燃料電極 的英文怎麼說

中文拼音 [ránliàodiàn]
燃料電極 英文
fuel electrode
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : 名詞1 (材料; 原料) material; stuff 2 (喂牲口用的穀物) feed; fodder 3 (料器) glassware 4 (...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 燃料 : fuel
  • 電極 : electrode; pole
  1. As a comparison, ba1. 03ce0. 8gd0. 2o3 - was synthesized by sol - gel method. among these samples, nonstoichiometric samples were synthesized for the first time. the research work involved : the crystal phase of the sinters were determined by xrd ; ionic conduction under different experimental atmospheres was measured by gas concentration cells ; performances of hydrogen - air fuel cells with the sinters as electrolytes and porous pt as electrodes were measured

    用粉末x射線衍射儀鑒定它們的結晶相;在( 600 1000 )范圍內,以燒結體作為解質隔膜,多孔性pt黑為正、負, pt - rh合金網為集,分別組成氫濃差池、氧濃差池及氫?空氣池並測定了它們的性能,研究了不同氣氛下樣品的離子導特性及影響池性能的因素。
  2. More recently, the perovskite manganite compounds, la1 - xsrxmno3 have been used as the cathode of the solid oxide fuel cell ( sofc ) because of their electro - ion conductivity properties. in manganite perovskites, substitution of divalent ions ( alkaline earth metals viz

    近幾年來, la _ ( 1 - x ) sr _ xmno _ 3這類鈣鈦礦型結構的氧化物材因為其具有混合子-離子導特性而被廣泛的應用於固體氧化物池陰
  3. So, how to consider about these factors and design out suitable dc / dc converter becomes very important. at the same time, it helps a lot to bring the fuel cell to market use

    因此,如何綜合考慮這些因素,合理設計符合要求的dc / dc變換器就顯得尤為重要,同時這對于池的市場化推廣應用也具有其重要的意義。
  4. Oxygen diffusion transport and electrochemical reaction in the oxygen cathode of direct methanol fuel cell ( dmfc ) have been expressed with the tffa model. model calculation has been carried out to investigate the effects of structural parameters of the dmfc cathode on the electrode performance, which is respectively represented by the curve of cathode overpotential versus current density. much attention has been paid to parameters including the porosity of the reaction layer, the thickness of the thin - film on the flooded - agglomerate, the radius of the flooded - agglomerate, the volume fraction of the flooded - agglomerates in the reaction layer

    本文首先運用tffa模型描述直接甲醇池( dmfc )陰氧氣的傳遞和化學反應過程,研究了過位-流密度曲線受陰結構參數變化的影響程度,其中著重考慮了以下幾個參數:催化層的孔隙率,浸漬聚集體薄膜的厚度,浸漬聚集體的半徑,浸漬聚集體在催化層中的體積分數。
  5. In the thesis, the strategy for china to develop the hydrogen energy system about fuel cell vehicles is analyzed firstly. then a case in beijing is studied, which is based on an imaginary but possible fcb ( fuel cell bus ) project in beijing, 2008. in the case, 11 feasible plans of hydrogen energy systems about fuel cell vehicles are evaluated from all the aspects of energy, environment and economy with lca ( life cycle assessment )

    論文首先從宏觀角度分析我國應該採取的池汽車氫能系統發展戰略;然後從微觀角度運用生命周期評價方法對一個假想的,卻有可能在未來實施的池汽車氫能系統案例的所有可行方案從能源、環境和經濟三方面進行評價,選出最優方案並討論改進方向;最後對池汽車氫能系統的安全性進行評價並總結現有工作中存在的問題,展望氫能系統評價的發展方向。
  6. Modeling of the cathode of proton exchange membrane fuel cell using interdigitated flow fields

    交指型板的質子交換膜池陰模擬
  7. Numerical simulation of mass transfer in the cathode of a proton exchange membrane fuel cell with interdigitated gas distributors

    交指型的質子交換膜池陰內傳質過程的數值模擬
  8. A hydrogen - oxygen proton exchange membrane fuel cell, with a control system for pressure, temperature and humidity, was set up

    摘要在組裝的單體質子交換膜氫氧池系統上,用線性位掃描法研究了不同池溫度和濕度下的陽化行為。
  9. In chapter 5, the principle of molten carbonate fuel cell power system is introduced. the development of the system, such as the improvement of cell components including electrodes and electrolyte, the fuel processing, the heat recovery, the power conditioning and grid interconnection, the control system and the combine generation

    第五章在簡要敘述了熔融碳酸鹽池發系統原理后,從以下幾個方面對系統的開發進行了論證:單體元件(解質)性能的提高,的處理,余熱利用,力調節和並網,池/氣輪機/汽輪機聯合發以及系統控制與優化。
  10. The research on electrocatalysts for oxygen reduction is of great importance to the development of proton exchange membrane fuel cell

