熱膜 的英文怎麼說

中文拼音 [rèmó]
熱膜 英文
hotting mask
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  1. The simulation of absorptance and response characteristics for pyroelectric thin films infrared sensors

    薄膜熱釋電紅外探測器吸收和響應性能的模擬研究
  2. They represent 38. 1 % of the total species that have been identified. we performed preliminary study on those mycofiora of agarics under those forests. based on our study, we identified one tropical element family : entolomataceae, two north temperate element families : hygrophoraceae and cortinariaceae ; the other 11 families all belong to cosmopolitan element

    根據論文所研究的傘菌類群，從科的地理分佈看，熱帶亞熱帶成分只有粉褶菌科entolomataceae一科；北溫帶成分的科有兩個，即蠟傘科hygrophoraceae和絲膜菌科；其餘的科均為世界廣布的科，占總科數的78 . 6 。
  3. A heat treatment to composite membrane, preferred at a 70 hot air bath for 20 minutes can improve the salt resistance of the composite membrane

    對復合膜進行適當的熱處理可以進一步改善復合膜的脫鹽性能，以70熱空氣浴， 20min為宜。
  4. The company has the professional qualifications of the construction, rich experience and expertise in project construction team, in shenzhen and neighboring had completed a number of major projects, such as : state - building in shenzhen, the shenzhen productivity technology park building, dongguan step by step, the china everbright bank, shenzhen city communist party, china enrolling, urban forests, turtle mountain lodge, alpine garden, quieting habitat ho side, garden city, wonderlang, the bay holds garden, studded day at ocean shores, etc. glass insulation, energy, explosion - proof security to indulge their works

    本公司具有專業的施工資歷、豐富的工程經驗及專業的施工隊伍，在深圳及周邊曾完成多項大型工程，如：深圳國通大廈、深圳科技園生產力大廈、東莞步步高、光大銀行大廈、深圳市委黨校、中國移動營業廳、城市山林、龜山別墅、高山花園、豪方悠然居、花園城、四季花城、灣畔花園、漾日灣畔等等玻璃隔熱、節能、安全防爆貼膜工程。
  5. At 100 to 150, both the toughness and the molecular weight decreased during the process of amination, but the transformation ratio of the amination reaction increased rapidly ; above 150, both the toughness and the molecular weight increased and transformation ratio of the amination slightly increased, and reached completely amination

    亞胺化過程中，當溫度從100升至150時，不同熱處理階段薄膜的韌性和分子量均下降，亞胺化反應轉化率上升較快； 150后，其韌性和分子量均升高，亞胺化反應轉化率上升趨于緩慢，最終達到完全亞胺化。
  6. As one of the most important applications, cmr bolometer is fabricated using the lacamno3 films, which has a metal - insulator transition temperature at 300k. the archetypal bolometer is fabricated after the film is photolithographed, evaporated au electrodes and fixed

    以製作室溫超巨磁電阻測輻射熱儀為目標，將t _ （ mt ） 300k ， tcr 5的薄膜進行光刻、電極製作、封裝等處理製作測輻射熱儀原型器件。
  7. The obtained polysilane - polyacrylate gradient films showed no macro - interface with the silicone content reducing gradually from the top surface to the bottom one. dma thermograms indicated that polysilane - polyacrylate gradient films contained two glass temperatures with their bands drifting from and their range extending much from each component. the good properties of waterproof, calorifics, and ultraviolet - absorption were also determined by dsc, uv and water contact angle measurements

    結果表明：有機硅聚合物-聚丙烯酸酯梯度膜有一個較寬的玻璃化轉變溫區，玻璃化轉變范圍相對組分材料的玻璃化轉變范圍發生了擴展：有機硅聚合物-聚甲基丙烯酸酯梯度膜具有較好的熱學性能；硅含量的提高有利於改善膜層的憎水性能和紫外吸收性能。
  8. Best concentration of ions is 1. 5mol / l and dispersant pvp monomer 0. 8mol / l. spin - coating speed, which affected the quality of limn2o4 film greatly, was also studied. it demonstrated that smooth limn2o4 film without cracks could formed under 2000 rotates / min with the solution cion = 1. 5mol / l, cpvp = 0. 8mol / l, what ’ s more, fewest spin - coating times were needed at that speed

    實驗結果表明:採用離子總濃度溶液為1 . 5mol / l ，聚乙烯吡咯烷酮單元濃度為0 . 8mol / l的溶液旋轉塗覆時，轉速在2000轉/分鐘時最佳，所得到的濕limn204薄膜平整光滑均勻，加熱后無龜裂現象。
  9. The results indicate the stress of copper interconnects generates in the metallization and the thermal stress caused by thermal mismatch during the damascene process is the main stress. the thermal stress distribution in copper interconnects has been simulated by the finite element analysis software with the different trench structures

    對測量結果的分析得出金屬薄膜的淀積是造成銅互連線中應力的主要原因，熱應力在銅互連線應力中占較大比例，熱處理后銅互連線中應力減小。
  10. Abstract : through study on energy dissipation of goupitang project on the wu - jiang river, the velocity field in the water cushion pool downstream ski - jump or drop was measured by hot - film anemometers on a fine model with scale 1 380

