燒焦負荷 的英文怎麼說
中文拼音 [shāojiāofùhé]
燒焦負荷
英文
carbon-burning load- 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
- 焦 : Ⅰ形容詞1 （物體受熱失去水分 呈現黃黑色並發硬、發脆） burnt; scorched; charred 2 （著急） worried;...
- 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
- 荷 : 荷名詞（蓮） lotus
- 燒焦 : charring; scorching; burns
- 負荷 : [電學] load; charge; weight
-
This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation
本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。The combustion - optimizing and automatic control system is being adopted on boiler no. 2 in jiaozuo power plant, successfully realizing the combustion optimizing control of said boiler under constant load and varying load conditions, the on - line combustion debugging test, and the monitoring analysis of operation economic behavior, making the said boiler always to be safe operation with highest efficiency, enhancing averagely the boiler efficiency to more than 0. 5 %, economic benefit being obvious
摘要焦作電廠2號爐採用燃燒優化與自動控制系統，成功地實現了鍋爐定負荷和變負荷過程的燃燒優化控制、鍋爐在線燃燒調整試驗和運行經濟監測分析，使鍋爐時刻在最高效率下安全運行，鍋爐效率平均提高0 . 5 %以上，經濟效益顯著。
分享友人