude oil

    原油熱化學沉降脫水設計規范
  9. The results instructed further utilization of thermophoresis in industrial of fine particle catching. the experiment data of the gas - particle two - phase flow in horizontal duct was been analyzed

    所得的結果為進一步在實踐中研究利用熱泳力提高細顆粒的沉降效率進而脫除細顆粒提供了理論分析結果。
  10. Of the currently available coolers for electronic products with a high heat flux, microchannel heat sinks have been proved to be able to provide the best heat transfer performance and are one of the most promising coolers. the manifold microchannel ( mmc ) heat sink has many advantages such as low thermal resistance, compact structure, little amount of coolant, low flow rate, uniform temperature distribution along the flow direction and many others, so it is able to provide the best heat transfer performance : lowering the maxmal temperature and the temperature difference

    在目前高熱通量電子產品冷卻器中，微通道熱沉已被證實是傳熱性能最佳且最具應用潛力的冷卻方式之一，而歧管式微通道熱沉因具有低熱阻、結構緊湊、所需冷卻液量小、沿流動方向溫度分佈均勻等優點則成為減小電子元器件換熱表面最高溫度、降低溫度變化的一種有效方法。
  11. Results obtained in the research are : l. by the virtue of palaeostructure analysis and method of balanced cross sections, we have studied the formation and development history of qianmiqiao buried hills, and indicate that the formation of ordovician buried hills can be mainly divided into four periods, namely, stable uplift period, fold - thrust period, block - fault tilting period, and thermal subsidence and depression period

    論文取得以下成果： 1採用古構造分析和平衡剖面技術，研究了千米橋潛山的形成演化史，指出其下古生界奧陶系潛山的形成主要經歷了穩定抬升、褶皺沖斷、塊斷翹傾和熱沉降坳陷四個時期。
  12. Nothing can be cooler than 0k. the gas below the photosphere has a higher temperature and so will rise up to the photosphere. after releasing its energy, the gas will become cooler and darker

    光球層之下的氣體溫度比光球層高，就好像沸騰的水，底層的氣體會向上升，當這些熾熱氣體把能量釋放后，便會變冷變暗，然後沉降回光球層之下，這種對流運動產生了稱為
  13. Powders properties of different phases such as the granularity, the shape and the component have been analyzed by the methods of sieving, gravity sedimentation, spectrophotometry, scan electronic microscope ( sem ), transmission electronic microscope ( tem ) and x - ray diffraction ( xrd ). the results show that technic of ball milling and parameters of heat treatments are important influencing factors to properties of cu - zn powders

    採用篩分法、重力沉降法、分光光度法、掃描電鏡法、透射電鏡法和x射線衍射法對不同階段的銅鋅粉末的粒度、形貌、成分等性質進行了分析，結果表明：球磨工藝及熱處理參數對銅鋅粉的性能有重要影響。
  14. The experimental results of the flow characteristics of the mmc heat sink indicate that the critical reynolds number signifying the transition from laminar flow to turbulent flow is in advance ; under the same experimental conditions, the variation in entrance direction of the microchannel inlet and outlet has little effect on the microchannel ; the experimental values of the friction factor of the de - ionized water in a microchannel agree well with those calculated using the theoretical laminar formula ; furthermore, a comparison of the experimental results and simulation results shows that navier - stokes equation and rng - turbulence model can be used to model the laminar and turbulence flow regions in a microchannel ; meanwhile, the correlations of the flow resistance in the turbulent flow regions for the de - ionized water as the working fluids are obtained from experiments

    對歧管式單通道熱沉流動特性的研究結果表明，微通道內流體流態由層流向紊流轉變的臨界雷諾數提前;改變流體的進出口方向對熱沉總壓降造成的影響很小;摩擦系數的實驗值與理論值較接近;數值模擬結果能夠與實驗值較好吻合;並由實驗給出了紊流區流動阻力的實驗關聯式。此外，選用十二烷基硫酸鈉（ sodiumdodecylsulphate ， sds ）以及烷基多糖苷（ alkylpolyglycoside ， apg ）作為減阻添加劑，研究了表面活性劑添加對微通道流動特性的影響。
  15. The structure evolution o f cenozoic experienced rifting subsidence of paleogene and rifting thermal subsidence of neogere and quartenary

