熱產率 的英文怎麼說

中文拼音 [rèchǎnlǜ]
熱產率 英文
rate of heat production
  • 產 : Ⅰ動詞1 （人或動物的幼體從母體中分離出來） give birth to; be delivered of; breed 2 （創造財富; 生...
  • 率 : 率名詞（比值） rate; ratio; proportion
  1. The heat production in rocks due to radioactivity is highest in the acid rocks and lowest in the ultra-basic rocks.

    巖石的放射作用熱產率以酸性巖類最高，超基性巖類最低。
  2. In the process of software development, especially in the process of software development of special domain, software reuse is becoming more and more important, the research of software reuse became the hotspot again, it " s regard as the best way to resovle the software conjuncture and improve the quality and productivity of software. software reuse is a solution for avoiding repeating working in software development

    在軟體開發的過程中，尤其是在領域軟體開發中，軟體復用正越來越重要，軟體復用研究重新成為熱點，被視為解決軟體危機、提高軟體生產率和質量的現實可行的途徑。
  3. After the bottleneck in the original ethene production plant is analyzed, the revamp design plan for srt - iii cracking furnace is proposed. the measuring results after revampment show that the thermal efficiency and ethene recovery ratio are increased compared with the design data ; the production capacity of ethene cracking furnace is enhanced, and energy consumption is reducted

    通過分析原乙烯裝置生產存在的「瓶頸」 ，提出了srt -型裂解爐改造的設計方案，並對改造後效果進行測量，熱效率和乙烯收率均比設計值有所提高，乙烯裂解爐的生產能力提高了，能耗降低了。
  4. 1. the flat plate split solar collector is some kind of the metal pipe - plate style structure, high heat effect, high hot water produced, pressured, anti - insolate, water heated in the copper pipe, reliable quality, free maintenance, can stay for 15 years

    1 .平板型太陽能集熱器是金屬管板式結構，熱效率高，產熱水量大，可承壓，耐空曬，水在銅管內加熱，質量穩定可靠，免維護， 15年壽命。
  5. The layer will finally disappear when the slope of the geotherm is too low to produce interstitial fluid at any depth.

    當地熱斜率太低，以至任何深度上都不能產生空隙流體時，低速層將最後消失。
  6. The gas generation of low mature source rocks has been simulated in the open system and close system respectively. the models of primary cracking gas ( gas from kerogen ) and secondary cracking gas ( gas from oil ) have been established. the ro value of primary cracking gas generation peak is ranged from 1. 0 % to 1. 5 %. the ro value of secondary gas generation peak is ranged from 1. 5 % to 2. 5 %

    對低成熟（部分為成熟）的烴源巖在開放和密閉體系下的生氣熱模擬實驗研究建立了熱解氣和油裂解氣的生氣模式，熱解氣的生氣高峰在ro = 1 . 0 ? 1 . 5 ，油裂解氣生氣高峰是在ro = 1 . 5 ? 2 . 5之間，從熱解氣和油裂解氣的相對含量來看熱解氣占總生氣量的21 ，油裂解氣可能佔79 ，油裂解氣產率為620m ~ 3噸
  7. In regard to the low wear resistance of the white iron shot in the practical application, based on experimental research and trial production, by alloying and proper heat treatment, the shot can be made with higher hardness, better toughness and increased service life

    摘要針對白口鐵丸在實際應用過程中不耐磨的現象，通過大量實驗研究和試生產，找到通過添加合金元素生產合金鐵丸，並通過適當熱處理等手段，使其既具有較高硬度，又有良好的韌性，使用壽命得到提高，滿足拋丸工作的需要，節約大量資金，提高了勞動生產率。
  8. Then, analytical work was carried out as follows : the ultimate analysis and physi - chemical analysis of the pyrolytic oil comprised a sketch of the fuel properties of the oil ; then, through the distillation analysis of the oil, the fraction composition of the " unrefined " oil was known. after that, a general knowledge of the aromaticity and saturation of the hydrocarbons in the oil was provided by the outcome of the ft - ir functional group analysis. also, from the analysis, the form of the polar functional groups and their distribution in different fractions of the oil were learned

    文中首先對不同熱解溫度下熱解油產率進行分析討論，然後，針對熱解油品質進行了一系列分析：通過元素組成和理化特性的分析，對熱解油作為燃料特性有了一個大致了解；通過實沸點蒸餾分析，得到熱解油作為一種未提煉油的餾分分佈，並為后續熱解油餾分的細入分析提供了前提；通過對熱解全油和各窄餾分的ft - ir官能團分析，對熱解油的芳香性、不飽和性有了整體的了解，並且清楚了熱解油中的極性官能團存在型式及其在熱解油不同餾分中的分佈。
  9. On the basis of test results, the effects of operation parameters such as material thickness, heating temperature and pressure of drying chamber on vacuum freeze drying are discussed. aiming at decreasing drying time and reducing energy consumption, these parameters are optimized and optimization results agree well with actual results

    在三因素二次正交回歸試驗的結果分析的基礎上，利用降維分析方法探討了凍干厚度、加熱板溫度和系統的真空度對乾燥時間和乾燥能耗的影響，並對混合加熱條件下單位水分能耗和凍干生產率進行了優化分析。
  10. Aimed at the automatic welding of the air - separate equipments. a computer control system for double - side automatic tig erect welding has been developed in this paper, which can keep the welding parameters of two welding torches consistent, and adopt a high - power and centralized energy fountain, and can take warm - up casually. the control system can assure a higher welding quality and a better work condition and a higher productivity than before