    文摘:結合烏江構皮灘水利樞紐工程消能問題研究，用熱膜流速儀在比尺為1 380的精細模型上量測了拱壩挑跌流在水墊塘內的流速場，並由試驗成果分析了淹沒射流在水墊塘內的消能過程，計算了消能率。
  11. The results indicate that the qualitative behavior in this process is similar to that observed in condensation of vapor at or above atmosphere pressure, the coefficient of heat transfer for condensation in tube, the coefficient of heat transfer in total increase with the increasing of heat flux density and vapor pressure. however, heat flux density and vapor pressure have a more significant effect on them

    發現水平管內低壓蒸汽冷凝過程與常壓條件下蒸汽冷凝過程相同，管內冷凝傳熱膜系數、總傳熱系數隨熱流密度、蒸汽壓力的增大而增大，但熱流密度、蒸汽壓力對低壓蒸汽冷凝有著更為顯著的影響，管外冷卻水流量對其影響並不明顯。
  12. Hot - film anemometer

    熱膜流速計
  13. When in experiment, the air was heated by the film heater installed on the above and below surface of channel, adopting various air velocity of flow, test import ' s and export ' s temperature, wall temperature, fluid flux and the drop of pressure, and the other parameter. adopting nu and nu0 to analyze the baffle ' s situation of heat transfer and fluid flow, which baffle was holed various diameters

    實驗時，通過矩形通道上下壁面敷設的電加熱膜加熱通道空氣，改變空氣流速，測試不同工況時的進出口溫度、壁面溫度、流體流量和壓力損失等參數，並採用無量綱努謝爾特準則數nu 、 nu _ 0等分析了設置不同開孔折流板的換熱與流動情況。
  14. Have this selections move forward handicraft producing heat insulation film color stability, through rate selectivity taking form nimbly, the sunlight having the best controls a function

    具有這種選進工藝生產形成的隔熱膜色彩穩定、透過率選擇性靈活，具有最佳的陽光控制性能。
  15. “ ouslan ” in the use heat insulation membrane the metal thermal insulation layer as well as the special adhesive, enable its to resist the sudden exterior attack and the accident for you hit, cause the automobile glass stave possibility to fall to lowly, maximum limit avoids the accident to crew member ' s injury, guarantees your journey safety

    利用隔熱膜中金屬隔熱層以及特殊的黏合劑，使其能為您抵禦突然的外部襲擊及意外撞擊，使汽車玻璃破碎可能性降到最低，最大限度地避免意外事故對乘員的傷害，確保您的旅途安全。
  16. Good agreement is obtained between present cfd predictions and published experimental data of solari and bell [ 77 ]. the maximum standard error of the result is 18. 9 %. the results can reflect the phenomena of different circulation area along the height of liquid layer and above the inlet baffle

    在1 . 2米塔徑的冷模篩板塔上，提出使用熱膜流速儀通過在平面內旋轉探針測量三維流速的新方法，與計算結果的對比有力地說明了該方法是正確的。
  17. Abstract : this paper introduce the basic theory of the hot - wire / film anemometer and the method to determine the flow velocity of calibration nozzle system. this calibration nozzle system is designed for the calibration of hot - wire / film anemometer. a method to determine the uncertainty of this system is fully analyzed using uncertainty thoery in this paper

    文摘:介紹了熱線熱膜流速儀的基本原理和用於熱線熱膜流速儀校準用的校準噴嘴系統的氣體速度確定方法，分析和推導了用不確定度理論全面分析系統不確定度的方法。
  18. The interactions between heat flux density, vapor pressure, vapor velocity and the coefficient of heat transfer for condensation in tube, the coefficient of heat transfer in total are investigated. the relationships between heat flux density and the total difference in temperature, the difference of temperature, pressure drop of vapor from the entrance of the tube to the exit are investigated as well

    考察了冷卻水流量、溫度恆定條件下熱流密度、蒸汽壓力、蒸汽流速對冷凝傳熱膜系數及總傳熱系數的影響關系，同時考察了總傳熱溫差、蒸汽進出口溫差及壓差隨熱流密度變化的關系。
  19. It has given the solutions how to troubleshoot the problem of amlcd at low - temperature environment, including thermal power theoretical calculation of ito heater - film, the technology of built - in ito soft heater - film in lcd, and heat control circuits at low temperature, etc. this paper presents a way to solve the problems, namely, lcd response slowly, and even not work in low temperature environment. in addition, this paper also researches into the features of vibration, shock and emc, and gives the means of how to solve them by reinforcing rigidity, shielding and filter etc

    本文在深入研究液晶顯示器溫度、振動、沖擊、電磁兼容、潮濕等環境特性的基礎上，解決了液晶屏在惡劣環境下工作的具體問題，提出了有源液晶顯示器的低溫解決措施，包括ito加熱膜加熱功率的理論計算、液晶屏內置ito柔性加熱膜工藝、低溫加熱控制電路等，較好地解決了模塊化液晶顯示器在低溫環境下出現的響應速度慢，甚至不能使用的問題。
  20. Analytical relationships are obtained for calculation of the coefficient of heat transfer for condensation in tube, the relative difference between the experimental value and the calculated value is smaller than + 15 %

    關聯出了相應的水平管內冷凝傳熱膜系數的計算式，計算值與實測值的偏差在15以內。
分享友人
分享到 Line

分享到臉書