相結構 的英文怎麼說

中文拼音 [xiāngjiēgòu]
相結構 英文
phase structure
  • : 相Ⅰ名詞1 (相貌; 外貌) looks; appearance 2 (坐、立等的姿態) bearing; posture 3 [物理學] (相位...
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : Ⅰ動詞1 (構造; 組合) construct; form; compose 2 (結成) fabricate; make up 3 (建造; 架屋) bui...
  • 結構 : 1 (各組成部分的搭配形式) structure; composition; construction; formation; constitution; fabric;...
  1. Effect of doped bivalent ions on phase structure and dielectric properties of pnn - based ceramics

    基陶瓷相結構和性能的影響
  2. The desired heterogeneous structure cannot be obtainable by batch addition of the glassy monomer to the rubbery seed lattx.

    通過往橡皮狀種子膠乳中分批加入「玻璃狀」單體,則不能得到所要求的多相結構
  3. It showed that 73 % increasing of toughness in modified composites was achieved without the reduction of other mechanical properties. sem has showed the periodically interleaved system where the co - continuously connected granular structure occurs layer by layer between each ply and the interlayer was relatively very thin

    電鏡分析表明離位改性的碳纖維單向布周期性增強體系,在每兩層增強體之間都有很薄一層規整的球性兩相結構,正是這個獨特的多層使其抗沖擊性能大幅提高,而且不會對其他重要的力學性能產生不利影響。
  4. Study on microstructure and formation of intermetallic compound in rs al - ti - re alloy

    合金化合物相結構及形成的研究
  5. Study on structural stability of mg - ce intermetallic compounds based on the pseudopotential plane - wave method

    化合物相結構穩定性的贗勢平面波方法研究
  6. Moreover, the quenching concentration of eu is raised. on the basement of successful synthesis of two - components oxide, edta complexing sol - gel method was expanded and applied to effectively synthesis nanosized muti - components oxide, such as la1 - xsrx fe o3, lafe1 - xcuxo3, la1 - xsrx coo3, laco1 - xcuxo3 because edta can bind with most metallic elements of the periodic table, this technique become a versatile tool in the production and study of new nano materials of multi - component complex oxides. a economic and new process has been studied to synthesis la2o3 nanocrystalline, using nh4hco3 as precipitant

    河北大學理學博士學位論文對于單一組份的稀土氧化物,探索出一條更經濟、更方便的合成方法,即:用碳酸氫錢做稀土沉澱劑,成功地制備了納米l匆03 ,並對中間產物碳酸斕及其燒成的氧化斕分別進行了ir 、 tg一dta 、 sem 、 xrd分析研究,確定了碳酸憫的組成,氧化斕的物,並發現分散劑的種類對微觀形貌有一定的影響。
  7. In order to improve the adherence of the film to the substrate and the repeatability of synthesis, we invent a three - step approach, which comprised the steps of turbostratic boron nitride ( tbn ) turning into rhombohedral boron nitride ( rbn ) as the first, rbn turning into cbn as the second and deposition as the last

    基於對bn薄膜相結構的分析和優化的沉積條件,制備出立方含量高達95 %的cbn薄膜。為了改善制備的可重復性和粘附性,提出了三步沉積方法,即將成核過程分成tbn轉化為rbn和rbn轉化成cbn的兩步,加上之後的沉積過程。
  8. We used this water - soluble cationic polyelectrolyte pei as a soft cushion for biomimetic membranes in this chapter, and studied the microstructure of polymer - cushioned pure binary and trinary mixed lb and ls films of dimyristoyl phosphatidyicholine ( dmpc ). cholesterol ( chol ) and sphingomylin ( sph ) ( that is to say study the influence of pei cushion on the microstructure of the monolayers ) deposited from looppm pei water solution subphase by - a isotherms and tapping mode atomic force microscopy

    在本章中我們用這種極易溶於水的陽離子型聚合物pei為一軟墊,研究以此軟墊為基底的不同生物分子和它們不同種二元及三元混合單分子膜體系在含pei亞上的相結構情況,初步的討論了它們以雲母為基底的is膜和lb膜的微或者說是該軟墊對單分子膜微的影響。
  9. The two constituents were compatibilized in - situ by mechanochemical reactions induced by pan - milling and the microstructure of the blend can be controlled conveniently by adjusting processing conditions. polyamide 6 / ground limestone powder ( pa6 / caco3 ) and polyamide 6 / silicon dioxide ( pa6 / sio2 ) composites were also prepared through this method. those pa6 blends and composites exhibit improved microstructure and superior mechanical properties to the systems mixed by conventional mixing methods

    研究了磨盤碾磨對尼龍6的粉碎機理,制備了就地增容、微相結構可調的聚丙烯/尼龍6 ( pp / pa6 )及尼龍6 /碳酸鈣( pa6 / caco _ 3 ) 、尼龍6 /納米級二氧化硅( pa6 / nano - sio _ 2 )共混復合材料,各體系混合效果、微相結構及力學性能均明顯優于採用傳統混合設備制備的試樣。
  10. The experimental results further demonstrate that the combination of incompatibility polydimethylsiloxane and polyacrylate by co - vulcanization improves the both compatibility and broadens the low temperature and high temperature functional region. while in sin, to improve microphase structures and damping properties, the design to increase compatibility between two compositions and modulate crosslinking density as well as relative reaction rate of two compositions, is also effective

