燃燒效應 的英文怎麼說

中文拼音 [ránshāoxiàoyīng]
燃燒效應 英文
fire behavior
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  • 效應 : [物理學] effect; action; influence
  1. Biological magnetic field : microwave energy produces by biological magnetic field penetrates into dermis, epidermis and hypodermis, and produces warm utility to expand capillary, activating hormone - sensitive lipase and consuming excessive fat

    生物磁場：通過生物磁場，進入皮膚表皮、真皮、皮下組織，產生溫熱效應可以使微血管擴張，增加組織反應酶的活性，使脂肪在皮下燃燒，消耗多餘脂肪。
  2. Preliminary test of combusting property of cows showed that this kind of synfuel had a good combustion behavior, and high combustion efficiency

    燃燒性實驗表明，三元料漿的燃燒性能良好，燃燒效率高，是一種工業應用前景廣闊的漿體。
  3. Combustion effects may cause unintentional interactions with the adjacent main flow environment.

    燃燒效應可能無意地引起與鄰近主流環境的相互作用。
  4. Meanwhile in the condition of high temperature, water vapors can participate in combustion. water gas reaction will happen, which will reduce carbon particle in flame, and reform combustion performance, so improve combustion efficiency. the article developed a kind of technology of water injection into intake ports for 4135g diesel engine, meanwhile designed a suit of water injection system

    同時在高溫條件下，水蒸汽參與燃燒，部分水分子與未完全燃燒的熾熱的炭粒發生水煤氣反應，形成可燃性氣體，從而減少了火焰中的炭粒，提高了油的燃燒程度，改善了燃燒狀況，提高了油的燃燒效率。
  5. This paper takes the practicing - study on the new type buring furnace system as its thesis, and it emphasizes the raising efficiency of burning. in the paper, one new type burning furnace based on the new process and construction has been designed, furthmore, a new way what related auto - control system to raise fficiency has been studied

    本文以燃燒爐的應用研究為課題，以提高燃燒爐燃料利用效率為重點，從系統流程和結構上研究開發出節能的新爐型，從新型燃燒爐系統的自動控制上進一步研究探討了提高熱效率的方法，重點探討了新型燃燒爐的微機自動控制。
  6. For design calculations, it is usually adequate to use the theoretical value for the approximate mixture ratio, corrected by a typical combustion efficiency factor.

    對于設計計算，採用相應混合比的理論值，並用典型的燃燒效率系數來修正，通常這樣做是恰當的。
  7. To optimize the burning operating mode and improve combustion efficiency correspondingly

    優化燃燒工況、相應提高燃燒效率。
  8. Standard test method for determining the corrosive effect of combustion products using the cone corrosimeter

    用錐形腐蝕計測定燃燒製品腐蝕效應的標準試驗方法
  9. 10. 02 fire test response standard for determining the corrosive effective of combustion products using the cone corrosimeter

    用錐型腐蝕計測定燃燒產品腐蝕效應的火焰試驗響應標準
  10. Aiming at such problems in combustion system of homemade middle and miniature boiler, as a complex system with the character of dead zone, time variation, serious non - linearity, large time delay, coupling and a lot of disturbance, this paper presents a new set of optimal control resources. by using well - matched control method on system, stable automatic running is realized. having the serious divulgence coals difference a lot from each other in character, instability of chemistry, value of lowest emission of heat, home - made boiler controller is not at all ideal. instead of traditional model that controls the ratio based on proportional control or with the correct signal of the amount of oxygen, this paper, combined with intellect control theory - - fuzzy control and self - optimizing concept, propounded a kind of fuzzy self - optimizing controller to be used in air supplying system of the boiler, and expatiates on the idea of dividing the control process into two parts, dynamic and static to realize, thus meets the demand of homemade boiler economic running

    本設計針對國產中、小型電站鍋爐燃燒系統參數時變、嚴重非線性、干擾因素復雜、耦合嚴重、模型不易確定的特點，提出多變量協調控制方案，解決了系統可控性差，難以實現穩定自動運行的問題；在此基礎上，改變以往以煙氣含氧量控制送風的傳統模式，針對國產電站鍋爐設備主體及一、二次送風迴路泄露嚴重，煤種混雜、成分不穩定、燃燒發熱值低、燃燒效率不高等問題，應用智能控制理論中的模糊控制技術，結合自尋最優控制的思想，設計了一種模糊自尋優控制器，應用在電站鍋爐送風控制系統上，並闡述了動靜態兩種實現途徑，通過在線優化風煤配比，實現最佳經濟燃燒，切實保障了鍋爐的經濟運行。
  11. This paper is a thesis about the application of htac technology on furnace and introduces the furnace construction, regenerative combustion system and control system

    摘要介紹了高溫空氣燃燒技術在攀鋼軌梁廠加熱爐上的應用，介紹了爐體結構、蓄熱式燃燒系統、控制系統及改造后的效果。
  12. Strong damping effects are possible because of solid particles in the chamber.

