燃燒器用風機 的英文怎麼說

中文拼音 [ránshāoqìyòngfēngjī]
燃燒器用風機 英文
burner blower
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 風 : Ⅰ名詞1 （空氣流動） wind 2 （風氣; 風俗） practice; atmosphere; custom 3 （景象） scene; view 4 ...
  • 機 : machineengine
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Hot waste gas from grate cooler is divided into four parts : part of it is sent to kiln as secondary air, part of it is sent to decomposition furnace as burning air by tertiary duct, and the rest is drained to the atmosphere after purified by electric dust collector at kiln head

    出篦冷機高溫廢氣一部分作為窯用二次空氣入窯；一部分由三次風管送到分解爐作為燃燒空氣；剩餘廢氣經窯頭電收塵器凈化處理後排入大氣。
  3. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。
  4. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變；實驗臺的流量測量採用風機動力性能測試標準中流量方法等。
  5. A combustion model has been built and burning process has been simulated by computer in blast furnace stove with ceramic grid - burner

    摘要建立了高爐熱風爐燃燒數學模型，應用計算機模擬研究方法對中空柵格陶瓷燃燒器的火焰形態進行了模擬研究。
  6. In this article, analysis is made on some problems which must be faced when plasma ignition technology is applied in 600mw unit boiler to achieve a power plant without oil, such as plasma burner disposal, the number of plasma burner, the boiler ignition coursing satisfy the temperature needs, pulverized coal origin, hot air origin, and reconstruction solutions are proposed

    本文詳細分析了某廠2 600mw機組鍋爐採用等離子點火技術實現無燃油電廠所面臨的等離子燃燒器的布置、等離子燃燒器層數的選擇、鍋爐點火啟動滿足升溫速度的要求、煤粉的來源、熱風的來源等問題，並提出了相應的解決方案。
  7. For the dual register burner, while cat being applied, it simulates the influences of the flow field in the burner by changing the velocities of primary flow and inner / outer secondary flows, and by changing the opening percents of inner / outer vanes. eventually, the appropriate values for velocities and opening percents of vanes are recommended, to provide engineering problems with theoretical orientations

    針對雙調風旋流燃燒器，本文運用計算機輔助試驗（ cat ）方法對一次風速度，內、外二次風的葉片開度及內、外二次風速度對燃燒器內流場的影響進行了數值試驗，得出了雙調風旋流燃燒器推薦使用的二次風葉片開度和速度值范圍，為工程應用提供了理論依據。
  8. Reburning technology is a valid method. this paper focuses on nox - emission problem of traditional units with hot air transferring pulverized coal. the main technical route of this paper is to use the pulverized coal contained within tertiary air to reduce the nox emission as the reburning fuel

    本文主要是針對傳統的缺少有效降低no _ x方法的熱風送粉機組進行研究，通過對制粉系統和燃燒器的改造與調整，利用三次風中的含粉作為再燃燃料送入爐膛，實施再燃燒以降低no _ x的排放。
  9. In this paper, two 50t / h coal - fired boilers " burning control system of 26 # heating station was studied as its thesis, the primary pid controller was improved as its purpose, fuzzy control theory developed rapidly at present was applied as its means. the design scheme is that controlling transducers change rotate speed of supplying coal electromotor, fan, and blower using 8051 micro - controller. it realized computer control of burning process

    本文以26 ~ #供熱站的2臺50t / h燃煤鍋爐的燃燒控制為課題，以改進原有pid控制為目的，以當前發展比較迅速的模糊控制理論為手段，提出了採用8051單片機控制變頻器改變給煤機、引風機和送風機轉速的設計方案，實現了燃燒過程的計算機控制。
  10. In order to simulate parameters of different diesel exhaust heat, an simulative multi - heat testing flat is set up with an combustor and two fans

    採用燃燒器和兩個離心風機構成的二級送風系統組成模擬多熱源實驗臺，以模擬不同的內燃機余熱條件。
分享友人
分享到 Line

分享到臉書