燃燒加速劑 的英文怎麼說

中文拼音 [ránshāojiā]
燃燒加速劑 英文
burning-rate accelerator
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : Ⅰ名詞1 (藥劑; 制劑) a pharmaceutical or other chemical preparation 2 (某些有化學作用的物品) a...
  • 燃燒 : (物質劇烈氧化而發光、發熱; 燒) burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. Theoretical analysis and testing results demonstrated that viton, a new substitute of the former plasticizer, could noticeably improve its performances, which has been proved as the important improvements of the mixture. due to the favorable thermochemistry performance, dicyandiamide can act as a good combustion - rate regulator. the addition of antistatic agent can desirably increase the antistatic capability of the mixture, and the testing results showed that the performance of the improved mixture was excellent

    理論分析和測試結果均表明了以氟橡膠取代耐水點火藥中原粘合將使藥的各項性能有明顯的改善,是耐水點火藥改進的重要方面;雙氰胺具有良好的熱化學特性,作為耐水點火藥改進中的度調節具有很好的調效果;抗靜電入,進一步提高了藥的抗靜電能力,測試分析表明改進后藥的性能更優異。
  2. At the conditions with the same fuel injection quantity per cycle and the same engine speed, with the increase of the additive mass fraction in the fuel, the ignition and heat release timings brought forward, the peak of heat release rate increased and the operating range at low engine load was enlarged obviously. however, excessive additives will make the engine be prone to knock, run rudely and shorten the operating range at high engine load

    在相同循環噴油量和相同轉的條件下,隨著添質量分數的增, hcci著火和放熱提前,放熱峰值提高,低負荷工況范圍明顯拓寬,但過高的添質量分數會使得發動機爆震,工作粗暴,導致高負荷工況變窄。
  3. The simulations results show that the spoiler is available to make the fuel and the oxidizer coming from the former to stay in the cavity for a long time, to let the fuel and oxidizer mix and burn completely. since there is a high temperature zone forming by vortex in the middle of the motor, it required a restricted thermal protection. the plate with holes decreased the vortex function in the cavity, which could not promote the combustion efficiency, but to decrease temperature in the cavity and be benefit to thermal protection of the wall

    計算結果分析表明:擾流板可以使料和氧化在擾流腔內的滯留時間長,促進料與氧化的摻混,提高效率,但由於渦流在發動機的中間部位形成了高溫區域,致使局部料和絕熱層率增大,大了熱防護的難度;孔板結構減弱了擾流腔內迴流區的漩流作用,不能增推進效率,但可以使擾流腔內的溫度降低,給壁面熱防護帶來好處。
分享友人