熱量校準 的英文怎麼說

中文拼音 [liángjiàozhǔn]
熱量校準 英文
thermal calibration
  • : 量動1. (度量) measure 2. (估量) estimate; size up
  • : 校名詞1. (學校) school 2. (校官) field officer3. (姓氏) a surname
  • : Ⅰ名詞1 (標準) standard; guideline; criterion; norm 2 (目標) aim; target Ⅱ動詞1 (依據; 依照)...
  • 熱量 : quantity of heat; heat quantity; amount of heat熱量測量 calorimetry; 熱量單位 thermal unit; heat ...
  1. In order to enhance the precision, this design proposes that temperature - measuring circuit of platinum resistors and software should be employed to carry on adjustment of measured precision ; it also proposes that the interference of the grid can be reduced by the voltage front feed ; and meanwhile it calls for the application of the photoelectric insulation, the over heating protection and alarm so as to enhance the security performance of the system

    為了提高精度,本設計還採用了鉑電阻溫度測電路,並利用軟體對測精度進行自;通過電壓前饋控制減少電網干擾。此外,設計中還加入了光電隔離措施及過自動保護和報警功能,以增強系統的安全性能。
  2. Standard practice for temperature calibration of differential scanning calorimeters and differential thermal analyzers

    差示掃描儀與差分析儀溫度的標實施規范
  3. Test method for calibration of heat transfer rate calorimeters using a narrow - angle blackbody radiation facility

    用窄角黑體輻射設備速度器的方法
  4. Thermal exchange is key factor to influence caloric determination, and it will cause temperature dissipation in caloric measuring system during the course of measurement

    過程中由於內外桶溫差而導致的交換,是影響確測的關鍵,必須對此散失的進行正。
  5. Correction of error to measure thermal parameter parastability of rubber material

    橡膠材料參數穩態測法的誤差
  6. 1 the company has imported one set world advantaged test calibrator with matrix tensile stress and purchased international advanced level of continuous sinter kiln, oir press, opening blade machine, cut - off tester, cintrifugal tester and mould. they made in china. these equipment have about 41 sets. diamond circular saw blades with cool and hot pressing can be produced two million pieces per year

    1引進國際先進的基體張力測試儀一臺,購入具有國際先進水平的國內製造的連續式燒結爐油壓機開刃機切割試驗機離心實驗機工夾模具等41臺套。生產冷壓金剛石圓鋸片200萬片。
  7. In order to improve measurement precision and display fidelity of the instrument, three new methods of nonlinear calibration of thermal instruments, which are based on intelligent control theory, are presented in this paper, such as nonlinear compensation of zr02 oxygen measurement instrument using bp nn, nonlinear calibration of temperature measurement sensors using cmac nn and nonlinear identification of throttle flow meter using ga. these methods prove to be not only simple but also effective

    火電廠工儀表普遍存在非線性特性,為了提高參數測確度和儀表顯示的精確度,基於智能控制理論,文中提出了工儀表非線性正的新方法: bp神經網路補償氧化鋯氧計非線性特性的方法、 cmac神經網路正測溫傳感器非線性特性的方法、遺傳演算法辯識節流式流儀表非線性特性的方法。
  8. Through analysis and discussion on experiment theory and structure of calorimeter, the precision and veracity of apparatus can be efficiently enhanced with improvement on cooling emendation which is very important to calorific value measurement

    本文通過對恆溫式氧彈儀試驗原理和結構的分析和探討,對測定發過程中至關重要的冷卻正計算進行改進,有效的提高了儀器測的精確度和確度。
  9. The system can simulate the transfer process of photo - thermal and thermal - electric at a given parameter setting of structure, environment and circuit. on the basis of circuit structure, the calibration, parameter adjusting and signal readout can be simulated, the vary process of readout circuit, readout voltage, optical gain, optical gain rate, and uniformity can be given. in addition, all kinds of character parameters of device can be forecasted

    本論文根據umbirfpa的原理,建立它的軟體模擬系統,它可以根據給定的結構、環境、電路設置等參數首先模擬光電轉換過程,並可根據電路結構,模擬、參數調節並讀出信號,給出讀出電流和電壓、光學增益、光學增益比、非均勻性等各特徵的定變化過程,預測製成后器件的各種性能參數。
  10. Use of calorimetric dosimetry systems for electron beam dosimeter measurements and dosimeter calibrations, practice for

    電子束劑計測和劑用的測定系統使用規程
  11. Standard practice for heat flow calibration of differential scanning calorimeters

    差分掃描計的實施規程
  12. Calibration specification for auto - measuring system of thermocouples and resistance thermometers

    電偶電阻自動測系統規范
  13. Standard test method for mass scale calibration of thermogravimetric analyzers

    重分析儀質刻度的標試驗方法
  14. Standard practice for calibration of temperature scale for thermogravimetry

    解重測定用溫標的標實施規程
  15. Standard test method for temperature calibration on cooling of differential scanning calorimeters

    差示掃描計製冷的溫度的標試驗方法
  16. Standard practice for use of calorimetric dosimetry systems for electron beam dose measurements and routine dosimeter calibration

    電子束劑測定和常規劑測定系統使用的標實施規程
分享友人