相對故障頻率 的英文怎麼說

中文拼音 [xiāngduìgùzhàngbīnlǜ]
相對故障頻率 英文
rff relative failure frequency
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 對 : Ⅰ動詞1 （回答） answer; reply 2 （對待; 對付） treat; cope with; counter 3 （朝; 向; 面對） be tr...
  • 故 : Ⅰ名詞1 （事故） event; incident; happening; accident 2 （原因） cause; reason 3 （朋友; 友情） fr...
  • 障 : Ⅰ動詞（阻隔; 遮擋） block; hinder; obstruct Ⅱ名詞（遮擋物） barrier; block; obstacle
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 相對 : 1. （面對面） opposite; face to face 2. （非絕對的） relative 3. （比較的） relatively; comparatively
  • 故障 : hitch; breakdown; stoppage; fault; faulting; accident; blunder; bug; conk; failure; impairment; i...
  • 頻率 : frequency; rate
  1. What is mainly discussed in this dissertation is as follows : the fault mechanism and vibration frequency feature of hydroelectric vibration are analyzed, induced and reorganized. the select and placement of detecting positions of parameters such as vibration, swing and pressure pulsation are researched, and the corresponding sensors are selected to monitor

    本文主要進行了以下工作：分析、歸納和整理了水電機組振動的故障機理和振動頻率特徵，對機組的振動、擺度和壓力脈動測點進行了選擇和布置，並選用相應傳感器進行監測。
  2. From theoretical analysis, we know the existing demodulation methods have limitations as following : one is that the subtraction of the two signals frequencies will display as the result of demodulation when we demodulate two time - domain adding signals without modulating information ( fault information ) ; the other one is that aliasing phenomenon will occur as a result of getting absolute value, detection or square in the process of generalized demodulation analysis, such phenomenon will result in some superfluous frequency composition on the frequency spectrum, which will puzzle the detec tion of mechanical vibration. if the sampling frequency is selected from a suitable range, the aliasing phenomenon will be avoided ; the last one is that aliasing frequencies will be produced in zoom demodulation analysis because this algorithm cannot employ digital low - pass filtering to avert the folding frequencies of higher harmonics in the process of zoom sub - sampling

    現有的解調分析方法存在以下三種局限性：將不包括調制信息（故障信息）的兩時域相加信號，也以其頻率之差作為解調信號而解出；廣義檢波濾波解調分析中，由於取絕對值、檢波或平方過程可能產生混頻效應，在解調譜中表現為無法分析的頻率成分，並由此推導出避免這種混頻現象的采樣頻率的選取范圍，從根本上避免此類誤診斷的產生；幾種細化解調分析新演算法中，因為無法在細化分析的選抽時進行數字低通濾波，有可能會出現調制頻率的高次諧波成分發生頻率混疊而反折到低頻部分的現象。
  3. Since that the choosing line hardware for the neutral ungrounded system has just passed part of the dynamic simulative test, matlab software was chosen to do a lot of simulative tests on single phase - to - grounding fault. and the simulative sampling ratio is almost the same as the hardware ' s. because there is a low wave filter in the hardware, i choose the db15 wave - let to carry out the multidimensional decomposition on the sample by the method of one dimension discrete wavelet in order to obtain low frequency signal including the high frequency transient information on single phase - to - grounding fault

    鑒于實驗室已有的小電流接地系統選線硬體的研製只通過了實驗室里的動模試驗，故選用matlab軟體對小電流接地系統進行大量的單相接地故障模擬試驗，模擬的采樣率和硬體基本一致，由於硬體中帶有低通濾波器，故在進行采樣數據的morlet小波分析時先採用db15小波對采樣進行一維離散小波的多尺度分解，使得分解得到的低頻信號剛好包括了小電流接地系統單相接地故障時的暫態高頻信息，然後對這一信息再繼續進行小波演算法分析，分析結論表明利用變換后的實部、虛部和模值能夠較準確的實現單相接地故障時的故障選線和暫態高頻分量的提取。
  4. A time - frequency analysis method is presented to solve paper machine press section bearing vibration signals of unstable and complication, applying wavelet function to the unstable signals for faulty bearing according to paper machine press section roll bearing characteristic, and process the vibration signals by means of decomposition and reconstruction, obtaining the vibration signals in different frequency bands, the statistic in frequency domain of relevant frequency bands is served as monitoring feature

    摘要針對紙機壓榨部滾動軸承尺寸大響應弱、運轉速度低、低頻信號容易淹沒、調制源多、振動信號非平穩性等特點而導致常規的傅立葉分析診斷故障效果不佳的情況，提出了一種應用小波變換的時頻分析方法，對振動信號進行分解和重構處理，獲得了振動信號在不同的頻段的分量，提取相應特徵頻段重構分量的功率譜的頻域統計值作為特徵參數，從而實現對軸承故障診斷。
  5. Firstly, a relevant algorithm is presented for locating single - line - to - ground ( slg ) fault in distribution networks, fault functions are reasoned out and analyzed for single - phase and three - phase distribution lines, and criterion measure, which are based on the frequency, phase and shape characteristics of the fault function spectrums, are also presented for locating slg faults

    首先論文對三相均勻換位線路的故障定位進行了公式推導和數值計算分析，並在頻域內對故障函數的頻譜曲線幅值、相角和頻率特性進行了分析，提出了相應的故障定位判據。
分享友人
分享到 Line

分享到臉書