直連泵 的英文怎麼說

中文拼音 [zhíliánbèng]
直連泵 英文
direct connected pump
  • : Ⅰ形容詞1 (成直線的; 硬挺的) straight; stiff 2 (跟地面垂直的; 從上到下的; 從前到后的) erect; v...
  • : Ⅰ動詞1 (連接) link; join; connect 2 (連累) involve (in trouble); implicate 3 [方言] (縫) ...
  • : 名詞(吸入和排出流體的機械) pump
  1. The paper mainly consider the followings : the performance parameter determination of cryopump, heat load determination and heat transfer of large cryopanel, reasonable distribution of heat load, the condition for construct steady flow in small vertical circle pipeline, balance condition for gas and liquid two - phase flow in the connection pipe between cryopanel and dewar, the safety of cryopump

    文中探討了低溫性能參數的確定;大抽速低溫抽氣面的熱負載的確定及合理分配;冷凝面上豎圓管內受熱建立穩定流動的條件;冷凝面與杜瓦間的接管道內氣液「雙相流動」的平衡條件;低溫系統運行的安全問題。
  2. This drilling adopts crank connecting link and walking beam percussion mechanism, which make the drilling possess two percussive functions, normal drilling takes connecting link impact as main mode, when encountering special situation and the connecting link impact can not drill, it can transform into hoisting impact, the stroke length can be modulated, it realizes automatic percussive drilling due to continuous operating of connecting link percussive mechanism, these can enhance drilling efficiency and relieve labor intensity ; it adopts pumping reverse circulation to drain slag, which not only resolves the drilling difficulty in special stratum such as pebble and gravel stratum and hard stratum, but also resolves the problem that the percussive drill ' s efficiency is low ; it adopts spur gear differential mechanism as double cylinders lazy tongs of main hoist, which not only ensures the balance state of drilling tool, but also reduces the mechanical design, and reduces the cost ; the bottom plate traveling motion of this drilling machine adopts walking type ; the drilling tower adopts hydraulic pressure uprising, and reduces the assistant operating time

    該鉆機採用曲柄桿、游梁式沖擊機構,使鉆機具有兩種沖擊功能;正常鉆進以桿沖擊為主,遇到特殊情況,用桿沖擊不能鉆進時,可轉為卷揚沖擊,沖程可調,因桿沖擊機構續工作,所以實現了自動沖擊鉆進,可提高鉆進效率,減輕勞動強度;採用吸反循環的方式排渣,既能有效解決卵礫石地層、堅硬地層等特殊地層鉆進的困難,又很好地解決了沖擊鉆機效率低下的問題;採用齒圓柱齒輪差速機構作為主卷揚的雙筒同步機構,既保證了鉆具處于平衡狀態,又大大簡化了該機構設計,降低了成本;該鉆機底盤行走移位採用步履式;鉆塔採用液壓起立,減少了輔助作業時間。
  3. Rating of direct coupled photovoltaic pumping systems

    接光電裝置的額定值
  4. 30 litre couplant tank. automatic pumped supply with full recirculation. visual and electronic level display. continuous couplant monitoring by flow sensor and ultrasonically

    30升的耦合劑儲蓄槽。自動化槽裝置可以將其完全循環利用。可顯示觀的電子層面。通過流量傳感器和超聲波地來對耦合劑進行續監控。
  5. The technical breakthroughs in growth of nd : cngg had been made. in particular, continuous laser operation was achieved from nd : cngg pumped by ld. when the crystal wafer was end - pumped by one bar of ld with 807nm wavelength, the cw laser output power of 123. 1 mw was obtained with slope efficiency of 22. 3 %

    本論文用自動化熔體提拉技術成功生長出< 111 >方向的徑25mm以上,長度80mm以上的平界面無核心nd : cngg單晶,確定了晶體結構和物相,測量了晶體的光譜性能,晶體消光比達到34db ,晶體生長技術有新的突破,實現了續激光運轉,用單支807nm半導體激光二極體端面浦該晶體片子,在國內首次獲得123 . 1mw的1 . 062 m續激光輸出,斜效率達22 . 3 % 。
  6. A laser diode with 976nm center wavelength and 2. 03w maximum cw output power is pumping unidirectionally through the couple - imaging system on a double - clad yb - doped silica fiber with a yb - concentration 0. 65 mol % circular inner core, a d - shaped inner clad, and 15m length by f - b cavity. the center wavelength of the fiber laser is 1130nm, and the maximum cw output power is 130. 7mw. an optical - to - optical conversion efficiency of 42 % and a slope efficiency of 63. 4 % are obtained

    用中心波長976nm 、最大續輸出功率為2 . 03w的ld浦源,通過成像耦合系統,單端腔式浦纖芯摻雜濃度為0 . 65mol % 、內包層截面形狀為d形、長度為15米的雙包層摻鐿石英光纖,實現了中心波長1130nm 、最大功率為130 . 7mw的續激光輸出,光纖激光器的光光效率為42 . 0 % ,斜效率達到63 . 4 % 。
分享友人