熱變形 的英文怎麼說

中文拼音 [rèbiànxíng]
熱變形 英文
deformation under heat
  1. A lot of engineering applications are carried out using our proposed method in this paper, such as thermal deformation measurement of a car lamp, analysis of the super low frequency harmonic vibration of a piezoelectric ceramic, dynamic mechanical behavior analysis of the ballistite material and so on

    在前面所提出的理論基礎之上，本文對該方法在實際工程中的應用做出了大量的工作。本文利用時間序列法實現了汽車前燈配光鏡的熱變形檢測、壓電陶瓷片的超低頻振動分析以及火箭固體燃料的動態力學特性研究。
  2. Two methods of improving precision for thermal defamation experiments

    提高熱變形實驗精度的兩種方法
  3. It compute the parameter of deflexion caused by thermal distortion in orbit, deduce the general expression for spreading beam after thermal distortion of reflector and the center deflexion of facula received in ccd. with the method of fixing etc, it put forward the restrain measures adopted accordingly

    計算了在軌運行條件下反射鏡面熱變形引起的表面法向偏轉參數，推導了鏡面變形后出射光線的通用表達式以及鏡面變形前後在ccd探測器上的接收光斑中心偏轉量的計算表達式。
  4. Research of the non - involution characteristic of thermal deformation gear

    標準漸開線齒輪熱變形時的非漸開特性研究
  5. Part 2 analyses beam landing shifts made by thermal deformations of a shadow mask and vibration of a new type of shadow mask - aperture grille. an automatic measurement system for cpt decolorization and a vibration measurement system for aperture grille are established. part 3 analyses the difference of perception and discrimination to color between the human eyes and ccd system, and develops a new method based on ccd technology to evaluate the screen white - balance

    主要內容分為三部分： （ 1 ）分析著屏電子束分佈與電子槍、偏轉系統及蔭罩之間的關系，研製自動測試裝置，為設計和改進相關結構提供依據； （ 2 ）分析蔭罩熱變形和振動對顯示屏色純度影響，建立了色純漂移自動測試裝置和張緊式蔭罩振動測試系統； （ 3 ）分析了人眼與ccd對彩色刺激的不同響應，建立了基於ccd的顯示器全屏色純均勻性測試方法。
  6. The effect on display characteristic made by thermal deformations of the shadow mask is comprehensively investigated. by using the electron beam distribution automatic measurement system with a micro - deflective coil, a concave spot in luminance distribution can be get. it changes its position when the shadow mask changes its form

    本文系統全面地分析了傳統蔭罩的各類熱變形對顯示屏特性的影響，利用本文研製的電子束亮度分佈自動測試系統，附加一個微偏轉磁場，使相鄰兩電子束打在同一顏色的熒光粉條，並形成一個亮度凹點，當蔭罩變形時，凹點位置作相應的位移，以此原理跟蹤測量凹點位移量，即可得到色純漂移動態變化曲線。
  7. Care must be exercised to prevent thermal strains from introducing spurious outputs.

    必須注意防止熱變形所引起的附加輸出。
  8. Moreover, the addition of wollastonite rose the thermal distortion temperature of the sls part, improved the dimensional accuracy of the sls part, and lowered the material cost greatly

    同樣，加入硅灰石后，可使燒結件的熱變形溫度大幅度提高，同時提高了燒結件的尺寸精度，大大降低了材料成本。
  9. The operation stability of routine electronic protector has been improved in essence, especially for the improvement of our electronic protector. more and more users begin to use electronic heat relay to replace routine double sheet metal heat relay which drove the machine through radiation and diatortion

    特別是近年來我國電子式電動機保護器已有了一定的發展，越來越多的用戶開始嘗試選用電子式熱保護器來取代傳統的以發熱、變形帶動機構動作為原理的雙金屬片式熱繼電器。
  10. It is the first time to use the conventional espi system ( neither phase shifting nor carrier is used ) to continuously analyze the super low frequency vibration with high quantitative in the world

    在火箭固體燃料動態力學特性研究中，時間序列法成功的給出了固體燃料的蠕變曲線和蠕變速率曲線，並且給出了其熱變形和蠕變不同時刻的全場位移分佈。
  11. Numerical simulation of austenite grain size during hot deformation of q345 steel

    345鋼熱變形奧氏體晶粒尺寸的數值模擬
  12. The resin produced by the flame - retardant products with high strength and mechanical properties, thermal deformation temperature, curing speed, and good soak

    該樹脂所生產製品具有很高的阻燃性能和機械強度，熱變形溫度高，固化速度快，浸透性好。
  13. Xt - p1007 unsaturated polyester resin is reactive flame retardant resin, heat distortion temperature, curing speed, good soak and toughness, both major requirements for flame - retardant and high mechanical strength requirements pultruded products

