燃燒池 的英文怎麼說

中文拼音 [ránshāochí]
燃燒池 英文
combustion cell
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 池 : 名詞1 （池塘） pool; pond 2 （旁邊高中間窪的地方） an enclosed space with raised sides 3 （舊指劇...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. As a comparison, ba1. 03ce0. 8gd0. 2o3 - was synthesized by sol - gel method. among these samples, nonstoichiometric samples were synthesized for the first time. the research work involved : the crystal phase of the sinters were determined by xrd ; ionic conduction under different experimental atmospheres was measured by gas concentration cells ; performances of hydrogen - air fuel cells with the sinters as electrolytes and porous pt as electrodes were measured

    用粉末x射線衍射儀鑒定它們的結晶相；在（ 600 1000 ）范圍內，以燒結體作為電解質隔膜，多孔性pt黑為正、負電極， pt - rh合金網為集電極，分別組成氫濃差電池、氧濃差電池及氫?空氣燃料電池並測定了它們的性能，研究了不同氣氛下樣品的離子導電特性及影響燃料電池性能的因素。
  2. In the mean time, i test the separator ’ s performance, including the rate of hole 、 the performance of absorbing electrolyte and the conductance eletrochemical steady range 、 machine intensity test, and then make bettery to test its cycle performance. the test result show that, the spreading separator get better performance, when dbp ’ s percentum reach 50 %, and dry temperature reach 90, after ultraviolet radiation disposal. the test show that, the separator has high conductance reach 6. 1 10 - 3s / cm ( 25 ), and the machine intensity can reach 3. 92 mpa, this separator can meet the need of making bettery, the bettery capability will go down after 30 cycle. and the bettery show worse performance under high temperature, under 70, the bettery will get fire. making the intensified seprator, i find that when dbp % : pvdf % = 40 % : 60 %, dbp % + pvdf % : sio2 % = 70 % : 30 %, the separator get

    但用其制備的電池循環30周期后容量發生衰減，並且電池高溫性能差， 70下電池燃燒;強化聚合物膜的最佳制備配比條件為: dbp : pvdf為40mass % : 60mass % ， dbp含量與pvdf含量之和與納米sio2含量比值為70mass % : 30mass % ;強化電解質隔膜的室溫離子電導率也可達4 10 - 3s / cm左右，完全能滿足聚合物鋰離子電池的使用需要;機械強度遠遠大於流延法制得的隔膜，達到108 . 84mpa 。
  3. Fire development processes of different combustion models were given and some corresponding parameters were also suggested

    通過給出熱釋放速率、燃燒持續時間和油池火蔓延速度等關鍵參數的計算方法，詳細描述了其發展過程。
  4. Do not incinerate or mutilate batteries, may burst or release toxic material

    14不要燃燒或毀壞電池，可能導致有毒氣體釋放或爆炸
  5. Could be scooped into a methane digester, a device that uses bugs and microorganisms to gobble up the material and emit methane, which would be trapped and burned to power a turbine to make electricity or to heat

    狗糞將被倒入一個沼氣消化池的裝置，然後被蟲子和微生物分解並釋放出沼氣。而這些沼氣被收集起來，燃燒之後可以帶動渦輪發電或者給室內供暖。
  6. Could be scooped into a methane digester, a device that uses bugs and microorganisms to gobble up the material and emit methane, which would be trapped and burned to power a turbine to make electricity or to heat homes

    狗糞將被倒入一個沼氣消化池的裝置，然後被蟲子和微生物分解並釋放出沼氣。而這些沼氣被收集起來，燃燒之後可以帶動渦輪發電或者給室內供暖。
  7. The article put forward an extinguishing method by use of gas and heat obstruction on the surface in oil pools according to the control process of fire continuance and development

    摘要根據油池火災燃燒的持續和發展的控制過程，提出了一種液面氣熱阻隔滅火方法，並針對該滅火方法開發研製了一種阻隔固體浮子及其滅火散料。
  8. The intermediate - temperature sofc ( solid oxide fuel cell ) ’ s electrolyte with perovskite - type lsgm ( la _ ( 0. 9 ) sr _ ( 0. 1 ) ga _ ( 0. 8 ) mg _ ( 0. 2 ) o _ ( 3 - ) ) was synthesized using advanced pechini method and solidification method. the thermal and electrical properties of the sintered samples ( synthesized by two different methods ) were measured and compared by thermal expansion and ac impedance spectroscopy ; the phase transformation process and inner structure were measured and compared by xrd, dta - tg and ac impedance spectroscopy. the research results show that the electrolyte synthesized by advanced pechini method has several advantages, such as fine pre - powders, low sintering temperature, reduced or eliminated impurity phases and high conductivity etc. so, the apm is ideal method to synthesize lsgm

    採用改進的檸檬酸法（以檸檬酸和edta乙二氨四乙酸為復合絡和劑，檸檬酸為燃料）和固相法分別制備了具有鈣鈦礦結構的中溫固體氧化物燃料電池的電解質材料lsgm （ la _ （ 0 . 9 ） sr _ （ 0 . 1 ） ga _ （ 0 . 8 ） mg _ （ 0 . 2 ） o _ （ 3 - ） ） ，用差熱?熱重分析（ dta / tg ） 、 x光衍射分析（ xrd ） 、交流阻抗譜技術（ ac - impedancespectra ） 、比表面積分析（ bet ）和燒結收縮率曲線等手段對產物的熱分解過程、物相轉變和內部結構等進行了表徵，並對由這些粉體燒結而成的固體氧化物燃料電池的電解質材料的電導率進行了檢測。
  9. Closure of pores at elevated temperatures meets the demand for the shut down property in lithium - ion batteries, stops current flow, thereby reducing the risk of ignition and explosion

    在更高的溫度下閉合毛孔的特性符合鋰電池關閉的要求，可停止現行流量，從而減低燃燒和爆炸的風險。
分享友人
分享到 Line

分享到臉書