熱疲勞試驗 的英文怎麼說

中文拼音 [rèpíláoshìyàn]
熱疲勞試驗 英文
thermal fatigue test
  • 疲 : 形容詞（疲乏; 勞累） tired; weary; exhausted
  • 勞 : Ⅰ動詞1 （勞動） work; labour 2 （煩勞） put sb to the trouble of; trouble sb with sth : 勞您費心...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 疲勞 : 1. （疲乏勞累） tired; fatigued; weary; become fagged 2. （機能或反應能力減弱） fatigue; strain 3. [物理學] fatigue
  • 試驗 : trial; experiment; test
  1. Through the experimental research, we think : the technological capacity of fiberglass asphalt macadam if weaker than asphalt macadam, however, if use elasticized capacity to solve blending technological problem. adjust the breed of fiber silk, extend its diameter, its paving capacity is still worth exploring, asphalt - rubber macadam structure lager have good deformed - become capacity and crazed - resistance capacity, small gap rate. good water - resistance capacity, good hot - stability and simple construction technology. therefore. pitch rubber spall is a good cover material which is suitable for the second class or lower whose asphalt pavement has split open because of fatigue. and is the good structural measure of preventing half - rigidity grass - roots unit shrink - rift reflecting. pave a thin layer of pitch rubber spall between asphalt - type pavement layer and half - rigidity basic level, although the cost of building is higher than paving togongbu in the middle, the construction technology, crazing - resistance and water - resistance are better than togongbu, not only could reduce greatly the reflex of half - rigidity grass - roots unit material, long then the use lifespan of pavement, but also it is possible to reduce suitably the thickness of asphalt mixture layer, though the cast of building in the early days becomes more, in the long - term opinion, it have fully important technological and economical significance

    通過試驗研究認為：玻璃纖維瀝青碎石的技術性能不如瀝青碎石好，但路用彈性性能較好，如能解決拌和工藝問題，調整纖維絲的品種，增大其直徑，其路用性能仍值得探討，瀝青橡膠碎石結構層具有變形性能和抗裂性能良好，空隙率小，防水性能好，熱穩定性較好，施工工藝簡單的特點，因此，瀝青橡膠碎石是二級及二級以下公路因疲勞而開裂的瀝青路面的良好罩面材料，也是防止半剛性基層收縮裂縫反射的良好結構措施，在瀝青類路面面層和半剛性基層之間夾鋪瀝青橡膠碎石薄層，雖然造價比夾鋪土工布高，但其施工工藝，抗裂性能和防水性能均優于土工布，不僅可以大大減少半剛性基層材料的反射裂縫，延長路面使用壽命，而且可能適當減薄瀝青混合料面層的厚度，雖然初期造價有所增加，從長遠來看，具有十分重要的技術和經濟意義。
  2. Testing of elastomeres ; testing of heat generation and service life during the fatigue test flexometer test ; bases principles

    彈性材料試驗.通過疲勞試驗測試工作壽命和釋熱
  3. Testing of elastomers ; testing of heat generation and service life during the fatigue test flexometer test ; rotary flexometer

    彈性材料試驗.通過疲勞試驗測試工作壽命和釋熱
  4. Rubber, vulcanized and thermoplastic - determination of temperature rise and resistance to fatigue in flexometer testing

    硫化和熱塑橡膠.撓度計試驗中溫度上升和抗疲勞性的測定
  5. Testing of elastomers ; testing of heat generation and service life during the fatigue test flexometer test ; compression - flexometer

    彈性材料試驗.通過疲勞試驗測試工作壽命和釋熱
  6. The expressions of interaction fatigue - creep life and of thermal shock damage evaluated by modulus were obtained by the experimental analysis

    通過試驗分析，初步得到疲勞蠕變壽命表達式和模量表徵的熱震損傷表達式。
  7. Thermal fatigue testing method for hot die steel

    熱作模具鋼熱疲勞試驗方法
  8. Thermoplastics valves - fatigue strength - test method

    熱塑性塑料閥門.疲勞強度.試驗方法
  9. En 28659 thermoplastics valves. fatigue strength. test method

    熱塑料制閥門.疲勞強度.試驗方法
  10. The characteristics and shortcomings of high temperature sliding wear testing machine for roll materials in china and a broad were analyzed in this paper

    摘要文章分析了國內外軋輥材料高溫摩擦磨損試驗機的特點及其存在的不足，在此基礎上，研製開發了一臺材料高溫滑動磨損與熱接觸疲勞試驗機，並進行了初步的實驗。
  11. Method of thermal fatigue testing for metallic materials

    金屬材料的熱疲勞試驗方法
  12. A testing study on thermal fatigue property of building up casting pipe model

    堆焊鑄管模熱疲勞性能試驗研究
  13. Thermal fatigue testing machine

    熱疲勞試驗機
  14. 7 the investigation of the thermoeconomic performance of an existing facility used for thermal fatigue experiments of aircraft canopy reveals the possibility and practicability of taking measures to improve it significantly. a piping system with alternative variation of flow temperature exists in this facility

    對一現行的飛機座艙蓋熱疲勞試驗系統? ?即流體溫度升降交替變化的管路系統，進行了熱經濟行為的研究，揭示出它具有潛在與可行的重大改進方向和途徑。
  15. Standard test methods for rubber property - heat generation and flexing fatigue in compression

    橡膠性能標準試驗方法.壓縮中熱的產生和彎曲疲勞試驗
  16. Finally, theoretical results and the fatigue test data of equal amplitude are combined, which is introduced the conception of " range of hotspot stress ", and the method of fatigue design for grid structure with bolt - sphere joints is obtained in this paper

    最後，將本文的理論研究成果與常幅疲勞試驗數據相結合，並引入「熱點應力幅」的概念，建立了螺栓球節點網架結構的疲勞驗算方法。
  17. The above research results of theory and test make a contribution to the study on the thermal damage of the piston

    上述試驗和理論研究結果將為活塞熱損傷的研究打下良好的基礎，同時也為探索活塞熱疲勞壽命預測提供了理論和試驗手段。
  18. Experiment research of thermofatigue performance about alloy made form ti - 22al - 27nb sinter

    粉末燒結合金熱疲勞性能的試驗研究
  19. Standard practice for strain controlled thermomechanical fatigue testing

    應變控制熱力疲勞試驗的標準規程
  20. 4. the first thermal shock stand in china has been developed. it has creation on simulation thermal state of the piston and control methods

    在該試驗臺上獲得了6150柴油發動機活塞熱沖擊的試驗數據，為活塞熱沖擊和熱疲勞研究提供了有力的手段。
分享友人
分享到 Line

分享到臉書