燃燒室阻力 的英文怎麼說

中文拼音 [ránshāoshìzǔlì]
燃燒室阻力 英文
burner drag
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  • 阻力 : 1 （阻礙事物發展的外力） obstruction; resistance 2 [物理學] resistance; drag; drag force; nowel; ...
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Results show that all the geometric parameters have remarkable effects on combustion performance ; the swirl of intake air generated by skew intake holes enhances fuel - air mixing, minimizes dead zone and stabilizes the flame with reverse flow, but the excessive reverse flow can cause overheat in combustion chamber and exhaust ; the consistency of flow resistance in intake and exhaust system is conducive to the stability of heater performance

    研究表明，燃燒室進氣孔的孔徑、孔數、孔的分佈及方向等均對燃燒性能影響很大；斜孔所產生的旋轉進氣，雖具有強化燃氣混合、消除死區和迴流穩焰的作用，但迴流過度會使燃燒室及排溫過高；保證進排氣系統流動阻力（壓力）的一致性，有助於保證加熱器性能穩定。
  3. In order to solve the problems effectively, under the auspices of 863 plan in china, the synthesis diagnosis has been carried by means of measuring and numerical imitating the combustion chamber of refining column, and some conclusions is such as : ( 1 ) through measuring the temperature and combustion in the burning chamber of the refining column, the result shows the temperature difference on the same level is more than that in height direction, and there is a few of co in bottom of burning chamber. ( 2 ) in order to ensure normal work of flue system in lead column in the course of zinc refining, theoretic calculation and measure about the flow resistance of exhaust gas are carried through. the results of study reveal that drawing out force of chimney is inadequate, which is mainly caused by illogicality of flue construction

    在研究過程中，採取了現場實測和數值模擬手段對韶關冶煉廠鋅精餾鉛塔燃燒室及排煙系統進行了綜合診斷，具體結果包括如下： （ 1 ）完成鋅精餾鉛塔燃燒室內溫度測試以及燃燒狀況的測試，結果發現：鉛塔燃燒室內水平方向的煙氣溫度並非均勻，而且其溫差比上下方向的溫差更大，以及鉛塔燃燒室尾部存在co未燃燼問題； （ 2 ）為了保證鉛塔煙氣系統的正常工作，對煙道系統的阻力進行了理論計算及測試分析，結果發現：鋅精餾鉛塔煙氣系統中煙囪抽力不夠，這主要是煙道結構不合理所造成的。
  4. The result of investigation on drags of cavities under combustion condition, with different injection schemes and fuel equivalence ratio, indicates that it is smaller than it ’ s of cold flow, and decreases with increasing fuel equivalence ratio, and could be converted into the

    研究發現:凹腔火焰穩定器熱試阻力小於冷流阻力，並隨著當量比的增加而減小，最終會表現為正推力。綜合論文研究成果，提出了多凹腔燃燒室設計技術。
分享友人
分享到 Line

分享到臉書