燒爐用風機 的英文怎麼說

中文拼音 [shāolúyòngfēngjī]
燒爐用風機 英文
stove burner fan
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 風 : Ⅰ名詞1 （空氣流動） wind 2 （風氣; 風俗） practice; atmosphere; custom 3 （景象） scene; view 4 ...
  • 機 : machineengine
  1. Abstract : apply computer simulation to the distribution pattern of air - flow without considering the cold condition of the combustion and compare the flow patterns under different designed circumstances. and the effect of the design of the partition in the air way of the burner on the flow and mixture of gas and air is especially studied. the result shows that the design of partition plays a very important role in strengthening the mixture of gas and air, but increases the loss of the resistance in the air way and the total pressure of the air way in same working conditions needs increasing

    文摘:應用計算機模擬的方法，在不考慮燃燒的冷態情況下，研究了熱風爐燃燒室內的氣流分佈規律.在此基礎上，比較了2種不同設計方案的氣流流動特徵，尤其是研究了燃燒器空氣通道內阻流板的設置與否對空氣和煤氣的流動和混合的影響.結果表明，阻流板的設計對加強空氣和煤氣的混合有著極為重要的作用，同時也增加了空氣管道的阻力損失，在同樣的工況條件下需要提高管道系統的總壓力
  2. Based on the coal burning mechanism in the precalcinator, by analysing all kinds of effect factors and according to the tga result of the anthracite, sinoma international ncdri developed the on - line spout pipe calciner for 5000 t / d production line of china resource cement ( guigang ) ltd., which composed an excellent - performance precalcining system combined with high - efficiency low - resistance and blockingproof cyclone preheater

    基於分解爐煤粉燃燒機理，並通過分析影響爐內煤粉燃燒的各種因素及依據所用無煙煤的熱失重分析結果，中材國際南京水泥設計研究院開發設計出了用於華潤貴港5000t / d工程的噴旋管道式在線分解爐，並與高效、低阻、防堵的旋風預熱系統組成了性能優異的預分解系統。
  3. We offer perfectly matched mechanical, pneumatic and electronic system components for atmospheric and forced - air burner - heater units, condensing burners, forced - air burners, gas - fired motors and industrial, heating production processes and combustion systems

    我們提供最佳的機械氣動和電子控制系統元件，應用於大氣式和鼓風式燃燒加熱裝置冷凝式鍋爐鼓風式燃燒熱燃氣發動機以及工業產品熱工過程和燃燒系統。
  4. Hot waste gas from grate cooler is divided into four parts : part of it is sent to kiln as secondary air, part of it is sent to decomposition furnace as burning air by tertiary duct, and the rest is drained to the atmosphere after purified by electric dust collector at kiln head

    出篦冷機高溫廢氣一部分作為窯用二次空氣入窯；一部分由三次風管送到分解爐作為燃燒空氣；剩餘廢氣經窯頭電收塵器凈化處理後排入大氣。
  5. Via the analysis of heat balance computation model and the computation of online heat balance for industrial coal boiler, this dissertation researched overall input heat, efficient utilized quantity of heat, heat losing of discharge flue gas, heat losing of chemistry and mechanism incomplete combustion, heat losing of dispelling heat of boiler, heat efficiency, air superfluous coefficient, wind speed, wind quantity, computation of primary air circle cutting and whose influence on boiler combustion efficiency

    本文通過對工業煤粉鍋爐熱平衡計算模型的分析，利用在線熱平衡計算，研究了總輸入熱、有效利用熱量、排煙熱損失、化學不完全燃燒熱損失、機械不完全燃燒熱損失、鍋爐散熱熱損失、熱效率、空氣過剩系數、風速、風量及一次風切圓計算以及這些因素對鍋爐燃燒效率的影響。
  6. A combustion model has been built and burning process has been simulated by computer in blast furnace stove with ceramic grid - burner

    摘要建立了高爐熱風爐燃燒數學模型，應用計算機模擬研究方法對中空柵格陶瓷燃燒器的火焰形態進行了模擬研究。
  7. Then a self - searching optimal control method for enhancing thermal efficiency is obtained through the optimal wind - coal ratio. then a computer control system for economic combustion in coal - fired boiler is designed

    通過實現燃煤鍋爐最佳風煤比，得出提高鍋爐熱效率的自尋優控制方案，設計出了用於燃煤鍋爐經濟燃燒的計算機控制系統。
  8. In this article, analysis is made on some problems which must be faced when plasma ignition technology is applied in 600mw unit boiler to achieve a power plant without oil, such as plasma burner disposal, the number of plasma burner, the boiler ignition coursing satisfy the temperature needs, pulverized coal origin, hot air origin, and reconstruction solutions are proposed

    本文詳細分析了某廠2 600mw機組鍋爐採用等離子點火技術實現無燃油電廠所面臨的等離子燃燒器的布置、等離子燃燒器層數的選擇、鍋爐點火啟動滿足升溫速度的要求、煤粉的來源、熱風的來源等問題，並提出了相應的解決方案。
  9. Reburning technology is a valid method. this paper focuses on nox - emission problem of traditional units with hot air transferring pulverized coal. the main technical route of this paper is to use the pulverized coal contained within tertiary air to reduce the nox emission as the reburning fuel

    本文主要是針對傳統的缺少有效降低no _ x方法的熱風送粉機組進行研究，通過對制粉系統和燃燒器的改造與調整，利用三次風中的含粉作為再燃燃料送入爐膛，實施再燃燒以降低no _ x的排放。
  10. Based on practical engineering, the multi - tangential firing technology and the variance perimeter wind technology were introduced in this paper too. from the practical point of view, in this paper, we state the application of multi - tangential firing technology to setting the high temperature corrosion of the water wall tubes of boiler

    本文對鍋爐水冷壁高溫腐蝕有關機理、影響因素以及預防措施作了詳盡的論述，並結合工程實際，詳細介紹多切圓燃燒技術以及變異周界風技術，從實踐角度介紹多切圓燃燒技術在解決鍋爐水冷壁高溫腐蝕中的應用。
  11. In this paper, two 50t / h coal - fired boilers " burning control system of 26 # heating station was studied as its thesis, the primary pid controller was improved as its purpose, fuzzy control theory developed rapidly at present was applied as its means. the design scheme is that controlling transducers change rotate speed of supplying coal electromotor, fan, and blower using 8051 micro - controller. it realized computer control of burning process

    本文以26 ~ #供熱站的2臺50t / h燃煤鍋爐的燃燒控制為課題，以改進原有pid控制為目的，以當前發展比較迅速的模糊控制理論為手段，提出了採用8051單片機控制變頻器改變給煤機、引風機和送風機轉速的設計方案，實現了燃燒過程的計算機控制。
分享友人
分享到 Line

分享到臉書