    燃燒室內的固體顆粒可能引起強烈的阻尼效應。
  13. The convective term is solved by ausm + ( a sequel to ausm which means " the advection upstream splitting method " ). the 7 species 8 steps model and 7 species 7 steps model of hydrogen / air is used in the hydrogen reacting flowfield, the 9 species 5 steps model of methane, the 10 species 10 steps model of ethane and the 10 species 13 steps model of kerosene are used in the hydrocarbon reacting flowfield, the results of the distributions of velocity, mach number, pressure, static temperature, total temperature, species mass fraction and the combustion efficiency are gained, and the numerical results of the pressure of hydrogen and methane are compared with those of the experiment

    計算中通量項採用ausm +通量分裂格式，氫反應流場採用氫/空氣的七組元八方程模型和七組元七方程模型，碳氫反應流場採用甲烷的九組元五方程模型、乙烯的十組元十方程模型和煤油的十組元十三方程模型，得出了超燃發動機燃燒室流場的速度、馬赫數、壓力、靜溫、總溫和組元質量分數分佈及燃燒效率等性能參數，其中氫和甲烷的計算壓力分佈與實驗結果進行了比較。
  14. Giving some suggestions to develop the fuel according to the experiment result. the final experiment result is very good. after using alcohol - blended diesel oil in diesel engine, the power can be achieved, the let of contamination is reduced, thermal efficiency enhanced, the exhaust degree and the max combustion pressure is steady

    對理論和實驗結論進行總結，對課題的發展提出建議實驗的最終數據證明：在柴油機上燃用乙醇柴油后，能夠達到原機的功率，並且柴油機的排放狀況有很大的改善，熱效率有一定的提高，排氣溫度和最高燃燒壓力基本不變，實驗結果是比較理想的，可以考慮在實際中應用和推廣乙醇柴油。
  15. You should follow the installation instructions for the luminaires, such as installing away from combustible surface ( wall paper, wooden false ceiling ), allowing sufficient room for heat dissipation ( particularly luminaires fitted with tungsten halogen lamps ), ensuring effective earthing connection ( such as adding star and spring washers at the earth terminal ), and adopting proper anchorage to support its weight

    燈飾應按照指示安裝，注意要遠離容易燃燒的表面（例如墻紙、木製假天花） ，預留足夠的散熱空間（尤其是裝有鎢絲鹵燈的燈飾） ，確保有效接地（例如在接地終端加上菊花介指和彈弓介指） ，並因應燈飾的重量，選用適當的安裝方法（例如大型的吊燈，須選用拉爆螺絲等） 。
  16. Method of test for establishing the efficiency of decorative fuel effect gas fires

    確認裝飾性可燃效應氣體燃燒效果的試驗方法
  17. As to the experimental study, a test system was designed firstly, which include propellant feed system, cooling system, controlling system and measure system. secondly, a test engine was designed according to the experimental requirement. on this basis, experiments under different working conditions were done, and the results of them were analyzed, which showed the combustion efficiency and stability

    實驗方面，首先設計了針對三組元發動機推力室工作過程進行試驗的試驗系統，包括推進劑供應系統與冷卻水供應系統、控制系統以及壓力、溫度、流量的測量採集系統；其次，設計出符合試驗要求的縮尺發動機；最後針對所設計的試驗系統和發動機，進行了不同工況的試驗，對所得數據進行了分析處理，得到了不同工況下燃燒效率和燃燒穩定性特性。
  18. In this paper, simple reacting flow model in solid - propellant ducted rocket combustor based on eddy break - up model is established. the model is used to simulate the three - dimensional combustion flowfields in an experimental motor. some factors how to affect the combustion efficiency are discussed in the paper, including air intake and gas generator nozzle

    本文基於簡單反應的旋渦分裂模型，建立了固體火箭沖壓發動機補燃室內的湍流燃燒模型，並在該模型下對某實驗發動機進行了三維數值模擬，研究了補燃室設計參數包括進氣道出口設計參數和燃氣發生器噴管設計參數對燃燒效率的影響。
  19. The disposal of the valves and intake manifold structure not only affect fresh air charge but airflow in the cylinder, which immediately affect combustion efficiency and the performance of dynamic, economic and emission. the structure of the air distributing institution has influence on charging efficiency and the noise of engine. the combustion chamber affects compression scale which has great influence on dynamical performance ; f / v which affects the exhaust of hc ; squash area and clearance which have great influence on the intensity of squash

    氣缸蓋的氣門排列方式與氣道結構形式影響進氣充量和氣流在氣缸內的運動，從而影響了燃燒效率，對整機的動力性、經濟性以及排放都有直接的影響；配氣機構的形式影響充氣系數和整機噪聲等；缸蓋燃燒室決定了影響整機動力性能的壓縮比，影響hc排放的f / v和對擠流起決定性作用的擠氣面積以及擠氣間隙，所以燃燒室對整機動力性、經濟性、排放等都有重要的影響；氣缸蓋是整機熱負荷與熱應力最大的部件之一，熱負荷過高將不利於發動機壽命以及可靠性的提高。
  20. It has extrude merit of wide applicability to fuel, high efficiency of burning, low letting of oxidenitrogen. great radio of charge regulation and rapid charge regulation

    它具有燃料適應性廣、燃燒效率高、氮氧化物排放低、負荷調節比大和負荷調節快等突出優點。
分享友人
分享到 Line

分享到臉書