燒結鋁 的英文怎麼說

中文拼音 [shāojiēlǚ]
燒結鋁 英文
sintered aluminium
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 鋁 : 名詞[化學] aluminium （13號元素, 符號al）
  1. Widely employed in coal mine, downhole coal bunker, coal washery, cement factory, foundary, thermal power plant, sintering plant coal gas factory, fertilizer plant, chemicals plant, aluminium plant, alkali factory, steel works, coking plant, pharmaceutical factory, mine, dock, foodstuff, and feedings process works, concrete process, etc. with bunker, hopper, transmitting pipeline and drawshaft

    廣泛用於煤礦、及井下煤倉、洗煤廠、水泥廠、鑄造廠、火力發電廠、燒結廠、煤氣廠、化肥廠、化工廠、鋁廠、制堿廠、鋼鐵廠、焦化廠、制藥廠、礦山、碼頭、糧食、飼料加工廠、混凝土加工廠等擁有料倉、料斗、輸送管道和礦山溜井的廠礦企業。
  2. The formation of new phase such as mullite and gahnite by solid - phase reaction in multiphase materials can benefit the sintering of materials at 1700, decreased apparent porosity to less than 5 %. reducing atmosphere inhibited the synthesis of mullite and gahnite, played a negative role in the densification of multiphase materials

    固相反應生成的鋅鋁尖晶石和莫來石具有較高的活性，使復相材料在1700燒后顯示出更好的燒結性能，其顯氣孔率降低到5以下；還原性氣氛阻礙了莫來石和鋅鋁尖晶石的生成，不利於復相材料的燒結和緻密化。
  3. Study on the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process using kaolinite as raw material showed that impurities introduced by kaolinite mainly increased the liquid amount at high temperature, which can assist sintering of specimen. the experiment results indicated that the samples with lower gahnite content had better sinterability than others. however, if the gahnite content was relative high, the promoting effect on sinterability caused by kaolinite was not significant

    採用天然原料高嶺土二步煅燒合成剛玉?莫來石?鋅鋁尖晶石復相材料研究發現：天然原料中帶入的雜質主要是增加液相量，促進高溫下試樣的燒結；當尖晶石含量較低時，試樣在1300保溫2h時，在1600燒后試樣燒結性能相比之下較好；而當鋅鋁尖晶石含量較高時，天然料對試樣的促燒作用不是非常明顯。
  4. Study on the synthesis of corundum - mullite - gahnite multiphase materials by one - step sintering process using high purity raw materials showed that the more the content of gahnite in multiphase materials, the high the volume expansion would be introduced in the system, which resulted in the sintering difficulty of the multiphase materials. while the content of gahnite was controlled about 30wt % and the content of mullite was about 70wt %, the densified multiphase materials can be obtained after fired at 1600 or 1700

    採用高純原料一步合成剛玉?莫來石?鋅鋁尖晶石復相材料研究表明：復相材料中鋅鋁尖晶石含量越高，則合成鋅鋁尖晶石時產生的體積膨脹越大，燒結性也就越差；當鋅鋁尖晶石含量為30wt ，莫來石含量較高為70wt左右時，在1600或1700燒后都能得到顯微結構較為緻密的復相材料。
  5. Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )

    本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。
  6. Based on the analysis of the characteristics of the raw mix slurry preparing process in alumina sintering production process, firstly, a mechanism model based on material balance principle was established as the master - rule model for the quality prediction ; secondly, considering the problem that the alkali liquor composition was unstable and its real - time measurement was difficult, a nn ( neural networks ) prediction model for the prediction of the alkali liquor composition was set up and nesting - integrated with the mechanism model ; finally, using the gray theory for the information mining from the errors of the mechanism model, a gm ( 1, 1 ) compensation model was put forward and parallel - connection - integrated with the mechanism model, achieving a raw mix slurry quality prediction model

    摘要針對燒結法氧化鋁生產過程中生料漿配料工藝的特點，根據物料平衡的原理建立機理模型，作為生料漿質量預測的主規律模型；針對堿液成分波動大且難以實時檢測的問題，對堿液成分含量建立了神經網路預測模型，並和機理模型進行嵌套集成；利用灰色理論對機理模型的偏差數據進行信息挖掘，建立了gm （ 1 ， 1 ）補償模型，並與機理模型進行並聯集成，獲得生料漿質量預測模型。
  7. Available standard ma - spinel bricks differ mainly in the type of magnesia and in the amount and type of their alumina carrier ( sintered and fused ma - spinel ， calc. alumina ， white fused alumina ， etc

