現澆混凝土 的英文怎麼說

中文拼音 [xiànjiāohúnníng]
現澆混凝土 英文
cast-in-place concrete
  • : Ⅰ名詞1 (現在; 此刻) present; now; current; existing 2 (現款) cash; ready money Ⅱ副詞(臨時; ...
  • : 澆名詞(姓氏) a surname
  • : 混形容詞1. (渾濁) muddy; turbid2. (糊塗; 不明事理) foolish; stupid
  • : 動詞1. (凝結) congeal; curdle; coagulate 2. (注意力集中) fix
  • 混凝土 : concrete; beton; jetereting混凝土壩 concrete dam; 混凝土板 concrete slab; 混凝土標號 concrete gra...
  1. Crack - control of aeolotropic hollow slabs in orthogonal in - site concreting deck floors in the construction of large - pillar - net structure of reinforced concrete

    大柱網現澆混凝土框架正交異性空心大板樓蓋的裂縫控制
  2. The monitoring of cracks of floor slab at construction stage

    現澆混凝土樓板裂縫的施工階段試驗研究
  3. Safety appraise and handle methods of insufficient in - situ concrete floor slab ' s thickness

    現澆混凝土樓板厚度不足的安全鑒定及處理方法
  4. The site concrete pump is designed for a delivery rate of 87 m3 / h and maximum pumping pressure of 100 bar

    "現澆混凝土泵設計的輸送速度為87立方米/小時,最大泵送壓力為100巴。
  5. As a new foundation improvement technology, the cast - in - situ concrete thin - wall pipe pile ( pcc pile ) is applied widely in the construction of the highway, civil architecture, haven and sea embankment etc. the pcc pile has a great prospect because it has superiority in the treatment of soils, such as construction period, cost and environment protection

    現澆混凝土薄壁管樁(簡稱pcc樁)及其復合地基是一種全新的地基處理新技術,已應用於高速公路、民用建築、港口、海堤等工程建設中, pcc樁在處理效果、工期、造價、環保等方面具有較大的優越性,因此在地基處理中具有廣闊的應用前景。
  6. Firstly, for the system of moulding board and support frame in construction the side pressure and screws are analyzed. the material and structure form of support frame are discussed. the design of support frame uses the method of limited state, and also it analyses the integer stability, part stability, and single stability, and then proposes the load analysis of multi - level support frame

    首先,針對轉換層梁模體系及支撐架施工,重點分析了轉換層結構現澆混凝土對模板側壓力值及模板對拉螺桿的計算;討論了轉換層支撐體系的形式及構造,詳細論述了基於極限狀態設計的支撐架計算方法,包括縱橫向水平桿的強度驗算、立桿的整體穩定性、局部穩定性、單肢桿件穩定性等驗算,並提出了多層支撐架的施工荷載計算方法。
  7. The method for design thin - wall core box cast - in - site concrete hollow floor using common structural computing software is put forward and the scale for the magnifying stiffness coefficient of the spandrel beam and middle beam is discussed

    5 、提出了採用常用的結構計算軟體計算薄壁箱體現澆混凝土空心樓蓋設計的方法,提出了邊梁和中梁剛度放大系數的建議。
  8. This thesis set forth its position on cast - in - place r. c. slab ' s cracks while pointing out the important meaning on research slab ' s non - loaded cracks

    本文對現澆混凝土樓板裂縫進行一些闡述,指出了樓板非荷載裂縫研究的重要意義。
  9. Thin - wall core box cast - in - site reinforce concrete hollow floor is a new type floor in which high strength thin - wall core boxes were laid as the certain rule

    薄壁箱體現澆混凝土空腹樓蓋板柱體系是一種在現澆混凝土樓板中按規則布置一定數量的永久性剛性薄壁箱體而形成的新型空心樓蓋體系。
  10. The results of the research indicate that the assembled highway bridge steel truss is an effective means to resolve the common problems of falsework over river for construction of cast - in - situ prestressed concrete continuous girders

    研究表明,採用裝配式公路鋼橋桁架解決跨河預應力連續梁現澆混凝土施工支架問題是有效的。
  11. Technical specification for cast - in - situ concrete hollow floor structure

    現澆混凝土空心樓蓋結構技術規程
  12. Cast - in - situ concrete hollow floor structure has been widely used all over the country

    現澆混凝土空心樓蓋結構在我國已得到廣泛應用。
  13. Cast - in - site concrete hollow floor has been used widely in china. but its design method is not very mature

    現澆混凝土空心樓蓋是一種新型結構,在我國已得到廣泛的應用,但它的設計計算方法還很不成熟。
  14. 3. the ultimate bearing capacity of such floor is worked out by applying yield line theory to thin - wall core box cast - in - site concrete hollow floor. and it is proved to be feasible according to the theoretic analysis

    3 、將板的屈服線理論引入薄壁箱體現澆混凝土空心樓蓋的極限荷載的計算中,根據理論分析,證明了該方法的可行性。
  15. According to author ' s practical experience accumulated in many years of water project construction, the author gives brief description to some common quality defects in cast - in - site concrete construction, such as honeycomb, ballast - surface, holes, reinforcement emerging, crack, surface unevenness, insufficient strength etc

    根據在水利水電工程施工中多年積累的實踐經驗,簡要闡述了現澆混凝土施工中常見的一些質量缺陷,如蜂窩、麻面、孔洞、露筋、裂縫、表面不平整、強度偏低等。
  16. 4. the elementary analysis about the geometrical parameter influences of plate thickness and breadth of rib beam on mechanical properties of the thin - wall core box cast - in - site concrete hollow floor is also made. a single geometrical parameter on mechanical properties of such floor system is set forth and the fitting scale for these parameters is determined to provide the reference when designing

    4 、對影響薄壁箱體現澆混凝土空心樓蓋內力和變形的板邊梁寬度、肋寬、肋間距、板厚等因素進行了分析,討論了單一幾何參數對該樓蓋受力性能的影響規律,提出這些參數適宜取值范圍,為對這種樓蓋進行設計時提供參考。
  17. Construction technology of strengthening soft foundation by cast - in - situ concrete thin - wall tubular pile

    現澆混凝土薄壁管樁加固軟地基技術
  18. In situ concrete lining

    現澆混凝土襯層
  19. Cast - in - site concrete construction is often used in water project

    摘要水利水電工程中通常採用現澆混凝土
  20. An analysis on quality in construction of poured - in place concrete box girders

    現澆混凝土箱梁施工質量淺析
分享友人