爐氣乾燥 的英文怎麼說

中文拼音 [gānzào]
爐氣乾燥 英文
furnace gas drying
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ名詞1. (八卦之一) qian, one of the eight diagrams2. (姓氏) a surname Ⅱ形容詞(舊時稱男性的) male
  • : Ⅰ形容詞(缺少水分) dry Ⅱ名詞[中醫] (病因) dryness
  • 乾燥 : arefaction
  1. The electrical and gas circuitry for the fullbin dryer is similar in many respects to that of a household furnace.

    整倉機的電路和燃管路在許多方面與生活用相似。
  2. Nc routers, sand blast machines, compressors, glass beads blast machines, coating booths, high power airless coating machines, force feed type large coating machines, conveyor type hot air dryers, fixed type heat treatment furnaces, etc

    Nc刳刨機,噴沙機,壓縮機,玻璃丸噴丸機,塗裝棚,高壓無塗裝機,壓送式大型塗裝機,傳送式熱風機,固定式熱處理
  3. The control system of furnace " s temperature has been widely used in every walk of life, as an important link of repair and manufacture of the electrical equipment such as electromotor transformer etc., soaking lacquer drying craft has some especial requests on drying crafto this article starts with the analysis of drying chamber " s configuration, analyzed its configuration limitation and control function limitation according to the factory " s situation and advances the conception of heated air drying circulation, in addition, this article adopts an intellectualize a / d module, a development sampling tuning - voltage circuit, and presents the method to measure online the insulation resistance of products in order to improve constantly products quality

    而浸漆工藝作為電機、變壓器等電設備的修理、製造中的重要環節之一,對過程的質量要求有一定的特殊性。該文從的結構分析入手,聯繫到工廠的實際情況分析了結構功能缺陷和控制功能缺陷,提出了熱風循環的概念,同時,選擇了較為先進的a d板卡、熱電阻信號調理板等專業化智能卡,運用數字pid控制技術,構成了一個較有特色的計算機控制系統。此外,該文還從保證品質量的角度,採用智能化交流模塊和自製采樣調壓電路的方法,提出了在線檢測產修品的絕緣電阻的方法和手段,以確保企業產品質量不斷提高。
  4. According to finite element segmentation principle, by combining test with observation, the author has measured the air streamline and speed distribution of burning equipment in dally situation, which provides some guide for research of air field in hearth on cold and hot conditions. and the law is found of air speed distribution by measuring its speed and distribution of upper and lower deck on cold condition, thus it lays the foundation for analysis on hot condition. under four burning states, we measure the air speed in single, double - deck, and find out its corresponding distribution law

    5 .根據有限元分割原理布置測點,採用降溫方法,用k五江9106等儀器分別測出單雙排燃燒方式4種不同工況下,該燃燒設備膛內coz 、 02 、 co體濃度,並找到了隨膛高度方向及深度方向變化規律;從燃燒原理分析評價了2種燃燒方式膛內coz 、 02 、 co體濃度場分佈特點及相應燃料層內、干餾、氧化、還原、灰渣層厚度,肯定了雙層排燃燒方式膛中c02 、 02 、 co體濃度場分佈合理性,從燃燒理論找出了最佳濃度場分佈狀態及燃料層內各反應層厚度。
  5. Using the furnace itself to dry the refractory has been reported in some cases but usually the flue gases will be too hot even with the minimum burner tip combination

    有過報道,說有時用加熱自身來耐火磚,但通常煙會太熱(即使燒嘴火嘴組合最小) 。
  6. Standard test method for rubber - deterioration in an air oven

    橡膠的標準試驗方法.在熱空中測定橡膠變質
  7. The temperature of inlet air could be raised by the developed heat recovery device to achieve energy saving

    加熱器的耗油率為4 . 5公升小時,分析進的溫升和流量可得此系統之加熱的加熱效率約為50 % 。
  8. First, based on reading lots of references biomass gasification technology is discussed in detail including the basic principle of biomass gasification, categories and working principle of biomass gasification equipment and ancillary system of biomass gasification in this paper. second, performance calculation modules of sub - systems such as gas turbine, heat recovery steam generator, steam turbine and dryer in the bigcc system are built, especially, performance calculation modules of gas turbine fueling biomass fuel gas based on variable specific heat and biomass dryer are built. in the mean time, program of performance calculation modules for sub - systems is developed using delphi 6. 0

    首先,本文在閱讀大量文獻基礎上對生物質化技術進行了詳細的闡述,主要包括:生物質化基本原理、生物質化設備的種類和工作原理以及生物質化的附屬系統;其次,建立了bigcc系統中各個子系統燃輪機、余熱鍋、蒸汽輪機、器等的性能計算模型,特別建立了基於變比熱的燒生物質燃料的燃輪機性能計算模型和生物質器的性能計算模型,並用delphi6
  9. Suitable for testing differential pressure of dry and non - corrosive gases. normally used in boiler ventilation systems, gas pipes, incendiary devices and other similar equipments

    適用於測量且無腐蝕體的差壓壓力。一般應用在鍋通風設備,體管道,燃燒裝置及其它類似設備上。
  10. There are two drying furnaces in electric company of panzhihua iron & steel co., which were employed for drying the windings of motor, transformer and other electrical equipment in order to satisfy the insulating performance and intensity requirement of works

    攀鋼電公司有兩臺,用於電機、變壓器及電器線圈等產修品,以滿足工件的絕緣性能和強度要求。
  11. In technical aspect, changing the sealed furnace into heat - air circulation structure, it makes the temperature of the drying works be average, the humidity is got rid of in time which affecting the quality of the product

    在工藝上,將原封閉的結構改為熱風循環結構,這樣有利於改善原物品在內溫度不均勻、潮不能及時排除等情況而影響產修品質量。
分享友人