    以上實驗果表明,在復合橡膠阻尼材料中將聚硅氧烷與聚丙烯酸酯通過共混硫化合,改進了二者的容性,拓寬了其阻尼功能區的低溫和高溫溫域;而在sin中通過改善組四川大學博士學位論文分間容性,調節交聯密度控制其微相結構和兩種組分對反應速度的快慢,進而控制材料阻尼性能的設計是行之有效的。
  11. According to the theory of light transmission, we derived the expression of rotation angle as a function of the dielectric constant conductivity of er fluid, and ( the angle between the electric vector of linearly polarized light and electric field ) from maxwell ' s equations and fresnel reflection, on the condition of several appropriate approximations and assumptions

    進而導出了非均相結構電流變液在外電場與光場交互作用下旋光角與(入射線偏振光振動方向與外加電場方向間夾角)及參數(為外加電場e 、分散顆粒介電常數、體積分數、絕緣油介電常數、位置矢量( ? )等量的函數)的西北工業大學應用物理系碩士學位論文摘要理論表達式。
  12. Through this article work, the perfect rutile has been got with flame fusion method in developed domestic sjz sintering machine for the first time in china. based on it, the study of the electrical property of irradiationed rutile by high dose neutron has been also made. the achievements are concluded in the following : ( 1 ) through the development of technology of tio

    對粉體的制備工藝本論文也做了詳盡的描述和研究,對粉體前驅體ats的晶、合成和焙燒過程進行了xrd 、 sem 、 tg等全面的分析,對粉體的晶相結構、形貌以及性能的表徵都做了研究。
  13. Study on negative thermal expansion material zrw2o8 by x - ray diffraction method

    一種負熱膨脹性材料的物相結構分析
  14. The explosive welding specimen were also annealed in vacuum at various elevated temperature from 1000 to 1300. optic microscope, sem, tem and eds ( electron diffraction scattering ) techniques are applied to observe the microstructure and the element profiles of the welding interface and the interdiffused layer, reveal the interdiffused performance of alloy elements at elevated temperature, and analyze the structure and composition of the precipitated phases. moreover, the tensile strength of welding line with the two different techniques and various welding parameters were carried out

    採用金、掃描電鏡、透射電鏡、能譜等多種實驗手段對焊接合層的微觀組織、高溫下nb - 1zr與不銹鋼合金元素的互擴散行為,形成的互擴散層的成分、金組織和擴散層中的析出組成和相結構等,都進行了較為詳細的分析,並且對在不同工藝、不同焊接參數下焊接的nb - 1zr合金和不銹鋼的焊縫做了強度實驗研究。
  15. Crystalline procedure and phase structure of bst powders

    鈦酸鍶鋇粉體晶化過程和物相結構研究
  16. A uniform metallurgical structure without internal flaws is assured by ( a ) quality, segregation - free billet and ( b ) high impact forces achieved on 10, 000 - 30, 000 ton presses

    通過優質,無分離鋼錠和1萬至3萬噸壓力機的沖擊力保證了沒有內部缺陷的、一致的金相結構
  17. The influence that the zr / ti ratios have on the ceramic crystal structure and its properties are studied through the research carried out about the relative respects of the fabricated samples. the increase of zr / ti ratio can result in the crystal structure transformation from the tetragonal to the rhombohedral, it can also induce the weakness in the stability of the ceramic crystal structure, for example, the drop in the curie temperature. in order to enhance the relative low mechanical quality factor of pzn - pzt system piezoceramics, component addition pb ( mn1 / 3sb2 / 3 ) o3 ( hereafter abbreviated as pms ) are introduced in to form a new psudo - tetragonal system ceramics

    為獲得具有高的機電耦合系數kp ,高的機械品質因數qm的高性能壓電陶瓷,採用二次合成法制備了不同zr ti比的鈮鋅酸鉛-鋯鈦酸鉛基( pzn - pzt )三元系壓電陶瓷材料,研究了zr ti比變化對陶瓷和性能的影響規律,發現zr ti比增大除了可以使陶瓷的相結構由四方向三方轉化外,還降低了陶瓷的的穩定性,使tc溫度下降。
  18. The surface morphologies of thin films were observed by using scan electron microscope ( sem ) and atomic force microscope ( afm ). based on grazing incidence x - ray diffraction ( gixrd ) equipment, we find that residual stress exist in magnetron sputtering plct film, in addition, the ferroelectric properties of plct thin films were measured by radiant premier lc type multifunctional ferroelectric properties test system

    利用廣角x射線衍射技術對不同濺射工藝下plct薄膜的相結構進行了研究;採用掃描電子顯微鏡( sem )和原子力顯微鏡( afm )分別觀察了薄膜的表面形貌;利用掠入射x射線衍射( gixrd )測量了薄膜的殘余應力。
  19. As increasing surfactant concentration, temperature or adding cosurfactant in certain range, the arrangement of hydrocarbon chains will change from sparse to dense which results in the structural transformation of lamellar phase from " flexible " to " planar " bilayers

    通過對散射曲線的解析,討論了表面活性劑濃度、溫度和助表面活性劑等三個方面對溶致液晶層狀相結構有序性的影響。
  20. Xrd spectra show that the bulk gan particles are wurtzite structure, and the nc gan has small domain size and the structure of solid solution phase

    Xrd果顯示經由氣凝法合成前後氮化鎵均為一六方晶系,利用塊狀氮化鎵生成的奈米粉體粒徑微細且是一種固溶相結構
分享友人