熱風混合系統 的英文怎麼說

中文拼音 [rèfēnghúngěxìtǒng]
熱風混合系統 英文
hot-blast mixer system
  • 風 : Ⅰ名詞1 （空氣流動） wind 2 （風氣; 風俗） practice; atmosphere; custom 3 （景象） scene; view 4 ...
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 系 : 系動詞（打結; 扣） tie; fasten; do up; button up
  • 統 : Ⅰ名詞1 （事物間連續的關系） interconnected system 2 （衣服等的筒狀部分） any tube shaped part of ...
  • 熱風 : hot blast air; [氣象學] hot wind熱風乾燥 heated air drying; hot air seasoning; 熱風乾燥器 [化學] ...
  • 混合 : （攙雜在一起） mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  • 系統 : 1. （按一定關系組成的同類事物） system 2. （有條理的;有系統的） systematic
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Aiming at such problems in combustion system of homemade middle and miniature boiler, as a complex system with the character of dead zone, time variation, serious non - linearity, large time delay, coupling and a lot of disturbance, this paper presents a new set of optimal control resources. by using well - matched control method on system, stable automatic running is realized. having the serious divulgence coals difference a lot from each other in character, instability of chemistry, value of lowest emission of heat, home - made boiler controller is not at all ideal. instead of traditional model that controls the ratio based on proportional control or with the correct signal of the amount of oxygen, this paper, combined with intellect control theory - - fuzzy control and self - optimizing concept, propounded a kind of fuzzy self - optimizing controller to be used in air supplying system of the boiler, and expatiates on the idea of dividing the control process into two parts, dynamic and static to realize, thus meets the demand of homemade boiler economic running

    本設計針對國產中、小型電站鍋爐燃燒系統參數時變、嚴重非線性、干擾因素復雜、耦合嚴重、模型不易確定的特點，提出多變量協調控制方案，解決了系統可控性差，難以實現穩定自動運行的問題；在此基礎上，改變以往以煙氣含氧量控制送風的傳統模式，針對國產電站鍋爐設備主體及一、二次送風迴路泄露嚴重，煤種混雜、成分不穩定、燃燒發熱值低、燃燒效率不高等問題，應用智能控制理論中的模糊控制技術，結合自尋最優控制的思想，設計了一種模糊自尋優控制器，應用在電站鍋爐送風控制系統上，並闡述了動靜態兩種實現途徑，通過在線優化風煤配比，實現最佳經濟燃燒，切實保障了鍋爐的經濟運行。
  3. This thesis introduced the status quo, existent problems and tasks which still need to be studied in the domestic and international research on ufad ( underfloor air distribution system ), expounded the principle and characteristic of ufad. compared with the traditional mixed ventilation, this thesis pointed out ufad has advantages of specially ventilated air organize, higher ventilation efficiency, flexible collocation, optionally accommodate to realize local environment in control of individual and satisfy personal request for the thermal comfort, and energy saving, and it is a ventilated way of all for human which has broad development foreground

    本文介紹了地板送風空調系統在國內外的研究現狀、存在的問題以及仍需研究的課題，簡述了地板送風的原理與特性，並與傳統的混合通風方式進行了比較，指出地板送風有獨特的通風氣流組織、較高的通風效率、布置靈活、能夠隨意調節實現局部氣候環境的個人控制滿足個人熱舒適性要求以及節能的優點，是一種充分體現以人為本的通風方式，具有廣闊的發展前景。
  4. This dissertation describes in detail about the operation principle of cooling system, the hardware circuit design and software design of the single chip control system. being different to the structure collation method of traditional cooling system, this system divided the whole system into two parts : cooling system for engine and cooling system for hydraulic oil system, and both of them are controlled by one singlechip

    這種電液混合驅動冷卻方式可以使風扇離開發動機而靈活布置，克服了傳統驅動方式的各種弊端，減小了風扇的徑向間隙，提高了容積效率，降低了能耗，並有效解決了發動機和液壓傳動系統的過熱問題。論文對該系統的工作原理、硬體組成、軟體設計作了詳細論述。
  5. In this dissertation, the author summed up the muti - technique in fluid dynamics, heat and mass transferring, mechanical designing and computational technique and studied the conventional pressure spray dryers with different air disperse structure and outlet equipment, at last put forward the theme i. e. the study on combined spin - flow pressure spray drying technology, the main contents were as follows : ( 1 ) the combined spin - flow pressure nozzle was designed whose novel structure has no report at present, and the structural designing parameters were obtained through analyzing the physical characteristic of materials and distribution of particles

    本文總結了國內外在壓力噴霧乾燥裝置的研究應用狀況，並分析了現有噴霧乾燥裝置設計方面的優缺點，運用流體力學、空氣動力學、傳熱傳質學、機械設計和計算機技術等多學科知識，綜合研究了傳統壓力噴霧乾燥系統的單噴嘴霧化裝置在併流、逆流以及混流乾燥中的應用和噴霧乾燥塔的不同布風裝置以及出風裝置的設置情況等，提出了新型旋流式組合壓力噴霧乾燥技術並對此進行了研究，其主要內容包括： （ 1 ）本文創造性地設計出旋流式組合壓力噴嘴的基本結構，並通過對料液的物化特性研究分析以及顆粒度的分佈要求，給出了噴嘴的不同結構設計參數。
分享友人
分享到 Line

分享到臉書