熱釋放率 的英文怎麼說

中文拼音 [rèshìfànglǜ]
熱釋放率 英文
rate of heat release
  • 釋 : Ⅰ動詞1 （解釋） explain; elucidate 2 （消除） clear up; dispel 3 （放開; 放下） let go; be reliev...
  • 放 : releaseset freelet go
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 釋放 : 1 （恢復被拘押者的人身自由） release; deliver; clearing; set free 2 [物理學] relief; rid; detachm...
  1. Because, this is of chinese herbal medicine outer the organization is stimulated suddenly by high fever, instantly constrictive, caky even, its protein is formed on cellular wall cannot go against the metamorphic layer that turn, prevent moisture development, organize interior to composition dissolves hard and be released, such, the decoct of medicaments active ingredient goes out rate reduce greatly, affect curative effect badly

    這是因為中草藥的外層組織忽然受到高熱刺激，立即緊縮，甚至凝固，其蛋白質便在細胞壁上形成不可逆轉的變性層，防止水分深入，組織內部成分難以溶解並釋放出來，這樣，藥物有效成分的煎出率大大降低，嚴重影響療效。
  2. The acquistion system is mainly used to measure the most important parameters ： the heat release rate and the temperature

    檢測系統主要用於測試火災中最為重要的兩個特性參數：熱量釋放率和溫度。
  3. It is necessary to include as a heat source in the thermodynamic energy equation at erm which represems the timerate of release of the latent heat of condensation of water vapor

    譯為:有必要把代表水汽凝結潛熱釋放的隨時間變化率的一項作為熱源項包括在熱力學能量方程中。
  4. Standard test method for heat and visible smoke release rates for materials and products using an oxygen consumption calorimeter

    利用氧消耗熱量儀測定材料和產品的熱和可見煙霧釋放速率的標準試驗方法
  5. Fire development processes of different combustion models were given and some corresponding parameters were also suggested

    通過給出熱釋放速率、燃燒持續時間和油池火蔓延速度等關鍵參數的計算方法，詳細描述了其發展過程。
  6. In this paper, the mechanism and practical effect of existing coordinated control schemes are analyzed in detail, the advantage and drawback of the different coordinated control methods in practice are indicated clearly. this paper describes a fact that it is difficult to obtain rapid load response and stable main parameters at the same time by using the recent methods, underlines that heat release is the vital parameter that should be carefully controlled

    本篇在吸取了目前各種協調控制系統的優點的基礎上，提出了改進后的協調控制方案，主旨為以控制鍋爐的熱量釋放信號為核心，採用具有內在穩定特性的控制方案，充分加快機組的負荷響應速度，在機組所帶負荷已經接近當時的極限，及時限制輸出功率的增長，達到穩定機組的目的。
  7. In view of the poor thermal stability of polyoxymethylene ( pom ) induced by the residual catalyst and unstable end groups formed in the synthesis of pom. the pom was treated by amine, and the effects of the variety of amine compounds, treatment technology and water content on the thermal stability of pom were investigated ; the effect of triethanolamine on the thermal stability of pom was further studied by means of isothermal mass loss, isothermal mass loss rate, and formaldehyde emission amount

    摘要針對聚甲醛由於合成中殘留催化劑及不穩定端基導致其熱穩定較差的問題，採用胺對聚甲醛進行處理，並考察了胺種類、胺處理工藝及水用量對聚甲醛熱穩定性能影響；採用等溫熱質量損失率、等溫熱質量損失速率、甲醛釋放量分析等方法對三乙醇胺對pom的熱穩定作用進行了進一步研究。
  8. Heat release rate of fires occurred in iso 9705 standard room

    9705標準房間熱釋放率實驗研究
  9. Test method for heat and visible smoke release rates for materials and products

    材料和產品的熱和可見煙霧釋放率的試驗方法
  10. Heat release rates for materials and products using an oxygen consumption calorimeter

    用耗氧熱量計測定材料和產品的熱釋放率
  11. Standard test method for heat and visible smoke release rates for materials and products

    材料和產品的熱和可見煙釋放率的標準試驗方法
  12. It can be seen that fire growth and heat release rate curve can be obtained through the calculation of fire load and the estimation of fire spread, which can provide the input for the latter work and enhance the efficiency of fire protection analysis observably

    可以看出，根據火災荷載的計算和火災蔓延可能性的討論，得到火災發展的變化情況和熱釋放速率曲線，能夠為之後的工作做好前期準備，同時顯著提高這項工作的效率。
  13. The results indicate that the critical ventilation speed is direct ratio to the heat release rate and reverse ratio to the height of the smoke barrier which lies in the stairs ' access between platform and concourse

    研究表明：臨界通風速度與火災熱釋放速率成正比，與站臺和站廳間樓梯口處的檔煙垂壁高度成反比。
  14. Method of test for heat release rates for upholstered furniture components or composites and mattresses using an oxygen consumption calorimeter

    用耗氧熱量計測定裝璜傢具部件或組合件及墊子熱釋放率的試驗方法
  15. Test method for determining the heat release rate and other fire - test - response characteristics of wallcovering composites using a cone calorimeter

    用錐形量熱計測定墻面覆層材料的熱釋放率及其它著火試驗響應特性的方法
  16. Test method for heat release rate of building materials

    建築材料熱釋放速率試驗方法
  17. First and second band - gap filters amplify small signals and shift direct current voltage, which filter interference and noise by frequency. then, comparator restrains noise and interference through 700mv voltage window

    兩級帶通濾波放大器對熱釋電紅外傳感器採集人體的微弱小信號進行交流放大和直流電平的轉換，並根據頻率對噪聲和干擾進行過濾。
  18. Test method for determining the heat release rate of upholstered furniture and mattress components or composites using a bench scale oxygen consumption calorimeter

    使用小型耗氧量熱計測定裝飾傢具和墊子組合件或組合材料熱釋放速率的測試方法
  19. Heat release rate study of a pool fire interacted with water mists using a cone calorimeter

    利用錐型量熱計研究細水霧作用下的油池火熱釋放速率
  20. The testing methods of combustibles heat release rate based on mass 1oss rate is also introduced, the experimental figures and results are analysed in this paper

    火源熱釋放速率的大小對於火災的溫度分佈及煙氣流動的影響較大。
分享友人
分享到 Line

分享到臉書