熱鹽結構 的英文怎麼說

中文拼音 [yánjiēgòu]
熱鹽結構 英文
thermohaline structure
  • : 名詞1. (食鹽; 鹽類) salt 2. (姓氏) a surname
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : Ⅰ動詞1 (構造; 組合) construct; form; compose 2 (結成) fabricate; make up 3 (建造; 架屋) bui...
  • 結構 : 1 (各組成部分的搭配形式) structure; composition; construction; formation; constitution; fabric;...
  1. From studies of these characteristics of structures, palaeontology, drilling, well logging, seismic profile, salt chemistry and lacustrine sedimentary system, it is recognized that the new characteristics occur in of section pukou and in huaiyiri sag, and the huge thickness of salt rocks is formed by the crust salt materials upwelling along deep fracture in the form of hot bittern and entering lacustrine basin in this area

    通過該區造、古生物、鉆井、測井、地震、巖化學及湖盆內沉積體系等特徵的研究,認為淮陰凹陷浦口組二段和三段的沉積造有其特殊性,巨厚的巖層是殼深部類物質沿深大斷裂上涌以鹵水形式進入湖盆的果。
  2. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕試驗、灼絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、霧、耐久性(壽命)試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全檢查等。
  3. The main conclusions with innovative features acquired from the present work are as follows : ( 1 ) soft solution processing technique for preparing functional thin films was put forward and applied to preparing advanced inorganic functional thin films ; a series of molybdate and tungstate films with scheelite - type were prepared directly on metal substrates ( molybdenum and tungsten foils ) by using constant current electrochemical technique at room temperature ; a series of titanate thin films with perovskite - type were synthesized directly on titanium flakes by hydrothermal method in our country for the first time

    通過上述研究工作,得到了如下具有創新性研究成果: ( 1 )首次在國內提出和運用軟溶液制備工藝技術進行無機功能薄膜材料的制備研究;首次在國內採用室溫恆電流電化學技術直接在金屬基底(鉬片和鎢四川大學博士學位論文片)制備了白鎢礦的鋁酸、鎢酸薄膜;首次在國內採用水合成技術在欽金屬片上直接沛叮備了鈣欽礦的欽酸薄膜。
  4. Thirty - one crystals of polyoxometalates ( 1d, 2d, 3d ) were prepared by means of middle hydrothermal technique, molecular design and self - assembly, and characterized structurally by single crystal x - ray diffraction. the thermal stability, activity of catalysis and magnetism of some compounds were systematically studied. the continuous appearance of p - v - o, p - mo - o, v - mo - o, v - o system with novel structure enrich polyoxometalate chemistry, the reaction characterization and the synthesis law of molybdates, tungstates and vanadates under hydrothermal conditions were explored

    由於p - v - o 、 p - mo - o 、 v - mo - o 、 v - o體系新不斷出現,豐富了多金屬氧酸化學,探討水條件下釩、鉬、鎢物種的反應特性和生成規律,研究原料的選擇、配比、加料順序、濃度、酸度、反應溫度、反應時間等因素對產物的生成及的影響,為新的催化劑、導電材料、磁性材料的研製與開發積累經驗。
  5. Alkali basite, which came from upper mantle or lower crust, invaded through those structure, which not only bring cu et al mineralizing elements, but also the most important is that thermal energy. it cycled the formation water ( yinmin fonnation and luoxue formation ), and form alkali - rich, middle - high temperature and salinity fluid mixed with alkali - rich magmatic water. there were high rate of percolation and well voidage in the contact zone between yinmin purple stratum and yinmin rubblerocks, which is in favor of the transposition and mineralization of minerogenetic fluids

    因此,總東川稀礦山式銅礦成礦模式為沉積( fe 、 cu ) ?液疊加( cu )改造:晉寧-澄江期,小江深大斷裂發生走滑運動,在東川礦區造成右行旋扭及其派生造,形成「 z 」字形落因破碎帶,同時來自深源(下地殼或上地幔)堿基性巖漿侵入,不僅帶來了大量cu等成礦物質,更重要的是提供了源,促使地層水(落雪組白雲巖和因民組紫色層)循環,與富堿( na和k )巖漿水混合,形成富堿中高溫高度流體。
  6. With the very low water to cement ratio, rpc has ultra - high strength high ductility and low permeability. in this paper, the compressive strength of rpc can reach to a high point with the number approximately 135mpa. as illustrated from the study results, we can approve some fundamental conclusions : there are big effects on rpc with deferent kinds and properties of raw materials and deferent curing conditions ; stress - strain curve shows the process of destroy with rpc samples ; x - ray diffraction analysis indicates that heat treatment at temperatures 90 accelerate the hydration of rpc sharply, therefore, mechanical and microstructural properties of rpc are highly dependent on heat treatment ; it is believed that rpc materials have excellent resistance to chloride permeability ; during the heat treatment, the shrinkage of rpc developed quickly because of chemical reactions ; the rpc with slag mostly has the advantage of rpc without slag about resistance to solutions corrosion