    摘要氧還原催化劑對于質子交換膜池的發展具有重要的意義。
  11. Exemplified with a number of representative systems which are highly valuable in industry and academically important, including electrode membranes of fuel cells, sesame seeds as well as hard bones and cartilages of marine fish, the extensive applications of microscopic mri images with various weighting approaches to the investigations of micro - structures and dynamics including the developmental processes of plants are demonstrated

    以具有高度產業價值及重要學術意義的幾個典型體系:月莫、芝麻種子和海生魚骨為例,說明各類加權圖象在微結構和動態(包括植物生長過程)研究中的廣泛應用。
  12. In order to combine biomass gasification technology, we have checked the fuel cell ' s impurity tolerance level. the results show that traces of h2s can damage the fuel cell. but co and cm almost have no influence on the performance of the fuel cell

    試驗結果表明, ch _ 4 、 co對池性能沒有太大的影響,而是作為參加反應的,而微量的h _ 2s氣體即可對產生破壞性的作用,解質中的碳酸根轉化為硫酸根,從而使池失效。
  13. Oxygen diffusion transport and electrochemical reaction in the oxygen cathode of alkaline fuel cell ( afc ) and pemfc have been expressed with the tffa model, including oxygen transferring in gas channel of gas diffusion layer and reaction layer, oxygen dissolution and diffusion in thin - film of reaction layer, oxygen reaction and diffusion in flooded - agglomerate of reaction layer and the conduction of electron and ion. numeric algorithm of the model equations is also obtained

    本文將tffa模型應用於堿性池( afc )和質子交換膜池( pemfc )陰,推導出陰各種傳遞和反應過程的描述方程,包括氧氣在氣體擴散層和反應層氣體通道中的擴散,氧氣在反應層薄膜中的溶解和擴散,氧在反應層浸漬聚集體中的反應和擴散以及子和離子的傳導,並給出方程的數值解法。
  14. At first, a two - dimensional across - the - channel mathematical model for simulation of a direct methanol fuel cell is described. the model accounts simultaneously for electrochemical kinetics, hydrodynamics, and multicomponent transport, and fully accounts for the mixed potential effects of methanol oxidation at the cathode as a result of methanol crossover caused by convection, diffusion and electro - osmosis

    首先描述了一個用於模擬直接甲醇池特性的垂直於流道的二維數學模型,模型考慮了多組分傳遞、水動力學和化學動力學,並且考慮了甲醇竄流在池陰產生的混合位的影響。
  15. In this paper, the principle of the direct carbon fuel cell, its state - of - the - art components and performance and the prototype structure are reviewed and discussed

    故對固體碳池的原理、碳材結構對陽性能的影響和其它組成部件及單池原型化設計的相關內容進行了論述。
  16. Tow types of fuel - cell models can be distinguished : microscopic and macroscopic. this paper adopt agglomerate microscopic model to analyze the fuel cell ' s performance. according to the computation, it can be concluded that the performances are determined by the thickness of the electrode, the effective ionic conductivity, the radius of agglomerate and other parameters

    池單體,建立了微觀的數學模型? ?聚塊模型,用nenmanbandj方法計算熔融碳酸鹽池陽和陰的過位,分析了各種參數的影響,對的制備,提高單池的性能,有一定的指導意義。
  17. In the thesis, we proposed a random lattice model of mea the lattice model randomly occupied by three kinds of particles, pt / c, nafion and ptfe ( poly - tetra - fluoro - ethylene ), was generated on a computer by the means of monte carlo method. it was supposed that current was only produced on those catalysts which have not only channels of electrons via carbon but also have channels of proton via nafion. the purpose of the work, in a word, is to find how many catalysts, pt / c, with such a two - types channels

    本文首先建立了質子交換膜池的膜的隨機方格子模型,在模型各格點位置用montecarlo方法生成隨機分佈的粒子、 nafion粒子和聚四氟乙烯團粒,認為只有那些既有質子傳輸通道,又有連續的子通道和氣體擴散通道的胞元才產生有效的流,而其餘胞元不產生流,把的輸出流轉化成一個概率事件。
  18. Preparation and characterization of the bifunctional oxygen electrode catalyst for unitized regenerative fuel cell

    組合式再生池雙效氧催化劑制備與表徵
  19. Preparation and characterization of the carbon nano tubes supporting oxygen electrode material for pemfc

    質子交換膜池中碳納米管負載的氧制備與表徵
  20. The passivafion was caused by the formation of platinum oxide and was enforced by increasing cell temperature and humidity

    提高池的工作溫度和濕度,都加速了池陽的鈍化。
分享友人