熱膨脹計 的英文怎麼說

中文拼音 [rèpéngzhàngjì]
熱膨脹計 英文
thermal dilatometer
  • 膨 : 動詞（物體的長度或體積增加） expand; swell
  • 脹 : 動詞1. （膨脹） expand; dilate; inflate 2. （脹大） swell; distend; bloat
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 膨脹 : expand; swell; dilate; inflate; puff; bulge; inflation; expansion; dilatation; buckling; swelling...
  1. Treating the anharmonic terms of potential energy as perturbations, and employing the formulas for atomic displacements and hamiltonian in phonon occupation number representation, the formulas for thermal expansion coefficients of crystal nano - wires are derived and the numerical calculations are carried out in this paper

    摘要將原子間相互作用勢的非諧項作為微擾，運用聲子數表象中的晶格原子振動位移和晶格振動哈密頓公式，推導了納米晶體線的熱膨脹系數公式，並進行了數值計算。
  2. Test methods for measurement of thermal expansion of rock using a dilatometer

    用膨脹計測量巖石的熱膨脹的試驗方法
  3. Standard test method for coefficient of linear thermal expansion of plastics between - 30 c and 30 c with a vitreous silica dilatometer

    用玻璃硅膨脹計測定塑料在- 30和30之間的線性熱膨脹的標準試驗方法
  4. Specimen preparation for determination of linear thermal expansion of vitreous glass enamels and glass enamel frits by the dilatometer method

    用膨脹計法測定透明玻璃釉瓷及玻璃色料的線性熱膨脹的試驗方法
  5. And due to the heat expansile coefficient of the stainless steel rather high, the connecting force between the stainless steel pipe and the pipe coupling in the room temperature is much less than that between the titanium alloy pipe and the pipe coupling. the results accord with the tensile experiments well. finally, the dependence of dimensions of the coupling on the strength of the connector system is analyzed

    模型計算還表明，被接管材料和管接頭材料之間的熱膨脹系數的差異會造成管接頭系統的室溫強度低於高溫強度；由於不銹鋼的熱膨脹系數較大，使得室溫下1不銹鋼管與n立tinb形狀記憶合金管接頭間的抱緊力遠小於鈦合金管與nitinb形狀記憶合金管接頭間的抱緊力，成功地解釋了拉脫實驗中的結果。
  6. It is shown that paraffin can be uniformly absorbed into the pore network of expanded graphite, that expanded graphite remains its vermiform structure in pcms, that the phase - change temperatures of composite pcms are similar to that of paraffin, and that the latent heat of composite pcms is are based on the mass fraction of paraffin in the composite materials

    結果表明：膨脹石墨吸附石蠟后仍然保持了原來疏鬆多孔的蠕蟲狀形態，石蠟被膨脹石墨微孔所吸附；復合相變儲熱材料的相變溫度與石蠟相似，其相變潛熱與基於復合材料中石蠟含量的潛熱計算值相當。
  7. The software takes visual basic6. 0 as work flat, adopting activex technique, transfers autocad2000 painting orders from the exterior of vb through programme method. it is a re - exploitation software to design bellows expansion joints. the software adopts ejma, the current international widespread trade standard, as mathematics model

    波紋膨脹節是安裝在金屬管線上起熱補償、柔性連接等作用的管道連接構件，本文以visualbasic6 . 0作為操作平臺，採用activex技術，通過編程手段從vb外部調用autocad2000軟體中的繪圖命令，二次開發軟體，以目前國際上行業中普遍採用的ejma標準作為數學模型，編輯波紋膨脹節設計軟體。
  8. The flow diagram of a lpg bottle paint - drying heating system using heat carrier as heat - medium, which has similar properties as other heat - carrier heating systems, has been improved, which has good effect in avoiding oil - spraying, shortening dehydration time and power - fail protecting etc. after making a series of analysis, calculational methods of expansion tank dimension have been deduced, which takes the moisture boiling - off of heat carrier into account and accords with real conditions

    對與其它熱載體加熱系統具有共性的鋼瓶熱載體加熱系統的流程圖進行了改進和完善，在防止噴油、縮短脫水時間和停電保護等方面取得了良好效果。通過分析，整理出了熱載體加熱系統膨脹器容積的計算方法，該方法考慮了熱載體所含水分汽化而帶來的影響，比原有的計算方法更加符合實際。
  9. The measuring element of the bimetal thermometer is a quick reacting bimetal coil. it is manufactured from two cold - welded metal strips with different thermal expansion coefficients and rotates in proportion to temperature

    雙金屬溫度計的測量元件是一個快速反應雙金屬線圈，由兩根不同熱膨脹系數的金屬條冷焊在一起，根據溫度比例旋轉。
  10. The electrical conducting properties and thermal expansion properties of la1 - xcaxcrc > 3 ceramics were investigated using a dc four - terminal method and a push - rod type thermal dilatometer method, respectively

    採用直流四探針法和石英膨脹計法研究了gnp法制備la _ （ 1 - x ） ca _ xcro _ 3陶瓷的電子導電性能和熱膨脹性能。
  11. In the nibco design stop - checks, you will note that the disc is mounted to permit the disc to settle into the seat area for positive sealing in case there is any misalignment due to assembly or uneven heat expansion