    P1007不飽和聚酯樹脂是反應型阻燃樹脂，熱變形溫度高，固化速度快，優良的浸透性和韌性，主要應用於既要求阻燃又要求機械強度高的拉擠產品。
  14. As the content of vermiculite minerals was about 3 %, the impact strength ( nick ), the flexural strength and the heat distortion temperature ( hdt ) of the nanocomposites all were the lowest and decreased 21 %, 28 %, 3c, respectively. compared with those of the polybenzoxazine ( bisphenol a type ), its thermal expanded coefficient ( tec ) was 3. 4 % bigger than that of the polybenzoxazine ( bisphenol a type )

    雙酚a型ben蛭石納米復合材料的力學性能和熱性能表現出明顯的結構特徵，普遍地低於純樹脂的性能數值，而優于雙酚a型ben金雲母復合約zi和zs 「熱變形溫度dt ）低約3 ，線膨脹系數高約3
  15. In this paper, the framework error of the system is analyzed quantificationally, and other errors as mechanical distortion error, thermal distortion error, detect error and dynamic error are analyzed qualitatively

    本文對非正交坐標系機械繫統的機構誤差做了定量分析，另外對其它的誤差因素也做了定性的探討，如力變形誤差、熱變形誤差、探測誤差和動態誤差等。
  16. Electron type omnipotent testing machine cmt5504, hot to link card appearance xwb - 300a, pulling force testing machine lj1000, melting body flow speed appearance xrz400, simple to prop up roof beam strike testing machine xjj - 50j, etc

    、電子式萬能試驗機cmt5504 、熱變形維卡儀xwb - 300a 、拉力試驗機lj1000 、熔體流動速率儀xrz400 、簡支梁沖擊試驗機xjj - 50j等
  17. Servo control computer system / microcomputer universal testing machines, ozone tester, compression flexometer, computer hdt / vicat tester, digital impact tester, melt flow indexer, moving die rheometer, mooney viscometer, lamination of pvc plastic press tester

    伺服控制電腦系統微電腦式拉力試驗機，耐臭氧機，橡膠壓縮生熱試驗機，塑料用維卡熱變形，數位沖擊試驗機，塑膠熔體流動速率機，無轉子密閉膜腔硫化儀，門尼黏度試驗機等等。
  18. Test results show that that the breakcown voltage and heat distortion temperature the encapsulating materials of epoxy resin with hgh are famously improved, but the the addition of hgh, the viscosities of the epoxy resin - hgh system is higher compared with that of the others and the encapsulating process is effected. nano - sio2 improves the mechanical properties of encapsulating materials of epoxy resin, impact strength reaches 27. 64kj / m2 from 13. 95 kj / m2, flexural strength reaches 136. 68mpa from64. 95 mpa. by addition of the montmorillonite, glass transition temperature and heat distortion temperature of the encapsulating materials are 13. 2 and 16 higher than that of epoxy re

    結果表明，活性硅微粉對環氧灌封材料的熱變形溫度和電學性能提高較為顯著，尤其在浸水后，電學性能降低幅度很小，西北工業大學碩士學位論文但活性硅微粉用量較大，材料的工藝性能明顯降低;納米5102對環氧灌封材料具有顯著的增強和增韌作用，沖擊強度、彎曲強度由原來的13 . 95kj / mz和64 . 95mpa分別提高到27 . 64kjzm2和136 . 68mpa 。
  19. This paper studied two - dimension model of rotor and cylinder and builded the finite element model. generally take the rotor and the cylinder as control objects ， definite their boundary conditions ， solute their temperature fields ， and then analyst their bear expansions and distortions as well as thermal stress distribute ， to control the courses ， and keep the unit the most optimum operating condition. and put the theories into practice developed by c + + program, used as the important part of the online monitoring and management system of life of the steam turbine

    本文對汽輪機轉子和汽缸的二維模型的進行分析，建立有限元模型；將汽輪機轉子和汽缸作為控制對象，確定其邊界條件，求解其溫度場，分析其熱膨脹、熱變形以及熱應力分佈；採用c + +語言編制汽輪機高壓缸、中壓缸以及缸體的溫度場實時在線監測程序，作為汽輪機壽命在線監測與管理系統的核心部分，用以指導汽輪機的啟停及運行過程，使機組可以安全的、經濟的運行。
  20. That is, by the calculation of the anti - thermal deformation quality factor and synthetic quality factor of some typical primary mirror materials, the primary mirror material is selected scientifically and rationally. by the finite element method and the conception of structure rigidity quality factor, researching the relation between the light - weighted cell shape, the mirror thickness and mirror structural rigidity quality. by the force - thermal coupling analysis of the primary mirror assembly, the relations between the thickness, height of the flexible support reed and primary mirror synthesis surface figure error ( p - v ) have been researched

    即，通過對常用主鏡材料的抗熱變形品質因數和綜合品質因數的定量分析，科學地完成了主鏡的選材；應用有限元分析方法，藉助于結構剛性品質因數的概念，研究了主鏡輕量化孔的形狀和主鏡厚度對鏡結構剛性品質的影響；通過對主鏡組件的力熱耦合分析，研究了主鏡柔性支撐簧片厚度與高度對主鏡面形的影響。
分享友人
分享到 Line

分享到臉書