用金屬包覆 的英文怎麼說

中文拼音 [yòngjīnzhǔbāofù]
用金屬包覆 英文
metal
  • 用 : Ⅰ動詞1 （使用） use; employ; apply 2 （多用於否定: 需要） need 3 （敬辭: 吃; 喝） eat; drink Ⅱ名...
  • 金 : Ⅰ名詞1 （金屬） metals 2 （錢） money 3 （古時金屬制的打擊樂器） ancient metal percussion instrum...
  • 屬 : 屬名詞1 （類別） category 2 [生物學] （生物分類系統上所用的等級之一） genus 3 （家屬; 親屬） fami...
  • 覆 : 動詞1. [書面語] （蓋住） cover 2. [書面語] （底朝上翻過來; 歪倒） overturn; upset 3. 同 「復」 （Ⅱ1. 2. ）
  • 金屬 : metal
  1. As predicted theoretically, the ps polymer spreaded over the surface of the titania particles to form composite particles with core - shell structure. the influence of ph value and non - ion surfactant in heterocoagulation was discussed. the property of the coated particles was characterized by sem, and zeta potential, particle size distribution of the particles before and after encapsulation was obtained by laser particle size analyzer

    根據機械力化學的原理，採用自行制備的微米級ps和pmma （聚甲基丙稀酸甲酯）高聚物微球、金屬粒子、納米級的tio _ 2 、爐料為原料粒子，通過採用自行研製的乾式沖擊設備和lg攪拌磨製得以高聚物微球、金屬粒子為核，納米tio _ 2 、碳黑粒子等為包覆粒子的具有不同特殊功能的納米微米復合粒子。
  2. Based on decreasing the production cost and enhancing the high rate performance of this material, this paper adopted a two - step solid - state reaction to improve lifepo4 ` s behavior mainly using carbon coated or doped and mg2 + doped method

    本文從降低材料生產成本的同時提高材料的大電流放電性能出發，採用球磨高溫固相法主要針對碳摻雜/包覆和金屬離子摻雜對磷酸亞鐵鋰進行改性。
  3. In this paper, nanosized al2o3 ceramic particles were chose as reinforcing phase. enhanced with ultrasonic wave the particles were covered with copper using method by electroless plating, the copper - matrix composite was developed by hot - press sintering process of the composite powder. the composition, microstructure, hardness, density and dry sliding wear property of the new material have been studied

    研究路線為：選用納米級al _ 2o _ 3陶瓷顆粒作為增強相，在超聲波的環境中用化學鍍的方法完成對納米al _ 2o _ 3陶瓷顆粒表面的金屬銅包覆，採用熱壓燒結成型技術以復合粉末為原料制備成納米al _ 2o _ 3陶瓷顆粒增強銅基復合材料，研究分析復合材料的成分、組織結構、硬度以及緻密度，對試樣進行了干滑動摩擦磨損實驗。
  4. Through the simulation of the forming process, we can get the deformations, stress, strain, plastic flowing in sheets and the interface state under impact load and rolling load, the deformation of the sawtooth form and comparing to the initial state, the results above are expressed in computer animated way. and the effect of geometrical ( mainly different form, including 90 degree, isoceles triangle ， 75 degree, and 1. 5 high and wide ), material and technical parameters on the bond strength are analyzed, also including the comparison of different sawtooth form. the optimum parameters are got

    對雙金屬復合板成型過程進行模擬，從而得到在沖擊載荷和軋輥壓力作用下基板和覆板的應力、應變分佈和塑性流動變形規律，復合后的齒形的變形情況與初始齒形形成對比，以動畫的方式模擬成型過程，並分析了不同幾何參數（主要是不同的齒型，其中包括直角齒型、等腰齒型、 75度齒型、 1 . 5高寬齒型） 、材料參數、工藝參數對復合強度的影響，以及不同齒型的變形對比以及齒型對復合情況的影響，提出最優齒型、最優工藝參數，有效地指導了實驗。
  5. Metallic envelope gaskets for pipe flanges

    管法蘭用金屬包覆墊片
  6. In this paper, we tried to get metal - coated composite powders with different particle sizes by electroless silver plating on different ceramic powders such as nano - al2o3, micro - cenospheres and submirco - sio2. the nano - al2o3 powder with average size about 10 to 20 nanometers was pretreated to produce catalytic activity before the electroless silver plating

