環形流壓計 的英文怎麼說

中文拼音 [huánxíngliúyājì]
環形流壓計 英文
piezometer ring
  • 環 : Ⅰ名詞1 （環子） ring; hoop 2 （環節） link 3 （姓氏） a surname Ⅱ動詞（圍繞） surround; encircle;...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 壓 : 壓構詞成分。
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 環形 : annular; ringlike; ring form; bight; annularity環形癌 annular carcinoma; 環形電路 [訊] loop circu...
  1. The best optimum mathematical model is constituted. scalar factor of structural parameter on loop rectangular negative pressure and adsorption slide is calculated. structural parameter, air gas source pressure carrying capacity and thickness of air cell are made sure by hydrodynamics and the theory of gas lubrication

    詳細論述了導軌副的設計過程，運用數學上的拉格朗日條件極值求解法，建立最優化數學模型，求出環矩形負壓吸附導軌的結構參數的比例情況，並運用流體力學和氣體潤滑理論確定了環矩形負壓吸附導軌的結構參數、氣源氣壓、承載能力和氣膜厚度的確定性結論。
  2. The theories and design principles of each circuit of the spwm three - phase frequency inverter experiment unit are in detail introduced in this thesis. at the same time some experiment results are shown that include the output voltage and current waves when the load is in resistivity, inductivity or asynchronous motor

    文中詳細介紹了spwm三相變頻實驗單元所包含的各電路環節的理論基礎及設計過程，並給出了調試結果，如負載為阻性、感性和異步電動機時，實驗單元輸出的電壓和電流波形。
  3. For best results in measuring static pressure, a piezometer ring should be used.

    為了測靜液壓能取得最好的結果，應該用環形流壓計。
  4. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直線感應電機進行了深入細致研究，內容包括： （ 1 ）本文採用有限長行波面電流作用於有限長鐵芯上的模型，引用了氣隙磁場一維解，研究了單層繞組磁場，奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較，簡單介紹了二維解； （ 2 ）用有限元軟體ansoft對大圓環直線感應電機空載氣隙磁場進行了靜態分析，並分析了結果； （ 3 ）用軟體進行了額定電壓下的瞬態分析，得到了轉矩，位移，轉速隨時間變化曲線圖，利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較，採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證，由實驗測得了三相電流波形，並與計算結果進行了比較，對其不對稱性進行了定性分析。
  5. Depending on how the ground surface is denuded, the feature of the current crustal stress field and rock stress environment can be calculated analyzing the result in this paper : by analyzing the recovering feature of the elastic deformation of the rockmass in unload - stage under various pressures, it has been found there is close relationship between the recovering degree of the elastic deformation of the rockmass and the unloading degree of the pressure the direction of the major principal stress in the crustal stress field is not consistent with the direction of the crushing stress regional tectonics borne during the last tectonic movement. the evolving degree of the regional geomorphology evidently affects the current crustal stress field, which changes from the self - weight stress field to the horizontal stress field, with the changing of the eroding degree of the regional geomorphology ranging from valley area to hilly country to flat country. in valley area, where there is two stress belts, the bankslope s tress belt and the self - weight stress belt within the mountain. the direction of the major principal stress is nearly parallel to the ground surface and inclines towards the valley in the bankslope stress belt. it is nearly vertical in the self - weight stress belt

    通過本文的研究成果，根據區域性地貌的演化特徵，我們可以大致地對現今地應力場進行判斷：在分級卸荷條件下，巖體中彈性變形的恢復具有明顯的規律性，這種規律對于研究地應力場的演變是有幫助的；地應力場中最大主應力方向與區域構造形跡在最近的構造運動中所受區域性擠壓應力的方向無明顯的對應性；區域性地貌形態的演化程度對現今地應力場的特徵具明顯的影響，隨著區域性地貌侵蝕程度由峽谷區、丘陵區、平原區的變化，現今地應力場特徵由自重應力場、水平應力場為主含少量自重應力場特徵向水平應力場的規律變化；在峽谷區，山體中具有兩個應力帶：自重應力帶和卸荷應力帶，最大主應力方向在卸荷應力帶中近平行於坡面並傾向于河谷、在自重應力帶中近於直立；根據原始地面遭剝蝕的程度，可以大致地估算最大主應力和中間主應力的量值和方向；在丘陵區和平原區，最大主應力的方向近於水平，並與附近區域性侵蝕盆地和河流的展布方向基本平行，根據原始地面遭剝蝕的程度，可以大致估算其最大主應力的量值；根據區域性地貌形態的特徵來分析工程區的現今地應力場特徵，並進而大致了解巖石的應力環境，這種分析方法得出的結論與許多實際的地應力測試成果基本一致，對于大型水電工程地下廠房和壓力隧洞的設計是有所幫助的。
  6. Considering of the problems exist in practice, large orifice discharge principle is employed to study the pressure distribution of ring runner system, the even ab lity for discharging of gates, the relationship of flow with the position of spr ue and the type of gates. a new design idea about circular runner system of cast is proposed

