真空速表 的英文怎麼說

中文拼音 [zhēnkōngbiǎo]
真空速表 英文
absolute airspeed indicator
  • : Ⅰ形容詞(真實) true; genuine; real Ⅱ副詞1 (的確; 實在) really; truly; indeed 2 (清楚確實) cl...
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
  • : Ⅰ名詞1 (外面;外表) outside; surface; external 2 (中表親戚) the relationship between the child...
  • 真空 : [物理學] vacuum; empty space; vacuo
  1. Using jgp560c magnetron sputtering equipment, cu / ag film are deposited on cd1 - xznxte substrate by dc magnetron sputtering in order to get the influences of the main experiments parameters such as sputtering power, gas flow, vacuum air pressure, magnetoelectricity power and substrate temperature on deposition rate of film, discovered that dc sputtering power is the most key factor influencing the deposition rate

    在jgp560c型超高多功能磁控濺射鍍膜機上,採用直流磁控濺射法在cdznte晶體上制備出cu ag合金薄膜,揭示了氣體流量、直流濺射功率、勵磁電源功率、工作氣壓和襯底溫度等工藝參數對沉積率的影響規律。結果明濺射功率對沉積率的影響最大,隨濺射功率的增大沉積率快增大。
  2. While descending to 3000 feet, a barge swan shot past smashed the pilot tube ( pilot head ), air speed indicator out of order

    在下降到3000英尺的過程中,一隻大天鵝很快越過,撞壞了管。真空速表失效。
  3. It is found that if the cavity dissipation is losses and the reservoir is in vacuum, the quantum nonlocality appears periodically. when the cavity dissipation and the average photon number of the reservoir are taken into account, the initial quantum nonlocality will be lost. the rapidity of the loss of the initial quantum nonlocality depends on the amplitude of the initial field, the average photon number n and the cavity damping constant k

    結果明,如果腔場無損耗且處于庫,則量子態周期性地顯現出一定的非局域性;如果考慮到腔場的損耗和熱庫的平均光子數,那麼,量子態將會喪失它初始的非局域性,初始量子非局域性喪失的度與初始腔場的幅度、腔的衰減系數以及熱庫的平均光子數有關,場越強、平均光子數和衰減系數越大,量子非局域性喪失得就越快。
  4. Results showed that moisture content was mostly removed during sublimation period of freeze - drying, while rapidly dropped during earlier period of air - drying and gradually decreased during vacuum belt drying

    結果明:冷凍乾燥物料中的大部分水分在升華階段去除,熱風乾燥初期水分含量迅下降,帶式乾燥物料水分隨時間延長呈比較均勻的下降。
  5. The experiments show that ultrasonic motors can operate under vacuum condition, but the performance is different from that under general condition, its unloaded speed decreases significantly, while the stall - torque increases a bit

    試驗結果明,超聲電機可以在環境下工作,但性能較常態環境下有所變化,其載轉明顯下降,堵轉力矩有所增大。
  6. This machine is main used for tian di s box s paperhanging, accompany with vacuum pump artomatic absorbing the inside box, there are two kinds of pressing equipment, this equipment use brush addhere paper to inside box, the whole processing is fast than hand paperhanging, it is a revoution of making box by manmade

    此機臺主要針對天地盒的裝裱成型,配置進口,自動吸風吸住內盒,有腳踏和自動裝置控制下壓,利用走邊毛刷將粉紙整齊的在內盒上,整個過程流暢、快捷大大提高了手工裝裱難度大度慢的難題,是手工制盒的一次大革命。
  7. In order to search after its applying to expressway roadbed improvement, this paper studied consolidation characteristic and distortion law hi soft soil under positive and negative action, introducing parse explain and numerical calculation theory. additionally, based on locale experimentation, the design and construction method of vhlcp was implemented and its reinforce effect and economical character was estimated. testing indicated that the groundwork ' s intensity have increased 97 %, silt soil have vanished and outlay have saved 39 %

    根據現場試驗,確定了適合於高公路工程要求的堆載聯合預壓的設計和施工方法,並分析評價了其加固效果和經濟性,試驗明:應用堆載聯合預壓后,地基強度平均提高了97 ,地基中淤泥質土已消失;與粉噴樁加固地基相比,節省經費39 。
  8. Surface flashover across the insulators in vacuum is the major limitation of the performance of the high power system, such as high power microwave tube, pulse power switch, high - energy linear accelerator, etc. flashover studies are of considerable importance in many applications. alumina ceramics are used widely in vacuum insulation system. the flashover and charging performance have been systematically investigated on alumina ceramics in vacuum under pulse voltage ( 0. 7 / 4 ^ 8 )