    從美國尼伯科的截止止回閥結構設計中，人們可能會注意到，萬一出現由於組裝問題或不穩定的熱膨脹導致的中心線錯位，所安裝的閥瓣能夠適應閥座區域的要求主動調整密封。
  12. Through the research of crosslinking of matrix resin, heating treatment of composite and mixing of different polymer, we draw some conclusions : 1 、 percolation theory can explain the phenomenon of the jump of resistance when the content of cb reach a critical volume ; 2 、 based on ohm conduct theory, abounded to the percolation the wbibull statistical theory and other theory, an adapted theory was obtained to explain the jump of resistance and the other phenomenon ; 3 、 the ntc phenomenon was eliminated by crosslinking the matrix of conductive composite, at the same time the stability of composite was improved

    通過對基體樹脂的交聯、復合材料的熱處理、聚合物共混物的研究得出了如下的結論： 1 、滲濾理論能夠很好的解釋導電粒子含量達到某一值時電導率劇增的問題； 2 、在歐姆導電模型的基礎上，綜合應用了weibull統計理論模型，結合原來的體積膨脹等理論，成功的解釋了ptc復合材料在基體材料熔點附近的跳變問題、 ntc現象以及熱循環穩定性等問題； 3 、有機ptc導電復合材料經硅烷交聯以後能夠消除ntc現象，改善了導電復合材料的穩定性能。
  13. Based on the principle of michelson interference a new integrative experiment apparatus to measure linear expansion coefficient and yang ' s modulus of metals is designed and manufactured primarily

    摘要在邁克耳孫干涉原理的兩條干涉光路中，分別設置可以精確測量金屬絲的拉伸長度和金屬棒熱膨脹伸長量的裝置，從而設計出一種可以分別測量金屬楊氏模量和線脹系數的新型綜合實驗儀器。
  14. But because it is not spreading popularize and new type pipe in market emerge in an endless steam, the selling market is not standard, many pipe material has not standard temporary. how to choose suitable pipe materials that it is not only the ordinary use do n ' t know but also relevant design and construction technician can not know comprehension

    而且廠家生產與銷售市場又不夠規范，很多管材暫無設計規程與施工驗收規范。要想選用適用的管材，正確進行設計和施工，需要研究新型管材的耐熱、耐壓、膨脹和阻力損失等物理性能。
  15. The thermal stress of ceramic regenerator resulting from its temperature difference and restricted extension and contraction has been calculated and analyzed, the result provides a theoretical basis for design and operation of high temperature air combustion system

    對于由溫度分佈不均勻，陶瓷蓄熱體膨脹或收縮受限制而產生的熱應力進行了計算和分析，其結果為蓄熱式高風溫燃燒系統的設計及運行參數的選擇提供了理論依據。
  16. The group ' s calculated sea - level change is due mainly to thermal expansion of ocean water, with little change in ice - sheet volume

    他們的估計主要是根據海水的熱膨脹來估算海平面的改變，而非根據冰原體積的改變。
  17. As composite material are widely used in navigation and physical education equipments for high comparing intensity and module, even it has the approxi - mate zero expanding coefficient, as the same time, configuration of composite has been aroused attention by scientific researchers, the goal of them is to find an integrated structure with high efficiency and intelligent and many function all along. grid structure is the right structure with the high efficiency, the researchers overseas have been studying the structure for many years, which manifests it has many excellent nature ; existing research indicate it has higher stiffness and intensity. the form can be detected in health easily for its open shape

    復合材料具有高的比強度和比模量，同時又具有近於零的熱膨脹系數和良好的尺寸穩定性等優良性能，已經廣泛應用於航天航空事業和體育器材生產工業，與此同時，尋求一種高效的、低成本的、並將智能化和功能化集於一體的結構形式，一直是航空航天追求的目標，具有點陣結構的復合材料格柵結構正是這種高效的結構形式，表現出多項優良性能;國外對其進行了大規模的理論分析和一些數值模擬研究，已有的研究表明該結構具有良好的可設計與自動化生產性能而無材料之間匹配問題，開放式的結構形式為結構的健康檢測提供了便利，具有廣闊的應用前景。
  18. 5. schapery model can be used to calculate the cte of composite when temperature is lower ( 50 - 100c ) and kerner model can be used when temperature is higher ( 300 - 450c ). the cte of composite will increased more quickly than that by three models when temperature is between ( 100 - 300c )

    復合材料的熱膨脹系數在溫度較低（ 50 100 ）時可用schapery模型計算，在高溫（ 300 450 ）時可用kerner模型計算，在100 300之間則隨溫度升高增加的很快，且與所有模型分析結果不一致。
  19. The thermal expansion of liquids is the principle of operation here

    液體溫度計的原理是液體的熱膨脹。
  20. In this paper i have done several worksuch as : coefficient of thermal expansion of frp sheet is larger different thanthat of the concrete. the interface of frp sheet reinforced concrete will producetemperature stress under the circumstance of temperature difference. i n order todesign the reinforced structure and evaluate safely, it is very significant toanalyse the interface temperature stress and to find the changing law of interfacetemperature stress

    本文重點分析了frp片材補強混凝土梁界面溫度應力分佈理論，解決補強方面的一些工程問題，主要完成了以下幾個方面的研究工作:首先， frp片材的熱膨脹系數與混凝土的熱膨脹系數相差較大，在環境溫差作用下， frp片材補強混凝土界面將產生界面溫度應力，正確分析界面溫度應力和界面應力變化規律，對補強結構設計和安全評價具有重要的意義。
分享友人
分享到 Line

分享到臉書