    為實現空分設備的焊接自動化，本文研究開發一種雙面自動tig立焊計算機控制系統，採用大功率和能量集中的熱源，克服了由於預熱而使手工焊接工人勞動環境的惡化，同時使得兩把焊槍的焊接參數保持一致，從而可得高的焊接質量，改善焊工的勞動條件，大大提高勞動生產率。
  11. The equilibrium working temperature of the gasifier and the composition of the outlet syngas ( short for synthesis gas ) at this temperature were calculated by solving the chemical equilibrium and the energy equilibrium equations. the analysis was used to study the effect of gasifying agent mixture ratio on the outlet syngas composition, the cold gas efficiency, the thermal efficiency and the exergy efficiency. the optimum o2 / coal ratio was found for a reasonable vapor / coal ratio ( the vapor / coal ratio had little effect on the efficiencies ) for various kinds of coal to maximum the thermal efficiency and the exergy efficiency

    通過化學平衡和熱量平衡方法求解氣化爐平衡工作溫度以及該溫度下的出口煤氣成分，研究了氣化爐進口氣化劑配比對出口煤氣成分、冷煤氣效率、熱效率及火用效率的影響，指出熱效率、火用效率最優情況下適應于各煤種的最優氧煤比以及合理的水蒸汽耗量，為多聯產系統的設計優化提供參考。
  12. My company product is centering on " hot high technology superconductivity " technology mainly ", hot medium of superconductivity " is a formula technology from the medium introducing to abroad, my company jointly concentrating on studies and experiment many years passes with relevant expert, the calorific efficiency, boiler having raised a boiler rise going over quickly, energy conservation is very effective on it being applied successfully having been in a boiler

    我公司產品主要是以高科技「超導熱」技術為核心， 「超導熱介質」是從國外引進的介質配方技術，我公司會同有關專家經過多年的潛心研究和實驗，把它成功的應用在了鍋爐上，提高了鍋爐的熱效率，鍋爐升溫快節能效果顯著。
  13. Micro - jets impingement cooling heat sink is used to cool the high power lda owing to the very thin hydrodynamic and thermal boundary layers in the impingement region when a jet impinges on a surface. reasonable array of jets can develop the uniform of temperature distribution on target very much

    微射流陣列冷卻熱沉，是利用射流沖擊在駐點區能產生很薄的邊界層來提高換熱效率的，合理的布置射流孔，可以極大的提高被冷卻表面溫度分佈的均勻性。
  14. A too high or too low social return appropriated level comparative to standard level ( in the vicinity of zero ) reveals a non - coordinative efficiency in innovation activities. this research shows that firms with coordinative efficiency cluster in labour input intensity and higher output elastisity manufacturing sectors

    但是，從非參數方法對生產函數法的補充以來，又掀起了生產率研究的熱潮。本文是在一些學者對生產率測度的已有基礎上進行技術創新效率內涵的擴展的，並用此擴展內涵分析了我國工業行業的技術創新效率。
  15. Based on testing and analyzing the relative results of the gear reducers ' standard or the problems emerging in chinese coalmine and the same products in other nations, proposed effect of different thermal radiation on the thermal power of gear reducer, gave effective thermal radiation measures in different case when designing and selecting the big power reducer, to ensure the thermal power of gear reducer increasing

    摘要通過對我國現行減速器行業標準及煤炭行業生產現狀與國外同類減速器的對比分析，提出了不同散熱方式對減速器熱功率的影響，給出了在設計和選用大功率減速器時，針對不同的工況所應採取的有效散熱方法，保證減速器熱功率的有效提高，最大限度地發揮和使用設計機械功率。
  16. The patented - designed steam can is of high heat efficiency and quick steam production, saving gas and energy

    專利設計的蒸汽發生器裝置，熱效率高，產出蒸汽快，省氣節能。
  17. Carbon fuel cell is much more efficient than hydrogen fuel cell and its product carbon dioxide does not need further purification for commercial use and is easy for sequestration

    碳燃料電池的熱效率遠高於氫燃料電池，產物二氧化碳不須進一步純化就可工業應用或隔離存放。
  18. Thermodynamic methods were used to optimize gasifier, shift reaction and co2 removal, and methanol synthesis processes. polygeneration is a promising system to make the best use of thermal energy with different qualities to achieve high environmental and economic benefits

    本文以熱力學方法研究了多聯產系統的熱效率和火用損失，對氣化爐、水煤氣變換和脫碳以及甲醇合成等單元作了優化分析，指出了多聯產系統在能量利用方面的合理性，對其環境效益和經濟效益的綜合評估方法進行了初步探索。
  19. The optical distribution of temperature along the furnace can be obtained with the optimized mathematical model, so as to reach optical heating - up process in the furnace, to improve productivity of the furnace and reduce consumption of resources

    運用該模型可方便地求得熱負荷沿爐長的最佳分配，從而達到加熱爐的最優工藝，提高加熱爐生產率、降低能源消耗。
  20. There is a higher heat production in the upper mantle below oceans than below continents.

    大洋下的上地幔要比大陸下的上地幔有較高的熱產率。
分享友人
分享到 Line

分享到臉書