燃燒空氣 的英文怎麼說

中文拼音 [ránshāokōng]
燃燒空氣 英文
combustion air
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • 燃燒 : (物質劇烈氧化而發光、發熱; 燒) burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  • 空氣 : 1 (大氣) air; atmosphere 2 (氣氛) atmosphere 3 (氣閘) air brake4 pneum ; pneumo ; pneumat ;...
  1. The top - firing air and gas self - preheating hot blast stove adopts a patented burner and high blast temperature bypass flue

    摘要頂、煤自身雙預熱熱風爐採用了頂器熱風爐專利的器技術和高溫旁通煙道技術。
  2. Mechanically actuated combustion air flaps ; safety requirements, testing and marking

    機械操作的燃燒空氣風門片.安全性要求.試驗和標記
  3. Standard for safety for waste oil - burning air - heating appliances

    廢油燃燒空氣加熱設施安全標準
  4. This paper facous on the micro - computer control of the burning furnace system. taking to meet the requirements of the user ' s as basis, it is designed about computer in hardware and software it brings forward a scheme of intelligent & fuzzy - control based on 8098 single - chip micro - computer to get the best proportion of fuel oil and burning air, to realize the auto - contral of the temperature of flue gas in or out the burning furnace. so the accurate efficiency is received, this can ensure the ahf unit having a high production and low costs and energy

    在控制上以滿足新爐型的設計要求為基礎,進行了微機控制的硬體與軟體開發,提出了採用8098單片機進行模糊智能控制的設計方案,實現了料油與燃燒空氣最佳比例控制、爐出口煙溫度控制、爐進口煙溫度控制和安全聯鎖報警控制,提高了爐出口溫度的控制精度和料使用效率,為整個裝置提高產量和降低消耗提供可靠的保證。
  5. Hot waste gas from grate cooler is divided into four parts : part of it is sent to kiln as secondary air, part of it is sent to decomposition furnace as burning air by tertiary duct, and the rest is drained to the atmosphere after purified by electric dust collector at kiln head

    出篦冷機高溫廢一部分作為窯用二次入窯;一部分由三次風管送到分解爐作為燃燒空氣;剩餘廢經窯頭電收塵器凈化處理後排入大
  6. Independent gas - fired convection heaters incorporating a fan to assist transportation of combustion air and or flue gases

    用排扇輔助輸送燃燒空氣和或煙道煤的獨立式混合對流加熱器
  7. In it, studies are carried out such as the combustion theory analysis of biomass briquetting, equipment design, thermal performance test, air flow field test, density field test in the hearth, temperature field test, the dreg characteristics, main design parameters and technological and economic evaluation, and so on. the author has gained all kinds of indexes of the equipment and the changing laws of air flow field, temperature field, density field, dreg and main design parameters. this will lay theoretical foundation on design, operation and technology improvement, meanwhile, this will offer actual guidance for development of equipment

    本文通過對「生物質成型設備設計」 、 「生物質成型設備熱性能試驗」 、 「生物質成型設備流動場試驗」 、 「生物質成型設備溫度場試驗」 、 「生物質成型設備爐膛內體濃度場試驗」 、 「生物質成型設備結渣特性試驗」 、 「生物質成型設備主要設計參數確定試驗」及「生物質成型設備技術經濟評價」等方面的系統研究,獲得了生物質成型設備各項性能指標及燃燒空氣流動場、溫度場、濃度場、結渣性能、主要設計參數變化規律。
  8. The so / sb shutoff regulator is used in the gas line to automatically shut off the fuel when the combustion air or any remote signal pressure drops below a predetermined limit

    Sb切斷閥用於管線自動切斷料,當燃燒空氣或者任何遙控信號的壓力低於預設定極限值。
  9. The smell of burning rubber filled the air

    中彌漫著橡膠味。
  10. This will be dealt with in this paper. the discrimination for noise source from qn700 indicates : the fan noise ( 625hz ), the electromagnetism noise ( 962hz ) and the burning noise are the main noise sources

    對汽車加熱器中具有典型代表結構的qn700型樣機的測試分析表明:風扇噪聲( 625hz ) 、電機噪聲( 962hz )和噪聲是加熱器的主要噪聲源。
  11. Oil - fired air heaters and direct - fired heaters

    加熱器和直接加熱器
  12. Equipment for the purpose of introducing fuel, air, and water, removing products of combustion and control of the entire system

    料、、水的輸送和產物的排出設備以及其控制系統。
  13. Planar laser induced fluorescence ( plif ) was used to study the spray / wall impinging in constant volume vessel. the experimental result show that when fuel spray impinging on the plane wall, wall jet was formed while fuel impinging on a plane wall with a bump, when the wall jet meet the bump, a secondary jet can be formed. some parameters affecting the secondary spray were studied, including bump height, the secondary impinging distance, impinging distance and injector parameters

    對傳統室和bump室內混合過程進行了對比研究,發現油撞壁以後在傳統室壁面形成壁面射流,這一層油濃度很高,很難與混合,而在bump室內,壁面射流遇到bump后,會在間形成二次射流,二次射流進一步能快速與充分混合。
  14. Planar laser induced fluorescence ( plif ) and multi - dimensional cfd software was used to study the fuel - air mixing process in traditional combustion chamber and bump combustion chamber, the experimental and simulated result agree well in room condition. the fuel - air mixing process in high pressure and temperature in traditional and bump combustion chamber were compared. the result show that fuel and air can mix more quickly in bump combustion chamber than in traditional combustion chamber, fuel - air mixture in bump combustion chamber is more homogenous than in traditional chamber

    進一步對高溫高壓下傳統室和bump室內混合好壞進行了對比研究,提出了衡量油與混合好壞的三個指標,發現bump室內油能在更大的體積內與混合, bump室內油比傳統室內油分佈相對更均勻, bump室內油濃度耗散率為傳統室內油耗散率2 . 8倍,能更快與混合。
  15. Independent gas - fired convection heaters incorporating a fan to assist transportation of combustion air and or flue gases ; german version en 1266 : 2002 a1 : 2005

    用電扇助燃燒空氣或煙流動的獨立式對流加熱器
  16. Stationary fan - assisted air heaters ; gas fired air heaters with interchange of heat, requirements, testing

    固定式鼓風燃燒空氣加熱器.帶熱交換的加熱器
  17. B ) applying the multi - fluid model to study premixed combustion in the combustor with the fluid being separated into 11 components, the air / fuel ratio being taken as the dominating attribute

    採用了多流體模型來對室中的預混湍流進行數值模擬,根據混合比把室內的混合體分成11種流體; c
  18. A fire requires fuel to burn, air to supply oxygen, and a heat source to bring the fuel up to ignition temperature

    一把火需要料來來提供氧還有使料到底溫度的熱量。
  19. Revolution control devices for combustion - air control in furnaces ; safety requirements and test

    熔爐燃燒空氣監控器轉數控制裝置.安全性要求和試驗
  20. Non - domestic gas - fired forced convection air heaters for space heating not exceeding a net heat input of 300 kw, incorporating a fan to assist transportation of combustion air and or combustion products

    凈輸入熱量不超過300kw藉助風扇輸送燃燒空氣和或產品的間供暖的家用強制對流加熱器
分享友人