環形模隙 的英文怎麼說

中文拼音 [huánxíngmóxì]
環形模隙 英文
annular gap
  • 環 : Ⅰ名詞1 （環子） ring; hoop 2 （環節） link 3 （姓氏） a surname Ⅱ動詞（圍繞） surround; encircle;...
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 隙 : 名詞1 （縫隙; 裂縫） crack; chink; crevice 2 （空閑） gap; interval 3 （漏洞; 機會） loophole; op...
  • 環形 : annular; ringlike; ring form; bight; annularity環形癌 annular carcinoma; 環形電路 [訊] loop circu...
  1. In this article, according to heat conduction theory, elastic creep theory and finite element theory, the temperature field and creep stress field in the arch dam during construction and operation are simulated and analyzed by means of three dimensional finite element relocating mesh method, and the distribution law of the temperature field and creep stress field in the arch dam during construction and operation are systematically studied, and according to the construction process of concrete arch dam, the effect of lamination placement, construction interval, elastic modulus change, thermal insulation change, surrounding temperature change, concrete creep and autogenous volume change on thermal stress in the arch dam are also considered

    論文根據熱傳導理論、彈性徐變理論及有限元理論，用三維有限元浮動網格法對拱壩施工期和運行期溫度場、徐變應力場進行了全過程模擬分析，較為系統的研究了混凝土拱壩施工期和運行期溫度場、徐變應力場的分佈規律，在分析中按照混凝土拱壩施工過程，考慮了混凝土分層澆築、施工間隙時間、彈模變化、絕熱溫升過程、環境溫度的變化、混凝土徐變、自生體積變形等因素對壩體溫度應力的影響。
  2. In this paper, the influence of cycles of drying and wetting on strength and deformation are studied by means of routine direct shear apparatus, triaxial apparatus and light consolidation apparatus which include : the influence of force of constraint on strength, the total stress strength of expansive soils with different saturation degree, the influence of cycles of drying and wetting on the total stress strength, the relation between saturation degree and compression modulus and that between saturation degree and void ratio, the influence of cycles of drying and wetting on the effective stress strength, the relation between saturation degree and generalized suction

    本文利用常規直剪儀、三軸儀以及輕便固結儀，分別對非飽和膨脹土的強度和變形特性以及干濕循環對強度和變形的影響進行了一系列的試驗研究。以飽和度、干濕循環次數為變量，分別探求了外力約束對膨脹土強度的影響，不同飽和度膨脹土的總應力強度特性，干濕循環對非飽和膨脹土總應力強度的影響，飽和度與壓縮模量以及孔隙比的關系，干濕循環對飽和膨脹土有效應力強度指標的影響，廣義吸力與飽和度的關系，建議了一組計算非飽和膨脹土變形及強度特性的經驗公式。
  3. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究，內容包括： （ 1 ）本文採用有限長行波面電流作用於有限長鐵芯上的模型，引用了氣隙磁場一維解，研究了單層繞組磁場，奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較，簡單介紹了二維解； （ 2 ）用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析，並分析了結果； （ 3 ）用軟體進行了額定電壓下的瞬態分析，得到了轉矩，位移，轉速隨時間變化曲線圖，利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較，採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證，由實驗測得了三相電流波形，並與計算結果進行了比較，對其不對稱性進行了定性分析。
  4. In theoretical study, through analyzing operational characteristics of traffic flow in roundabout and studying the acceptable gap influence on delay and different arrival distributions effect to the capacity, the paper brings forward the experiment methods to study the capacity of roundabout by using the simulation technology

    在理論研究方面，就環形交叉口交通流運行特性進行了分析，並深入地研究了可接受間隙對延誤的影響以及車頭時距分佈對通行能力的影響，提出了利用模擬技術研究環形交叉口通行能力的實驗方法。
  5. With this axial symmetric quasi - 3d model, the gas - flow field in such a wedge - shape air - gap is studied, the phenomena about taylor vortex in such a narrow wedge - shape air - gap is illuminated and the so caused gas - flow in axial direction is explained

    採用準三維軸對稱的計算模型，對楔形氣隙的流場進行了研究，驗證了高速旋轉情況下，環形間隙流場中充滿taylor渦流的現象及相關規律。
  6. Based on a large numbers of model / simulation test of the intermittent cracked rock - like samples, fatigue strength, fatigue deformation and crack appear in preexisting cracks tips, the growth of crack, the pattern of crack coalescence are studied / analysed systemically by means of cyclic load and static load, in the course of the model test, the difference between cyclic load and static load of crack appear in preexisting cracks tips, the growth of crack and the pattern of crack coalescence are observed and analysed

    在試驗過程中，觀察並分析了循環加載方式下，預置裂隙端部裂紋萌生、擴展、巖橋貫通模式與靜載方式下的差異；探討了疲勞裂紋萌生、擴展的機理，分析了加載頻率、荷載水平對裂隙試樣疲勞強度、疲勞變形（總變形和不可逆變形）的影響規律。
  7. The tower shafts, most of which are hollow and varying in cross section, and altitudinal construction bring trouble to the form work and the stress of strand wire. and the cracks on the crossbeams will be caused by the following - deformation of the bracing structure joints, elastic deformation ， uneven settlement and temperature changes. the additional stress of the base slab and the foundation is caused by the deviation of cable bent tower construction

    但大跨度橋梁混凝土索塔施工設備進場及現場管理都比較困難；塔柱多為空心變截面，且為高空作業，給模板工程及預應力張拉帶來一定困難；支撐系統連接的間隙變形、彈性變形、不均勻沉降以及環境溫差可導致橫梁裂縫；索塔施工偏位會引起的承臺和基礎的附加應力，對加勁梁的架設影響大；懸吊結構未完體系（架設時）施工階段的風致振動往往影響到施工的安全和質量；實心塔柱部分體積較大，易產生溫度裂縫。
分享友人
分享到 Line

分享到臉書