特徵位錯 的英文怎麼說

中文拼音 [tèzhǐwèicuò]
特徵位錯 英文
characteristic dislocation
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 徵 : 名詞[音樂] （古代五音之一 相當于簡譜的「5」） a note of the ancient chinese five tone scale corre...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 錯 : Ⅰ形容詞1 （錯誤; 不正確） wrong; mistaken; erroneous 2 （用於否定: 壞; 差） bad; poor 3 （交叉; ...
  • 特徵 : characteristic; feature; properties; aspect; trait
  1. The writer of this paper, beginning from the establishment of standard, thinks that, based on the phoneme of mandarin chinese and ipa, errors and defects should be judged from the phoneme and non - distinctive features

    本文從標準的確立談起，認為錯誤和缺陷要以普通話音位和國際音標為基礎，從音位和非區別性特徵上進行判定。
  2. Presents the microstructure evolution in aluminum a nd copper after deformation by cold rolling in the strain range of 10 to 50 % red uction using tem and points out three types of dislocation structures are typica l and two of them are common for both materials and these two common types are f ound in non - cube grains and can be distinguished by crystallographic orientatio n of dislocation boundaries in the grains and the third type of structure is obs erved in cube grains, and concludes that grain orientation is important in deter mining the structure type but some other metallurgical parameters also have a ro le to play

    採用tem對冷軋多晶銅與多晶鋁的形變顯微組織演變進行了對比研究.結果發現：多晶銅及多晶鋁形變顯微組織中均含有三類典型的位錯結構類型，其中的兩種結構特徵在兩種材料中是相似的，這兩種類型結構存在於非立方取向晶粒，可通過晶粒中位錯邊界的晶體學取向加以區別，另一類型結構存在於立方取向晶粒；晶粒的晶體學取向決定了其形變顯微組織類型，但其它冶金學因素對顯微組織也有影響
  3. This paper, based upon a careful analysis of the expressive and stylistic traits of political texts, expounds the orientation, general criterion and five basic principles in translation of political texts, and furthermore this paper, by way of exemplification, discusses the five types of errors to be easily made in translating practice of political texts

    通過細致探討政論語言文體特徵，對政論翻譯定位、總體策略及五大基本原則加以歸納論述，並進一步就政論翻譯實踐中五類易犯錯誤問題進行例證分析。
  4. Under the careful retrospection and analysis on the previous and recent experiments about mechanical behavior of nanocrystalline metals performed by almost main investigators, the dislocation and atomic diffusion is believed to contribute hardly to the deformation of nanocrystalline alloy, and a model based on thermal activation process was applied to fit the experimental data of nanocrystalline ag

    結果表明，納米晶金屬ag的不僅具有比粗晶ag高2 - 6倍的拉伸和壓縮強度，而且在大范性形變階段顯示了極低的加工硬化和應變速率敏感性。結合位錯理路和非晶合金形變特徵，提出納米晶金屬ag的塑性變形主要由於晶界滑移貢獻。
  5. From an examination of the tensile behavior of cz ly12 alloys under different temperature and strain rate, two kinds of deformation and intergranular fracture behaviors were observed that were opposite to the characteristic strain rate range in fine - grained superplasticity. the mechanisms are described as follows. the high ductility achieved at high strain rate is generally attributed to the dominant role of gbs accommodating mechanisms, which is considered as dislocation creep within grains controlled by subgrains

    研究選用自然時效淬火態的ly12鋁合金，進行了一系列不同溫度和應變速率下的單軸拉伸試驗， 480下，觀察到與傳統細晶超塑性特徵區間相反的行為：較高應變速率下，動態再結晶使晶粒細化，促進了晶界滑移，亞晶界控制的晶內位錯蠕變是晶界滑移的主要協調機制。
  6. Dc has two attractive characteristics : ( 1 ) dc can make genes in a chromosome keep good diversity. dc overcomes the evil of traditional crossovers, which cause gas get into prematurity. ( 2 ) dc well reduces algorithms " generations by guiding them to search in global optimal ' s neighborhood space

