瞬壓曲線 的英文怎麼說

中文拼音 [shùnxiàn]
瞬壓曲線 英文
insochrone
  • : Ⅰ名詞(眼珠一動; 一眨眼) wink; twinkling Ⅱ動詞(眨眼) wink
  • : 壓構詞成分。
  • : 曲名詞1 (一種韻文形式) qu a type of verse for singing which emerged in the southern song and ji...
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. Linear induction motor is an important kind of machines which have some merits such as simple structure, low cost, durability, convenience for maintenance etc. the subject of this thesis is to study a big circular ring linear induction motor, and the major works in this thesis are summarized as follows : ( 1 ) considering the effects of the finite length of primary core, one - dimension analytical solution for the air gap field is cited in this paper. based on it, the single layer winding magnetic field is studied. considering whole - pitched and short - pitched winding configuration with odd poles and half - fulled slots in both ends, the double - layer winding magnetic field is analyzed, respectively

    本文對大圓環直感應電機進行了深入細致研究,內容包括: ( 1 )本文採用有限長行波面電流作用於有限長鐵芯上的模型,引用了氣隙磁場一維解,研究了單層繞組磁場,奇數極半填槽雙層繞組在採用整距和短距時磁場的分析、比較,簡單介紹了二維解; ( 2 )用有限元軟體ansoft對大圓環直感應電機空載氣隙磁場進行了靜態分析,並分析了結果; ( 3 )用軟體進行了額定電下的態分析,得到了轉矩,位移,轉速隨時間變化圖,利用單極性霍爾元件測定轉速並與軟體計算結果進行了比較,採用等效電路法計算了堵轉時的最大電磁力並做實驗進行了驗證,由實驗測得了三相電流波形,並與計算結果進行了比較,對其不對稱性進行了定性分析。
  2. First, the dynamic stability of braid composite cylindrical shells with the influences of some main factors is introduced. the general governing equations for the nonlinear dynamic stability is obtained. by the hamilton principle. the creep buckling analysis of braid composite cylindrical shells under axial compression and the dynamic stability under nonconservation force are discussed as emphases. in creep buckling question, by means of theoretical analysis, the instaneous critical load and durable critical load of viscoelastic braid composite cylindrical shell under axial compression are obtained and the numerical example is given

    首先介紹了編織復合材料圓柱殼在幾種主要因素影響下的動力穩定性問題,用hamilton原理建立非性動力穩定性問題的一般性基本方程。然後重點討論了編織復合材料圓柱殼軸下的蠕變屈問題及非保守力作用下的屈問題。對蠕變屈問題,通過理論分析來得到了編織復合材料圓柱殼的時彈性臨界載荷和持久臨界載荷,給出了具體的算例。
  3. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路,以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電時值反饋控制策略,給出了變換器的外特性、關鍵電路參數、與電網電n倍頻或n分頻信號同步的基準正弦電路的設計。
  4. While working in offline ( no pc ) mode, additionally to normal transducer, it has soft - startup function and fast - stop function. and the input of frequency and voltage - coefficient is optional. while working in online mode, additionally to working in offline mode, it can process, display, save and load waveform, which is specialty of computer

    脫機工作(無pc )時,它除具有一般變頻器功能外,還具有軟啟動功能、頻率和電輸入源可選、急停功能等;在聯機工作時,除具有脫機工作的全部功能外,還具有計算機特有的圖形處理、顯示、存取能力,包括態波形、各種參數動態過程等。
  5. The effect of uneven power and compression condition of each cylinder of diesel engine on the crankshaft instantaneous rotation ( velocity and acceleration ) curves and their interrelationship in different cylinder numbers and rotation speeds have been thoroughly analyzed by means of the crankshaft instantaneous rotation curves simulated by computer

    本文通過計算機模擬出多缸內燃機各種作功和縮狀況下的時轉動(速度和角加速度) ,詳細分析在不同缸數和不同轉速條件下,柴油機各缸作功和縮功不均衡對時轉動的影響及其內在聯系。
  6. Based on a number of charging and discharging experiments, a thought is put forward that the polarization may be detected according to the terminal voltages at charging, terminal voltage at the short pause, and the soc ( state of charge ) ; the depolarization by momentary discharge according to the reference of optimal curve