    研究果表明:通過對rpc各組分摻量變化的研究,可以找到rpc的最優配合比;試件成型后的養護制度對rpc的性能影響巨大; rpc的抗壓應力?應變曲線可以反映出試件受破壞時微裂紋的擴展情況,剛纖維的摻入可以大幅改善rpc的韌性; rpc在成型后存在較大的收縮,而其中的化學收縮要遠遠大於乾燥收縮; rpc具有很強的抗氯離子滲透性能,漿體的密實度很高;通過x射線衍射實驗,可以發現rpc的膠凝體中ch晶體已經幾乎不存在,膠凝體主要由c - s - h凝膠和未水化水泥顆粒組成;在抗溶液侵蝕的實驗中,摻礦渣rpc的抗溶液侵蝕性能在絕大多數情況下要好於不摻礦渣試件,酸、堿溶液和浙江工業大學碩士學位論文摘要一些溶液都會對rpc的產生侵蝕作用,但是機理各有不同。
  7. Four chapters are comprised in this thesis : chapterl : gives the outline of organic - inorganic hybrid materiais area. thrugh investigation and generalization, we know that polyoxometalate - based orgaic - inorganic hybrid materials, which have so various smictures as to design and tailer molecules easily, have both functional properties of orsanic moieties and therml stabilization of inorganic moieties

    論文共分四章:第一章通過大量的文獻調研,總發現有機-無機雜化多金屬氧酸綜合了有機的功能性和無機的穩定性於一體,具有多樣性,便於分子設計與剪裁。
  8. Salt alginate fiber was prepared by means of wet spinning, the structure and properties of the fibers were studied by differential thermal analysis, infrared and scanning electron microscopy

    摘要採用溶液紡絲的方法制備了海藻酸纖維,藉助分析、紅外分析及掃描電子顯微鏡等對纖維與性能進行了研究。
  9. Products and systems for the protection and repair of concrete structures - test methods - determination of thermal compatibility - thermal cycling without de - icing salt impact

    混凝土保護和修整用的產品和系統.試驗方法.符合性的測定.無水浸濕解冰循環法
  10. Products and systems for the protection and repair of concrete structures - test methods - determination of thermal compatibility - freeze - thaw cycling with de - icing salt immersion

    混凝土的保護和修整用的產品和系統.試驗方法.符合性的測定.水浸濕解冰循環法
  11. The unstable stacking of layers of org - mmt was easily damaged under force and heat. hence, it is very important to decide the process temperature for preparing the composites, and it was found that 200 was a upper limitation of temperature

    由於在高( 200以上)或強機械剪切作用下,蒙脫土層狀堆疊會坍塌,導致不能與聚合物分子作用生成聚合物?層狀硅酸納米復合材料,因此熔融插層的溫度選擇顯得十分重要。
  12. Products and systems for the protection and repair of concrete structures - test methods - determination of thermal compatibility - part 1 : freeze - thaw cycling with de - icing salt immersion

    混凝土的防護和維修用產品和系統.試驗方法.測定容性.第1部分:解凍.浸入防凍融雪
  13. In this paper, high density polyethylene / bentonite nanocomposites were prepared by simple melt compounding, their structures were demonstrated with x - ray diffraction, ft - ir spectra and dta. it was proved that the molecular chain of pe could be intercalated in layered silicate of organobentonite , the intercalation nanocomposites were obtained

    本文採用簡單熔融插層復合法制備高密度聚乙烯/膨潤土納米復合材料,用x -射線衍射、紅外光譜和差分析等手段表徵了復合材料的,證實聚乙烯分子鏈確已進入有機膨潤土的硅酸片層間,形成插層型納米復合材料。
分享友人