    中絕緣子沿面閃絡現象是制約高功率微波管、脈沖功率開關、高能粒子加器等系統性能的主要原因,這是因為中絕緣子在一個比自身及相同間隙擊穿電場低得多的電場下就發生了面閃絡的緣故,研究中絕緣子沿面閃絡現象及其形成機理對于改善和提高系統性能有重要意義。
  9. Results of vmd experiments indicate that flux increases when feed temperature, feed rate and vacuum degree increase. but the increase of flux becomes slowly when feed rate reaches 60l. h - 1 ; flux increases with pore size rapidly, but rejection approaches zero when pore size reaches 0. 5m

    實驗明,隨進料溫度、進料流、冷側度的增大,膜通量增大;但進料流增大到60l . h - 1之後,通量隨進料流的增長變緩;膜通量隨孔徑較快地增大,但當膜平均孔徑達到0 . 5m時,截留率迅降低,已無實際意義。
  10. The results indicate that drying thickness, radiant temperature and pressure of drying chamber are the most three significant factors. there ' s hardly any relationship between freezing rate and drying time, the sublimation drying time of slow freezing material is shorter than quick freezing one, but its desorption drying time is relatively longer, so the total drying time is approximately the same. the initial freezing temperature and freezing manner has little influence on vacuum freeze drying process

    試驗明:凍干厚度、加熱板溫度、系統的度是最重要的三個過程參數;凍結率對總凍干時間沒有影響,慢凍物料的升華乾燥時間要比快凍物料短,但慢凍的解析時間相對較長,兩者的總凍干時間相差很小;初始凍結溫度對凍干過程的影響可以忽略。
  11. This paper presents the effects of some features on the productivity of raw c60 materials, such as distance and approaching speed of electrodes, helium partial pressure and arc current etc. then we separate and purify the raw materials and obtain pure solid c60 of 99. 9 % and compare the purification efficiency and effect of different fluxion phase and fixed phase and discuss the effects of the experimental conditions, such as the depositing speed, the type of the substrate, the surface structure of the substrate and the temperature of the substrate. finally, we use xps, afm, ultraviolet, infrared and raman to analyze the component, structure and feature of the films qualitatively and quantitatively

    本文首先研究了氦氣分壓、弧電流大小、電極間距以及電極推進度等實驗條件對制備c _ ( 60 )粗品產率的影響;接著選用柱色譜法分離提純得到了純度大於99 . 9的c _ ( 60 )固體,比較了不同流動相和固定相的提純效率和效果;然後採用自己改進后的鍍膜機,利用電阻式加熱蒸鍍方法,得到了純c _ ( 60 )薄膜和不同摻雜比的銀摻雜薄膜;探討了沉積率、襯底種類、襯底面結構以及襯底溫度等實驗條件對薄膜結構的影響;最後通過xps , afm ,紫外,紅外,拉曼對薄膜的成分、結構和特性作了定性和半定量分析。
  12. In the same time, this paper applied the plane strain fem based on biot theory to analyzed calculated result and observation information hi scene. finally, this paper put forward a settlement forecast model based on the modified gaomujunjie method, using by inversion analysis theory to compare and analyze the settlement process of vhlcp. result indicated that the model inosculated with the fact data and the consolidation degree have finished 86 %, back - work settlement was 87mm

    最後,根據實測沉降資料,採用一維反演分析法,推導最終沉降量計算公式,結合改進后的高木俊介固結度計算方法,建立堆載聯合預壓的沉降預測模型,並根據計算結果,對比實際沉降過程,對比明:所建沉降預測模型與實測數據吻合,由此所得現場試驗的地基平均固結度達86 ,剩餘沉降為87mm ,滿足高公路質量要求。
  13. The increase of vacuum energy can not accelerate the surface settlement when the flow is small

    在出水量已較少的情況下,增加能量並不能加快地的沉降率。
  14. The best process for high quality tio _ ( 2 ) thin film deposited on k9 glass by reb is studied by using orthogonal test method, the se results indicate that the best process for tio _ ( 2 ) thin film deposition is the substrate temperature of 300, the total gas press in the chamber of 2 x 10 ~ 2pa and the deposition rate of 0. 2 nm - s - 1, of which the substrate temperature has influence on the optical properties of the deposited films notably

    文中首先以tio _ 2薄膜的折射率和消光系數為研究對象,採用l9正交試驗法研究了在k9玻璃上制備高光學質量tio _ 2薄膜的最佳工藝條件。橢圓偏振儀的測試結果明,制備tio _ 2薄膜的最佳工藝條件為:基片溫度300 ,工作2 10 ~ ( - 2 ) pa ,沉積率0 . 2nm ? s ~ ( - 1 ) ,其中基片溫度對薄膜光學常數的影響最大,該結果具有較好的可重現性。
分享友人