直流磁偏 的英文怎麼說

中文拼音 [zhíliúcípiān]
直流磁偏 英文
dc magnetic bias
  • 直 : Ⅰ形容詞1 （成直線的; 硬挺的） straight; stiff 2 （跟地面垂直的; 從上到下的; 從前到后的） erect; v...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 偏 : Ⅰ形容詞1 （不正; 歪斜） inclined to one side; slanting; leaning 2 （只側重一面） partial; prejudi...
  • 直流 : direct current （dc）; constant current; steady current; continuous current; zero frequency curre...
  1. The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory

    以整流側觸發延遲角的調節信號、逆變側觸發超前角的調節信號以及發電機勵磁電壓作為控制變量，以直流線路電流、逆變側關斷角以及發電機功角的偏移量作為目標輸出，用直接反饋線性化方法設計了系統的非線性控制器。
  2. In the thesis, a signal processing scheme of polarization - insensitive fiber optic michelson interferometric magnetic sensor is described : making the interferometer work near the quadrature with closed loop controlling working point method, the fundamental frequency component of the magnetic field sensing signals can be detected to measure the input direct current ( dc ) magnetic field by phase sensitive demodulation

    本文主要介紹了偏振無關光纖michelson干涉型微弱磁場傳感器信號處理的方案:通過閉環控制工作點演算法使干涉儀工作在正交工作點處，再利用相敏檢波演算法提取傳感器輸出信號的基頻分量，以測量直流磁場的大小。
  3. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    偏置測試電路向偏置線圈輸入偏置電流和小信號測試電流，兩者產生的偏置磁場在控制線圈產生感應信號，檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號，該信號經半波整流電路和低通濾波電路后得到與轉子位移成正比例的直流信號，再由pid控制器轉換為轉子位移的控制信號，最後控制信號輸入功放電路產生控制電流，實現閉環控制。
  4. The accurate calculation of the input voltage and the compensation for the dc - offset error and the variation of the stator resistance are important factors in practical implementation of the integration since they can cause a drift in the stator flux linkage trajectory and furthermore deteriorate the quality of torque control

    因此，輸入電壓的準確計算、直流漂移量的補償以及定子電阻變化的補償都是影響積分計算準確性的重要因素，這些誤差會導致定子磁鏈軌跡的偏移，進而降低系統轉矩控制的性能。
  5. With the best modulation strategy which was found on condition that it must have largest energy transfer ratio, smallest current ripple of the inductor, and realizing zvs of each switches, the converter overcomes the drawbacks presented by the conventional zvs fb converter, such as high voltage stress of each switches, large current ripple of the inductor, and severe parasitic ringing on the rectifier diodes, so it can get higher efficiency, faster respond speed, and wider application area. the operation principle of the proposed converter is analyzed and verified by a 3kw, 50khz experimental prototype. experiments and research results show that the scheme of the tl topology derivation is reasonable, adjusted modulation strategy makes some other severe problems in conventional topologies easy to solve or makes the converter more competitive

    研究結果表明，本文提出的三電平拓撲變換方案合理，針對各種三電平拓撲尋找到的控制策略可以解決變換器存在的某些問題或使變換器表現出更突出的優勢：例如針對單管直流變換器三電平拓撲的控制策略可以減小電感的設計值，針對推挽直流變換器三電平拓撲的控制策略可以實現開關管的軟開關、解決變壓器偏磁問題等，針對全橋直流變換器三電平拓撲的控制策略可以減小電感的設計值、實現開關管的軟開關等。
  6. ( 4 ) the study of the optical band gap of cnx film by uv - vis spectrophotometer. ( 5 ) by using the microhardness tester, we study the hardness of cnx film on the ceremic substrate by dc magnetron reactive sputtering with the feed ar and n2 flow rate, film thickness, substrate temperature and substrate bias

    （ 5 ）用直流磁控反應濺射法，以陶瓷作為襯底，對在ar和n2不同流量、不同膜厚、不同基片溫度和對基片施加不同偏壓下沉積的薄膜，用< wp = 4 >顯微硬度計研究測試了不同工藝參數下的相應硬度。
  7. These methods all can be used to solve the magnetic aberration hi the conventional push - pull converter

    這兩種方式均可以解決傳統推挽直流變換器存在的偏磁問題。
  8. In 1992, li zhiqing ' s master degree paper, the temperature stability of vertical bloch line ( vbl ) chains in walls of second hard dumbbell domain ( iid ) in the uncompressed state was investigated experimentally and a threshold temperature ( 7 ) nd at which to breakdown the vbl chains in the walls of iid was found

    由於其轉化過程中vbl沒有丟失，也就是說，其疇壁結構沒有發生變化，所以我們再次證明了三類硬磁疇的疇壁結構是一致的，在直流偏場下之所以會出現不同的縮滅行為，完全是由於vbl的數目引起的。
  9. Classic u - i model is simple. however the integrator inevitably bring up the error accumulation and dc drift. this paper present a new integrator method. it has been proved to be a successful alternative for integrator, but in simulation it is found not fit for dtc

    定子磁鏈的觀測是dtc的關鍵技術，傳統的u - i模型結構簡單，實用，但是由於積分器將電流檢測中的直流偏置累加，而且對定子電阻的變化魯棒性不夠。
  10. Abstract : the multifunctional inverter power sourcethe handy inverter welding, plating & charging manchine, developed with advanced inverter and micro - electronics control techniques, adopts “ half - bridge power expansion supply midpoint voltage autocontrol setting ”, and technically and effectively having solved inverter subvision of inverter power expansion circuit for leaning magnetism, reliability of high - power inverter setting, achives combination of constantcurrent and constantvoltage export, and realizes low - voltage dc and high - voltage ac double power supply

    文摘:運用先進的高頻逆變技術和微電子控制技術設計研製的逆變式多功能電源便攜式逆變焊鍍充電多用機，採用「半橋式功放級供電中點電壓自動控制調節裝置」 ，在技術上解決了逆變功放電路因偏磁而造成的逆變顛覆，有效地解決了大功率逆變器的可靠性問題；進行多種外特性的綜合設定，實現了恆流與恆壓輸出的合一；與傳統焊機相比，實現了開環和閉環狀態下都互不影響的低壓直流電瓶和高壓交流雙供電
分享友人
分享到 Line

分享到臉書