    本文利用化學鍍的方法在不同粒徑的陶瓷粉體（包括納米al _ 2o _ 3 、微米空心玻璃微珠及亞微米級的sio _ 2 ）上包覆金屬銀，制備不同粒徑的金屬包覆型復合粉體。
  7. This modulator works with the guided - wave reflectance peak, in which the light intensity is changed by the variation of the refractive index of poled polymer due to the electro - optic effects. device performances have been theoretically and experimentally investigated. we also successfully carried out experiments of video signal transmission using the proposed modulator

    該調制器工作于金屬包覆波導的衰減全反射導模吸收峰，利用極化聚合物電光材料的折射率對導模吸收的影響來實現電光調制，並對器件的性能指標進行了實驗研究，同時利用製作的反射型電光調制器進行了視頻信號良好地傳輸實驗。
  8. Steel wire and wire products for fences - zinc and zinc alloy coated steel barbed wire

    欄柵用鋼絲和金屬絲製品.鋅和鋅合金包覆的刺鋼絲
  9. The pvc tube is hazardous for carbon dioxide ( co2 ) laser surgery if it is not well wrapped with metallized foil tape

    在雷射手術當中，如果氣管幾管用金屬鋁箔紙包覆的不完備的話，尤一管子被雷霆央求我束打到，造成起火燃燒的機會還是很大。
  10. Steels excluding packaging applications - metallic coated flat steel products intended for contact with foodstuffs, products and beverages for human and animal consumption - part 5 : tin coated non - stainless steels

    包裝用鋼除外的鋼.與人和動物消費用食品產品和飲料接觸的金屬塗覆扁鋼製品.第5部分:塗錫
  11. It ' s well known that nano - materials have good ductility, and the composite powders have the better consistency properties. on the other hand, because the metal phase was evenly distributed, the ductility of the ceramic composites could be promoted further

    因此，本文的研究內容設定為用化學鍍的方法在納米級的al _ 2o _ 3陶瓷粉體上包覆金屬銅，制備納米的金屬包覆型陶瓷復合粉體。
  12. The company is the global leader in the provision of high quality metallic coated and painted steel products for the building and construction sector, and also supplies customers in the general manufacturing, automotive and packaging sectors

    博思格鋼鐵公司的生產製造工廠及營銷網路覆蓋澳大利亞、紐西蘭、亞洲及北美洲，其世界一流的金屬鍍面及彩塗鋼品被廣泛運用於建築業、製造業、汽車及包裝行業。
  13. The electrode potential of the ndfeb magnetic powders and the plating was measured, the correlation between the electrode potential and corrosion resistance of ndfeb magnetic powders was discussed

    磁粉電極電位表現為ndfeb磁粉和包覆金屬鍍層的混合電位。探討了電極電位在金屬腐蝕性能方面的作用。
  14. The applications field of fgm include aerospace, electron, chemistry, biology and medicine fields ; the composition change also from metal / ceramic to metal / metal, metal / alloy, non - metal / non - metal and non - metal / ceramic. moreover, various methods including powder metallurgy, self - propagating high - temperature synthesis ( shs ), chemical and physical vapor deposition ( cvd and pvd ), electrodeposition, laser cladding method, plasma sputtering and sol - gel method have been studed. metal organic chemical vapor deposition ( mocvd ), using chemical vapor deposition of metal organic compounds, is an effective method for acquiring special function materials and membrane

    功能梯度材料是21世紀最有發展前景的新型材料之一，其用途已由原來的宇航工業，擴大到核能源、電子、化學、生物醫學等領域；其組成也由金屬?陶瓷發展成為金屬?金屬、金屬?合金、非金屬?非金屬、非金屬?陶瓷等多種組合；其制備方法主要包括粉末冶金法，自蔓延高溫合成法（ shs ） 、氣相沉積法（ cvd和pvd ） 、電沉積法，激光熔覆法，溶膠?凝膠法（ sol - gel ）等。
  15. The formula was tested and verified by experimental results. dies for powder wire, bi - metal and tri - metal cladding products were designed. using these dies, formability of powder wire and cladding products in different processing parameters has been studied by experiments

    在前期研究工作基礎上，設計了粉末線材及雙金屬、三金屬包覆材連續擠壓模擬實驗的模具，並採用此模具對粉末線材及包覆材在不同工藝參數下的成形作了實驗性研究。
  16. Rubber hoses and hose assemblies - rubber - covered spiral wire reinforced hydraulic type - specification

    橡膠軟管和軟管組件.橡膠包覆螺旋形金屬絲增強的液壓用類型.規范
分享友人
分享到 Line

分享到臉書