熱電流 的英文怎麼說

中文拼音 [diànliú]
熱電流 英文
heat current
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Units with amperage draw of 48 amps or more require factory installed internal fusing

    安培數超過48安培的水器需要在工廠安裝內置保險絲。
  2. The test shall demonstrate to the satisfaction of the owner that the equipment meets all specified performance criteria, is properly installed and anchored, and operates smoothly throughout the specified speed range without exceeding the full load amperage rating of the motor or excessive motor heating

    測試應該讓用戶滿意,證明這些設備符合所有規定的性能標準,經過正確的安裝和錨固,在額定轉速范圍內運行平穩,沒有超過機的額定滿負荷運轉安培數,或發生機過
  3. Hot water is likewise less dense than cold water and rises, causing convection currents which transport energy

    水是同樣密度較低,比冷水上升,造成對,其中運輸能源。
  4. We make an electron gun which consists of a tungsten wire heated by an electric current.

    我們製造了一把子槍,它包括一根用的鎢絲。
  5. At room temperature, thermal excitation can produce an unwanted current.

    在溫室下,激發可能產生所不需要的
  6. The china heating information network altogether divides into several big edition blocks they separately are : heats the on - line exchange area ; warmly passes the heating profession tendency ; heating ( thermoelectricity ) technical paper ; heating ( heating ) thermoelectricity product supply and demand information ; warmly passes the equipment, the heating product demonstrates, heating enterprise / heating company huang ye ; heating investigation ; heating magazine free subscription ; visitor visitors ' book ; and three leisure columns - reading room, joke, tabletop wallpaper and so on

    中國供信息網共分幾大版塊分別是:供供暖論壇交;暖通供行業動態;供技術論文;供供暖產品供求信息;招標采購投資合作;暖通設備供產品論文(包括鍋爐、量表、散器換器、保溫管材、地暖等) ,供公司供暖公司採暖供暖設備黃頁;及兩個休閑欄目-在線書屋、精彩笑話等。
  7. Measuring methods of the heater or filament current and voltage for electronic tubes

    子管絲或燈絲壓的測試方法
  8. Measurements of the electrical properties of electronic tubes. part 2 : measurement of heater or filament current

    子管性能的測量.第2部分:絲或燈絲的測量
  9. This article introduces briefly the process of design and characteristic of structure of db930 tube and discusses the main problems of technology and technique which was met during the manufacture and the measures having been adopted are emphatically. it discusses the solve measures in following six aspects : the filament current is too large, carbon deposits during the carbonizing of cathode, the capacitance between the first grid and the second grid is too large, transpiring happens inside the tube, the insulation resistance between the electrodes is too lower when the filament is on and the ability of bearing high voltage is too lower

    本文簡略地介紹了db930的設計過程及其結構特點,重點論述了在試制過程中遇到的主要工藝技術問題及解決問題的措施,圍繞解決燈絲大、陰極碳化時積碳、一柵和二柵之間的容大、管內蒸散、態時極間絕緣低、耐高壓的能力差等六個方面的問題進行了論述。
  10. Electric cables - calculation of the current rating - thermal resistance - a method for calculating reduction factors for groups of cables in free air, protected from solar radiation

    纜.額定的計算.阻.室外避免太陽輻射的纜組減縮系數的計算方法
  11. Hh silc is found to have a more pronounced transient effect

    空穴應力導致的漏具有更加顯著的瞬態特性。
  12. Induction heated oil tempered spring wire is a kind of new technical material which has been developed since 1980s. it can be heated by means of eddy induced into itself through electromagnetic coil and this method is mainly used in surface quenching. with correct designing and reasonable current frequency, induction coil and heat treatment process selected, as well as plc controlling applied, the wire can be uniform heated along cross - sectional and longitudinal direction and can be quenched and tempered continuously

    應加油淬火-回火彈簧鋼絲,是二十世紀八十年代發展起來的新技術材料,在國外稱為itw induction heat oil tempered spring wire 。是通過線圈磁感應鋼絲本身產生的渦進行加,通常主要用於表面淬火。經正確設計,選擇頻率,合理的感應線圈及處理工藝,並實施plc控制,可使鋼絲整個截面及長度上得到均勻加,進行連續整體淬火和回火。
  13. The process parameters of electric upsetting include : velocities of upsetting cylinder and anvil cylinder, heating current, preheating length and time, etc. because different materials have different mechanical, electric and thermal characteristics, and there are effects between different parameters, the determination of those parameters becomes a complex problem

    鐓粗成形過程的工藝參數主要包括鐓粗缸活塞運動速度、砧子缸活塞運動速度、鐓粗壓力、加熱電流和預長度等。這些參數的選擇是一個復雜的問題,其復雜性不僅在於不同的材料具有不同的力學、傳導特性,而且各參數相互影響、相互制約。
  14. Secondary limiting thermal current

    二次極限熱電流
  15. Rated short time thermal current

    額定短時熱電流
  16. Rated continuous thermal current

    額定連續熱電流
  17. Exhibits include " the giant motor ", " the principle behind the motor ", and " making a magnet rotate by using electric current ", " the generator produces electricity " and " the magnet within the coil ". getting to grips with electric current exhibit include " when the current flows, things heat up ! ",

    展品包括通過時會產生熱電流通過時會產生磁場通過時會造成路必須閉合,才有通過路是導體,才有通過器接上池,才有通過及小心短路
  18. The approach is that we first calibrate the filter radiometer with cryogenic radiometer and measurement equipment of relative spectral responsivity and then calculate the absolute spectral responsivity. because the drift in blackbody temperature directly influnces measurement accuracy, so we adopt a feedback system to stabilize blackbody temperature through controlling the current of blackbody that improves measurement accuracy greatly

    該方法首先要用低溫輻射計及相對光譜響應度測量裝置對濾光輻射計進行標定,經計算可得到濾光輻射計的絕對光譜響應度;由於黑體溫度的漂移直接影響到測量精度,我們採用反饋系統通過控制黑體的加熱電流,來穩定黑體溫度。
  19. Xps measurement results exhibited that no detectable fe2 + existed in the compound of a ~ fe2os doped with sn4 +, which suggest that oxygen anions or cation vacancies not only can compensate the charge balance but also significantly enhance the gas - sensitivity of a - fe2o3 based gas sensors. ( 3 ) conductive type of a - fe2o3 doped with sn4 + is showed in the n - type by hall measurement and gas - sensitivity measurement. the results of measurements and characterizations suggest that the sensitive mechanism of the a - fe2o3 based nano - materials prepared by this work be the surface resistance controlled mode

    ( 3 )首次進行了霍爾測量,並結合氣敏測試結果,從不同方面證實了摻錫- fe _ 2o _ 3納米半導體的導類型是n型;綜合粉體的導率?溫度曲線、元件的阻?加熱電流特徵曲線、元件在不同氣氛下的阻特性以及比表面積等測試表徵結果,得出本文所製成的- fe _ 2o _ 3基氣敏元件的氣敏機理特徵屬于表面控制型。
  20. Rated heating current : 630

    額定發熱電流a 630
分享友人