    通過對交叉運算元產生新個體的機理以及實際問題的特徵進行分析后，本文提出一種基於非等位基因交叉運算的錯位交叉運算元，該運算元的主要優點在於： （ 1 ）能夠使種群個體的基因值更加有效地保持多樣性，克服傳統交叉運算元下演算法易於陷入局部最優解的缺陷； （ 2 ）引導遺傳演算法在最優解鄰域內搜索，從而提高演算法的優化速度。
  7. Since the real - time image and norm image shoot height, orientation and image size are different, the two image ' s outline exist rotation and distortion, and so obtained image ' s edge character is influenced by picture ' s gray distribution, so that the match result is usually not correct

    摘要下視景像匹配製導中，實時圖和基準圖的拍攝高度、方位和圖像比例尺不完全一致，兩圖的輪廓形狀存在旋轉和變形等差異，邊緣特徵提取方法受圖像灰度分佈影響存在變形和移位，易導致匹配錯誤。
  8. Then, we proposed a new qos protocol, qgr, based on the greedy geographic routing and dynamic source routing. qgr protocol searches the best route for the packet using energy 、 packet delay and bit error rate of manet as qos parameter

    Qgr協議是一種qos路由協議，以傳感器網路的能量、延遲、位錯誤率等特徵作為qos參數，實現相對于某一種參數最優的路由路徑的查找。
  9. The profound question existing in the current schooling in china is the overlook to the individual life, and the reform on schooling shows the characteristics of segregation and superficiality the statu quo that reflects the great dislocation between value - direction and transition challenges us to have a theoretical study on value - direction in schooling in china

    當代中國現有學校教育的深層次問題正是在於對個體生命的忽視，而現有的學校教育改革又體現出分散和流於表面的特徵。這種現狀體現出價值取向與時代轉型間的巨大錯位，迫切需要進行認真的理論研究，以合理地重建當代中國學校教育的價值取向。
  10. On the basis of the principle of unbalanced legislation to protect the weak, this article presents a systematic research on the liability for the breach of labor contracts, which may apply a historical analysis, standard analysis as well as comparative research. chapter 1 probes into the definition of the liability for the breach of labor contracts and its characteristics, its common characteristics and its special characteristics. chapter 2 discusses the classifications of the liability for the breach of labor contracts : the employer " s liability for the breach of labor contracts and the labor " s liability for the breach of labor contracts or the primary liability for the breach of labor contracts and the subordinated liability for the breach of labor contracts, which may play the special and significant role in the liability for the breach of labor contracts. chapter 3 mainly discusses the constitutive requirements of the liability for the breach of labor contracts, which have a unbalanced character. the character is mainly reflected in fault. in general when the laborers break the contracts, we should apply the doctrine of liability for wrongs, while the employers, the doctrine of no - fault liability

    本文從「傾斜立法，保護弱者」的觀念出發，運用歷史考察、比較研究和規范分析等多種方法，對勞動合同違約責任的基本理論問題作了較全面系統的研究。第一部分探討了勞動合同違約責任的概念及其特徵，重點分析了勞動合同違約責任的特有特徵：傾斜性特徵和（可能）重合性特徵；第二部分論述了在勞動合同違約責任中具有特殊意義的分類? ?用人單位的違約責任、勞動者的違約責任與違反主給付義務的違約責任、違反附隨義務的違約責任。第三部分研究了勞動合同違約責任的構成要件，著重論述了勞動合同違約責任的構成具有不平衡性的特點，此特點體現在過錯要件中，一般說來，勞動者違約時，應采過錯責任原則；用人單位違約時，應采無過錯違約原則。
  11. Chinese ancient science and technology characteristic is to take technology seriously and look down on theory. why ? because the ones who embarked on science and technology should n ' t be such ones ; and that is the result of official - centered, or that is to explain chinese ancient science and technology ca n ' t evolve into the early modern science and technology

    本文力圖從官本位這一獨特視角揭示中國古代科技特徵形成的原因，中國古代科技特徵是重實用輕理論，技術成分多於理論成分，形成這種特徵是古代科技主體錯位的原因使然，而科技主體錯位的原因又是官本位的必然結果。
  12. Lastly, the teacher ' s teaching philosophy is independent, situated synthetic, developing and inconsistent as it is functioning

    最後，教師教學哲學在其具體運作中呈現出下述特徵：獨立性、情境性、綜合性、發展性和錯位性。
分享友人
分享到 Line

分享到臉書