    根據生產中存在的問題，用大孔出流理論研究了環形橫澆道系統的壓力分佈、內澆道出流均勻性及流量與直澆道引入位置和內澆道引入方式之間的關系，提出了圓形鑄件環形橫澆道系統新的設計思想。
  7. Under the function of big pressure and dynamic load, the grains may be moved which may cause the soil body distortion. at present, the relatively ripe methods of drill in gravel layer are mostly double - wall drill pipe reverse circulation drilling, auger stem breast wall drilling and down - the - hole hammer follow down drilling

    論文根據jsl ? 30型礫石鉆機潛孔錘同心跟管鉆具結構，採用程序計算得到了鉆桿內各深度處壓力分佈、鉆頭壓力降、環形空間壓力分佈及空氣流速分佈。
  8. The system uses the permanent magnet synchronous machine as the driver motor based on the idea of polygonal flux linkage locus and the permanent magnet brush - less motor is as the momentum balance motor by means of speed and current loop in order to track driver motor precisely and rapidly. the harmonious control of driver motor and balance motor is realized by making full use of the dsp hardware resource and complicated programmable logic device. the software design is composed of c and assembly language to realize motor control arithmetic of polygonal flux linkage locus

    衛星天線伺服控制系統以正弦波永磁同步電機作為驅動電機，採用多邊形磁鏈軌跡法（電壓空間矢量法）的控制策略；動量平衡電機採用永磁無刷直流電機，通過電流環、速度環達到快速、精確跟蹤驅動電機的目的，確保了衛星姿態恆定；設計方案中充分利用了dsp硬體資源和復雜邏輯陣列實現了驅動電機和平衡電機的協調控制，並通過c語言和匯編語言的混合編程實現了電機的多邊形磁鏈軌跡控制演算法。
  9. We discuss the influence on the flux and torque when the multi - voltage space vector is applied on the motor. then the strategy of producing hexagon flux or circle flux is proposed. it is believed that, in order to control the torque optimally in dtc system, the stator current needs to be observed predictably

    論文在闡述異步電動機的直接轉矩控制原理的基礎上，詳細分析了多電壓空間矢量對磁鏈和轉矩的影響，給出了六邊形磁鏈和圓形磁鏈以及定子電流預測的設計方法，提出了一種新的轉速環控制方法。
  10. People can easily design the hysteresis current control hardware circuit, but the switching frequency is variable which makes us difficult the design the output filter, moreover the output waveform is not good. the space vector modulation techniques, by selecting the zero vector properly, it can reduce the harmonic content of the output voltage, so it has become a popular control method

    滯環電流控制的硬體電路設計簡單，但存在開關頻率不固定，輸出濾波器設計困難，輸出波形質量差，空間矢量控制（ svm ）技術具有較高的電壓利用率，且通過對零矢量的合理控制可以降低諧波含量或降低開關損耗，因此是一種較好的控制方法。
  11. For the direct current decouple controller, the p1 adjustor ? parameter of current and voltage loop ? is designed. the correction of the designed parameter is testified by simulating on two phase synchronization coordinate and three phase stationary coordinate, the simulation wave is given

    對直接電流解耦控制器的電流環和電壓環的pi調節器參數進行了設計，並通過在兩相同步坐標系與三相靜態坐標系的模擬驗證了設計參數的正確性，同時也驗證了直接電流解耦控制方案的可行性，給出了模擬波形。
  12. Based on the large disturbance equation and using the measured power angle as an observation argument in an identification algorithm, the electrical parameters and mechanical parameters are obtained. in this thesis, micro - computer testing systems for synchronous generator is analyzed. withmcs - 196 series single chip micro - controller of high price performance ratio, a high precision, intelligent instrument for automated testing has been developed

    設計了同步發電機參數測試儀器，完成了利用發電機定子電壓電流的波形，辨識發電機參數的計算機軟體，該裝置運用鎖相環技術自動跟蹤和獲取電量頻率，進行交流采樣，利用傅立葉演算法求得電量基波的幅值、有效值，從而可獲得三相有功功率、三相無功功率以及功率因數。
  13. The article synthesizes the transducer technique, the detection technique and the computer technique to build a healthy intellective monitor system, which measuring the pressure value of structure and convert it into the electrical value which is convenient to research such as the voltage and the current. the upper computer can obtain pressure values by transmitting and analyzing the electrical values

    本文主要根據此結構物所處外部環境，將傳感技術、檢測技術和計算機網路技術結合起來建立一個結構智能監測系統，其原理是測量應力的風壓力所引起的應變傳感器的彈性形變，把結構物所受壓力轉換成電壓、電流等便於測量的電信號，再通過傳輸並測量這些電信號而對應得到此結構所受到的壓力值。
分享友人
分享到 Line

分享到臉書