    在論文撰寫過程中,作者主要進行了如下方面的研究: -對鉛酸蓄電池的電化學機理進行充分研究,並在大量充放電實驗的基礎上,提出了依據蓄電池充電時和停充間的端電和蓄電池荷電狀態檢測蓄電池極化狀況的思想。 -依據最佳給定,採取間放電減少極化。
  7. The study of the effect of material properties and dimensions and loading currents on liner buckling, using a capacitor bank as a driver, indicates that the mode number for buckling increases with the ratio of radius to thickness of a liner, and the yield strength to plastic hardening modulus, but keeps invariable with the increase of loading current, and that the magnitude of buckling increases with the loading current

    用電容器組脈沖發生器裝置作為驅動源,設計4種不同材料、不同尺寸的金屬套簡,通過調節電容器組的充電電得到不同的加載電流,研究材料及幾何參數、加載脈沖特性對套簡屈的影響;採用態非性有限元方法對實驗結果進行了數值模擬。
  8. The apparent activation volume calculated by the model is about 2500a3, which was ten times larger than that of usual amorphous alloy and was at the same range of the amorphous polymer. the model shows the main deformation mechanism of nanocrystalline ag is grain boundary sliding, which in some extent declares the similar forms of equation with amorphous alloys. with the ananlysis to the hrem of nanocrystalline ag, the discrepancy of the apparent activation volume between the nanocrystalline ag and amorphous alloys is interpreted by the loss of atoms participating in grain boundary sliding without enough reconstruction by the movement of atoms under the low temperature

    運用晶界滑移的熱激活理論對縮實驗結果進行了數值擬合,擬合與實驗數據符合很好,得到了晶界滑移的表觀激活體積(熱激活基本單位體積與局域態應變的乘積) ,約為2500a ~ 3 ,先當于幾十個原子體積大小的態變化,約為非晶合金的10倍以上,與非晶高聚物的表觀激活體積相當。
  9. This paper selects the pulsating wind power density spectrum of davenport and simulates the wind speed time series and the wind load time by matlab. considering the vertical and horizontal correlation of the pulsating wind, the study make use of the time domain analysis of buffeting to carry out the transient dynamic analysis of the whole frame structure which is loaded by the random pulsating wind load. finally, in terms of the whole frame of the pipe belt conveyor, the evaluation for

    選取davenport脈動風功率譜,利用matlab模擬脈動風的風速時程和風荷載時程,並考慮脈動風的空間豎向和側向相關性,利用抖振時域法對整體機架結構進行隨機脈動風作用下的態動力學分析,最後再對圓管帶式輸送機整體機架結構對環境風荷載的適應性做出評價。
  10. Taking single four - quadrant power switch mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy, the auxiliary switching power supply and parallel technology of this kind of converters are investigated. the output characteristic curve and the design for the key circuit parameters are given

    以單四象限功率開關式電路拓撲為例,分析研究了這類變換器工作模式、穩態原理與電時值反饋控制策略,給出了變換器的外特性、關鍵電路參數、機內輔助開關電源的設計,對電流源高頻交流環節ac ac變換器並聯擴容技術進行了研究。
  11. Taking single four - quadrant power switch mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of current mode ac - ac mode ac / ac converters with high frequency link are investigated. the output characteristic curve and the design for the key circuit parameters are given

    以單四象限功率開關式拓撲為例,分析研究了電流源交?交型高頻環節ac ac變換器的工作模式、穩態原理與電時值反饋控制策略,給出了變換器的關鍵電路參數的設計準則和變換器的外特性
  12. For the pin diode, its major transient behaviors are forward voltage recovery and reverse current recovery. this dissertation describes these performances by lumped - charge approach, and then developed an improved lumped - charge model for pin diode and a corresponding parameter extraction approach, which can reduce parameter measurement and enhance parameter accuracy

    Pin二極體中主要的態現象是正向電恢復和反向電流恢復,本文採用集總電荷的方法描述了它的動、靜態特性,提出了改進的集總電荷的pin二極體高頻模型,同時提出了改進的擬合模型參數抽取方法,減少了所需的參數測量實驗並提高了參數抽取的精度。
分享友人