疲勞特性 的英文怎麼說

中文拼音 [píláotèxìng]
疲勞特性 英文
endurance character
  • 疲 : 形容詞（疲乏; 勞累） tired; weary; exhausted
  • 勞 : Ⅰ動詞1 （勞動） work; labour 2 （煩勞） put sb to the trouble of; trouble sb with sth : 勞您費心...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 疲勞 : 1. （疲乏勞累） tired; fatigued; weary; become fagged 2. （機能或反應能力減弱） fatigue; strain 3. [物理學] fatigue
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. Test research of ultrahigh - cycle fatigue behavior of high strength steel

    高強度鋼超高周疲勞特性試驗研究
  2. Hydraulic fluid power - filter elements - verification of flow fatigue characteristics

    液壓濾芯流動疲勞特性的驗證
  3. Hydraulic fluid power ; filter elements ; verification of flow fatigue characteristics ; identical with iso 3724 : 1976

    液壓流體動力.濾芯.流動疲勞特性的驗證
  4. The test of low cycle fatigue characteristics for 45crnimova steel and in - situ observation on surface crack propagation

    鋼的低周疲勞特性和表面疲勞裂紋的在位觀測
  5. Flexible cellular polymeric materials - determination of physical properties - part 4 : compression set and fatigue characteristics

    撓性多孔聚合材料.物理性能的測定.第4部分:壓縮變形和疲勞特性
  6. Hydraulic fluid power - filters - evaluation of filter performance - part 6 : filter elements - verification of flow fatigue characteristics

    液壓動力.過濾器.過濾器性能的評價.第6部分:過濾器元件.流動疲勞特性的檢定
  7. Mechanics characteristic of lean concrete included strength & module, fatigue characteristic and shrinkage properties are studied and its pavement parameters are put forward

    研究了貧混凝土的力學特性包括強度、模量、疲勞特性和收縮特性，並確定各相關的路用參數。
  8. Low - frequency fatigue investigation of 0. 94pbmg1 3nb2 3o3 - 0. 06pbtio3 and ba0. 7sr0. 3tio3 ceramics under high - electric - field cycling and the de - fatigue effects by heat treatment

    鐵電陶瓷的低頻高場疲勞特性及去除疲勞方法的研究
  9. Research on anti - fatigue performance of strata stress absorbing layers

    應力吸收層抗疲勞特性研究
  10. After the study on the characteristic of the fatigue behavior of gray cast iron dryer, the fatigue analysis on this kind of dryer is carried out so as to specify the fatigue analysis method of dryers

    本文還在分析灰口鑄鐵烘缸疲勞特性的基礎上，對該烘缸進行疲勞分析，以此說明烘缸疲勞分析設計的方法。
  11. 5 %. due to the instability of gh4145 / sq in the total cyclic course, we study the oscillation of fatigue factors regarding different life stage for the first time

    針對gh4145 / sq合金在整個疲勞過程中的不穩定行為，本文對不同疲勞壽命階段的疲勞特性參數進行了研究。
  12. An experimental program which includes lots of unidirectional laminae is conducted using t300 / bmp - 316 material for researching the static and fatigue behaviour of the unidirectional ply. the experimental research for mechanical behaviour of a unidirectional lamina is to set up expressions of the normalized fatigue life, the residual strength degradation and the residual stiffness degradation of a unidirectional ply in the longitudinal, transverse and in - plane - shear directions, which also verifies the fact of nonlinear shear stress - strain behavior of a unidirectional ply in the 1 - 2 planes

    其中:分別對材料t300 / bmp - 316單向層合板縱向、橫向及面內剪切靜載力學性能及疲勞特性進行了試驗研究，並採用最小二乘法擬合得到各主方向正則化疲勞壽命表達式，以及單層板各主方向疲勞加載剩餘剛度退化表達式及剩餘強度退化表達式;試驗同時驗證了單向層合板1 - 2面上明顯的剪切應力應變非線性關系。
  13. The fatigue properties of sucker sods are predicted by its static properties with fatigue strength theory and cumulative damage theory according to the measurement result of conventional mechanical properties of sucker sods with different service periods

    摘要應用疲勞強度理論和累積損傷理論，利用對使用不同年限抽油桿的常規機械性能的測試結果，由抽油桿的靜特性去推測其疲勞特性。
  14. Advanced composite is widely used in designing the structure of aircrafts, for it has some excellent performances such as excellent fatigue, high strength and stiffness ratio, etc

    先進復合材料比強度、比剛度以及良好的抗疲勞特性等諸多優異性能為飛機結構工程設計實踐廣泛應用。
  15. In the master thesis, the fatigue characteristics of the ferroelectric films under thermal load and electrical load were investigated. the thermal load was induced by a pulse laser beam of nd : yag and the electrical load was made by rt6000s ferroelectric tester t o act on the films respectively. the effect of thermal or electric loads on the films properties was discussed

    本文對鐵電薄膜在循環的熱載荷和電載荷作用下的疲勞特性進行了研究，分別用nd ： yag脈沖激光器模擬熱載荷、用rt6000s鐵電測試儀模擬電載荷作用於鐵電薄膜，根據實驗結果探討了這兩種載荷對鐵電薄膜性能的影響。
  16. This paper uses the theory of design on parameters to achieve the software package of bss and the stator vane ’ s vibration and fatigue analysis software, which realize the process of stator vane ’ s vibration and fatigue use a key to control

    本文還採用了參數化的設計思想開發了盲源分離的軟體包。同時課題期間還開發了靜子葉片振動與疲勞分析平臺軟體，實現了整個葉片振動、疲勞特性分析的過程的「一鍵控制」 。
  17. Study on the fatigue properties of the ta15 titanium alloy plate and electron beam welding specimen

    15板與電子束焊接疲勞特性研究
  18. Fatigue strength coefficient decreases linearly during the cyclic course ; fatigue strength exponent increases ; fatigue ductility coefficient first goes up till the maximum value at 50 % total life, and then goes down ; fatigue ductility exponent decreases during the first half cycle till its minimum value at 50 % total life and then increases in the rest cycle course ; cycle strength coefficient and cycle strain hardening exponent both decrease during the total cycle course

    結果表明： 6個基本疲勞特性參數在循環過程中都呈顯出規律性變化。疲勞強度系數呈線性減小趨勢；疲勞強度指數呈線性增大特徵；疲勞延性系數是一個先增后降的過程；而疲勞延性指數隨循環進行由初始減小到逐漸增大；循環強度系數和循環應變硬化指數在整個循環過程中都趨于減小。
  19. The oscillation of fatigue factors have much effect on small strain amplitude fatigue life, and the less the strain amplitude, the less the effect. as for notched specimen, the fatigue life prediction using fatigue factors of half - life section is the smallest

    5時，採用7 10壽命階段的疲勞特性參數預測結果與實測值的一致性更好；對于缺口疲勞試樣，則採用半壽命階段的疲勞參數的預測結果為最小。
  20. This paper mainly analyzed sn - cu eutectic solder alloys ' research production of wetting characteristics and their tensile property, shear property, creep property, fatigue property and thermal fatigue property when the block of sn - cu eutectic solder alloys joined by backing

    摘要主要敘述了錫銅合金的潤濕性質以及它們的塊材與基材連接時的拉伸特性、剪切特性、蠕變特性、疲勞特性及熱疲勞特性等方面的研究結果。
分享友人
分享到 Line

分享到臉書