燒結裝料 的英文怎麼說
中文拼音 [shāojiēzhuāngliào]
燒結裝料
英文
sinter burden-
Among the ways that motorists have made this clear : spraying the cameras with paint ; knocking them over ; covering them in festive wrapping paper and garbage bags ; digging them up ; shooting, hammering and firebombing them ; festooning them with burning tires ; and filling their casings with self - expanding insulation foam that, when activated, blows them apart
駕車者的下列行為清楚地表明了這一點:給相機噴灑顏料;撞倒相機;用喜慶的包裝紙和垃圾袋將它們蓋住;把相機挖出來;用槍射擊、用錘子砸和用燃燒彈炸;用燃燒的輪胎在上面結彩;將自身膨脹的絕緣泡沫塞進相機外殼,一旦泡末膨脹起來,能將相機撐開。Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )
本研究以武裝直升飛機防護裝甲材料為研究對象,採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料,結合其力學性能、掃描電鏡和界面微區能譜分析結果,分析了sic _ p al復合材料的真空燒結過程中的界面現象,以及材料增強和斷裂機理,並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態(應變率為3 . 3 10 ~ ( - 3 ) s ~ ( - 1 ) 5 . 2 10 ~ 3s ~ ( - 1 ) )的壓縮破壞響應進行了研究,分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下,材料的變形和微觀損傷機理,以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. , if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios
文摘:在某些廢鋼熔煉過程中,當爐料中含碳及碳氫物質且燃燒不充分時,會帶來煙氣中一氧化碳的燃爆、油污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含油廢鋼在加熱過程中煙氣成分隨時間的改變以及二次燃燒率的變化,試驗結果表明,反應過程的限制性環節是油分的熱分解;在較低的溫度下( co ) / ( co2 )比例影響轉化率和二次燃燒率;而在任意比例下保證充分反應的溫度為900以上For the sake of realizing compressive ignition of single fueled natural gas and aiming at the characteristics of high spontaneous combustion temperature of natural gas, the separated combustion chamber provided with low heat radiation structure was designed, meanwhile the heating device for the intake pipe air and the ceramic electro - thermal plug heating device inside the separation chamber were set up
摘要為實現單一燃料天然氣的壓燃著火,針對天然氣自燃溫度高的特點,設計了具有低散熱結構的分隔式燃燒室,同時設置了進氣管空氣加熱裝置和分隔室內陶瓷電熱塞加熱裝置。Structure improvement of the burning bottom layer fan gate
燒結布料鋪底料扇形閘門裝置結構改進To have dewaxing and degreasing systems, the bond in sintering materials can be removed efficiently
配置脫蠟脫脂裝置,可有效去除燒結材料中的粘合劑等成分。Abstract : enhancing function of pulsating draught for sintering process is studied with simulative burden in the laboratory. the experiment results indicate that sintering velocity is the fastest along with appropriate pulse draught frequency when negative pressure is lower
文摘:採用模擬原料,在試驗室內的脈動燒結裝置上,進行脈動氣流燒結試驗,探討了脈動氣流的頻率變化和抽風負壓等因素對燒結過程的強化作用The new requirements for applications in material surface engineering urge a new type of hipib apparatus, for instance, the generation of medium - power - density ion beam, high - stability ion beams and long - lifetime ion source etc. therefore, characterization of high power ion diode - magnetically insulated ion diode ( mid ), the key issue for the technique development, is considered in this dissertation. the investigations of hipib generation and its mechanisms have been carried out in a temp - 6 hipib apparatus, in order to optimize the configuration of ion diode and its ion beam parameters for materials surface treatments
針對強流脈沖離子束( hipib )技術研發的關鍵環節?高功率離子二極體(磁絕緣離子二極體)的工作特性,在temp - 6型hipib裝置上開展了hipib產生及其形成機理的實驗研究,確定了優化的離子二極體結構和輻照工藝參數;通過hipib輻照金屬材料燒蝕行為的系統研究,揭示了燒蝕表面形貌的形成規律,為徹底弄清hipib與材料相互作用機理提供了實驗依據。Abstract : this paper gives a summary of raw material, production cap acity, output, product variety, product quality, main uses, as well as production technology, equipment, inidustrial situation, overseas and domestic markets and development prospects of permanent neodymium ferroboron magnet
文摘:綜述了我國燒結釹鐵硼的生產原料、生產能力、產量、產品品種、質量及主要用途,生產技術、裝備及產業化狀況,產品的國內外市場及發展前景。Nhi mainly provides research and development, design, manufacturing and services of the significant technology equipments of crushing & grinding, ore dressing, metal rolling and dressing shearing, tunnel boring, bulk material transporting and handling, synthetic excavating, construction machinery, transmission machinery, particle board, environmental protection and military and large castings and forgings for metallurgy, mining, coal, power, building material, port, chemical industry, environment industries
簡介:北方重工主要為冶金、礦山、煤炭、電力、建材、港口、化工、工程、環保等行業提供破碎粉磨、礦物洗選、燒結球團、金屬壓延和精整剪切、隧道掘進、散料輸送和裝卸、煤礦綜采、工程機械、傳動機械、人造板、環保、軍工等重大技術裝備及大型鑄鍛件的研發、設計、製造和服務。Sealing materials for metallic threaded joints in contact with 1st, 2nd and 3rd family gases and hot water - unsintered ptfe tapes
第1 , 2 , 3類家庭用燃氣和熱水裝置連接的金屬螺紋接頭的密封材料.非燒結ptfe密封帶Shanghai asiahope trade co., ltd their subordinate of the ceramics factory, devoted to developing the modern ornament materials ; pursue natural art is combined with the new concept of the modern life, found and smelt the ceramic brick of crystal inferiorly, one layer of complete hand mades of surface crystal of the brick, after the high temperature is fired, the surface of the brick does not have regular crystal crackle to produce naturally, the products have more than more than ten seed colors, is suitable for hotels such places as the hall and top - grade bar, swimming pool, bathroom, entry wall, kitchen, sitting room background wall, etc., deep since smelting brands and appearing on the market inferiorly welcomed by the market
上海遜豪貿易有限公司其下屬擁有自己亞冶陶瓷廠,致力於研製現代裝飾材料,追求自然藝術與現代生活新概念結合,所締造亞冶水晶陶瓷磚,磚的表面水晶層完全手工製作,經高溫燒制后,磚的表面產生自然無規則的水晶裂紋,產品有十幾余種顏色,適用於酒店大廳和高檔酒吧,游泳池、浴室、玄關墻、廚房、客廳背景墻等場所,亞冶品牌面市以來深受市場歡迎。Abstract : the problems exist in the mixing drum scraper device of shaogang sintering plant were analyzed, and the new structure of subsection and demountable scraper was presented
文摘:分析了韶鋼燒結圓筒混合機刮料裝置存在的問題,介紹了刮料裝置改成分段可拆卸式結構及取得的效果。分享友人