    新生代構造演化經歷了老第三紀裂陷沉降和新第三紀至第四紀後期裂陷熱沉降階段。
  16. Kinematic models have predominance in predicting heat flow but weakness in simulating basin geometry ; kinematic - rheological models are adept in tectonic modeling, but identical with kinematic models in heat flow prediction ; dynamic models contain latent advantages and also some obstacles in tectono - thermal modeling

    運動學模型在預測盆地熱流演化方面具有優勢，但在預測構造沉降等幾何形態方面存在一定的缺陷；運動學流變學模型的優勢在於構造演化模擬，在熱演化方面類似於運動學模型；動力學模型蘊含著潛在的巨大優勢，只是目前還存在一些阻礙因素。
  17. Bozhong area has different oil - gas accumulation characteristics from the adjace nt onshore oil fields. because of the latter thermal event and tectonic action, bo zhong area became the subsidence center and depo - center of the bohai bay basin

    其具有不同於周邊陸地油田的油氣成藏特點，晚期的熱沉降和構造活動使其成為渤海灣盆地的沉降和沉積中心，上第三系具有優于周邊陸地油田的良好的儲蓋條件，晚期的構造活動與油氣主要排烴期相匹配，為油氣向上第三系圈閉中運聚提供了良好條件。
  18. The multilayer composite including a hard component tz - 3y20a and a plastic soft component mo has been fabricated by particle sedimentation method. by choosing appropriate settling parameters and dispersed medium, the tz - 3y20a / mo multilayer composite has been obtained via alternating deposition of tz - 3y20a and mo according to the design of individual layer thickness and layer thickness " ratio

    採用顆粒沉降成型工藝，選用適當的沉降參數與分散介質，將tz - 3y20a陶瓷粉和mo金屬粉按設計的層厚和層數進行交互沉降，得到預成型體，再經1500 ? 20mpa ? 1h熱壓燒結，制備出緻密的tz - 3y20a mo疊層材料。
  19. On the basis of the analysis of the topography, geomorphology, geological structure of geothermal area and surroundings in fuzhou city, and the survey of hydrogeological condition, and the distribution of geothermal drilling, and the geothermal water exploitation, and the groundwater regime, and the scale and distribution of land subsidence, the relationship between land subsidence and geothermal water regime was discussed. the result showed that land subsidence of geothermal area in fuzhou city was mainly induced by the excessive extraction of geothermal water in the thesis

    在分析研究福州市溫泉區及周圍的地形地貌、地質構造、水文地質條件的基礎上，對地熱井分佈、流量、水位、地下熱水開採的歷史與現狀以及對地面沉降的表現、規模、分佈規律進行了深入的調查；分析了地下熱水歷年水位、水量動態變化特徵，並探討地下熱水與地面沉降的相關關系，結果表明過量開采地下熱水是導致福州市溫泉區地面沉降的主要原因。
  20. Because of the difference of density, the particle with big conductivity factor will subside in the organic phase change materials, so the orginic phase change materials were solided. the best technology was determined, which the solidation fatty alcohol was made by two steps, the solidation temperature is at 80, and the proportion of fatty alcohol : fatty acid : sodium hydroxide is 96 : 3 : 1

    由於密度差的存在，高導熱系數粒子在有機相變貯能材料中會產生沉降，為了克服這一現象，對有機相變貯能材料進行了固化研究，確定了制備固化十二醇的最佳工藝條件，即採取兩步法、固化溫度為80 、添加比例為十二醇：硬脂酸：氫氧化鈉= 96 ： 3 ： 1 （質量比） 。
分享友人
分享到 Line

分享到臉書