    目前各種標準的鎂鋁尖晶石磚主要在氧化鎂的數量、種類和它們鋁載體的種類（燒結和電熔鎂尖晶石、鈣，氧化鋁，白電熔等）方面有很大的不同。
  8. But it also includes two fatal disadvantages : first, at is difficult to be sintered and its density is low, which causes its lower strength ; second, in the temperature range of 1023 - 15 73 k, at can decompose into al2o3 and tio2 easily, which can cause the stress concentrated and raise the heat expansion rate

    但是該材料本身存在的兩大致命的缺點，在很大程度上限制了它的廣泛應用： （ 1 ） 、鈦酸鋁難以燒結，燒結體的緻密度低，因而強度不高； （ 2 ） 、在750 1300的溫度范圍內易分解成氧化鋁和二氧化鈦，造成材料內部應力集中，並使材料的熱膨脹率升高。
  9. Effects of heating rates on the sintering behaviors of alumina powders

    升溫速率對氧化鋁粉末燒結行為的影響
  10. Case and the shift fork all adopt the aluminum alloy, part of components adopt the sinter material, which realize the light

    殼體、換檔撥叉全部採用鋁合金，部分零件採用燒結材料，實現產品輕量化。
  11. The density of the al bulk nanomaterials is only 75 percent of mat of normal ordinary coarse crystallized counterparts, which means there are a lot of holes or loosen structure in the nano - bulk al

    通過模壓成形的納米金屬鋁和銅的塊體的密度只有普通體材料密度的75左右，表明得到的未經燒結的納米鋁塊體內部可能還存在很多孔隙或很多疏鬆的組織。
  12. Synthesis of magnesia alumina spinel refractories by reaction sintering

    反應燒結法合成鎂鋁尖晶石耐火材料
  13. In the alumina process with sintering, the slurry comes out from the grind with low quality because of lots of uncertainty factors and the delay of composition analysis, the qualified raw mix slurry is commonly gained through arranging

    摘要由於燒結法氧化鋁配置生料漿過程中不確定性因素多，成分分析滯后，造成生料漿出磨合格率低，一般需經調配使生料漿質量指標符合工藝要求。
  14. The quality is a burnt magnesia spinel brick made from fused magnesia ， low iron sintered magnesia and fused hercynite. this synthetic hercynite is a patent by rhi refractories

    它由電熔鎂砂、低鐵燒結鎂砂和電熔鐵鋁尖晶石製成的燒結鎂鐵尖晶石磚，這種人工合成的鐵鋁尖晶石是rhi奧鎂公司的專利。
  15. The micromorpholgy and grain boundary microstructure of the material were studied with sem and tem and the grain boundary phase composition were analyzed with eds and x - ray the mechanical properties, micromorpholgy microstructure of grain boundary and phase composition of al2o3 composite ceramics were systematically studied, the effect of additives, the relationship between microstructure and mechanical strength, the sintering mechanism of the material and influence factors of the structure and properties of al2o3 composite ceramics were discussed respectively

    系統研究了氧化鋁陶瓷的力學性能、微觀形貌、晶界顯微結構，並討論了各添加組分的作用、材料顯微結構與力學性能的關系以及材料的燒結機理和影響材料結構與性能的影響因素。本論文探討了氧化鋁基復相陶瓷的強韌化機理，實驗表明al _ 2o _ 3 - ticn體系主要是微裂紋韌化。
  16. The process of organic vehicle evacuation of aln green tape and ag conductor paste have been researched in the view of ltcc technology, and optimum condition of organic vehicle evacuation temperature and cofiring atmosphere have been determined

    摘要從低溫共燒的工藝角度來研究氮化鋁坯片和銀漿的排膠，從而確立排膠的溫度及燒結氣氛的控制。
  17. This article studies the main factors, which affect the extract ratio of aluminum oxide from lean alumina ore, such as the ratio of raw material, particle size, broiled temperature, and broiled time

    摘要探討了原料配比、粒度以及配料燒結溫度、時間等工藝因素對貧鋁礬土中氧化鋁的提取效率的影響。
  18. Standard specification for sintered aluminum structural parts

    燒結鋁結構部件標準規范
  19. Apmp aluminium powder metallurgy product

    燒結鋁粉製品
  20. Sintered ainico bxh ximgoe

    燒結鋁鎳鈷
分享友人
分享到 Line

分享到臉書