瞬態分佈 的英文怎麼說

中文拼音 [shùntàifēnbù]
瞬態分佈 英文
transient distribution
  • 瞬 : Ⅰ名詞（眼珠一動; 一眨眼） wink; twinkling Ⅱ動詞（眨眼） wink
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 瞬態 : transient; instantaneous condition; transient state
  1. In the chapter two we discussed that the server would first use speed - 1 to serve customers when the system entered the busy state from the empty state, but when the server found the number of customers in the system exceeded the thresh - n during serving, after finishing the service of current customer it would use speed - 2 to serve the next customer till there is no customer. by the method of supplementary variable, l - transition and constructing vector markov, we attained the distribution of the queue length, the distribution of wait - time, the distribution of stay - time, the utility and etc. in the last part of this chapter, we discussed the optimal n * for thresh n which minimizing the cost function and we illustrate the cost function behaves for various parameter selections by a numerical study

    在本文第二章討論了當系統從空閑進入忙期時是服務臺以速度1進行服務，但一旦對某顧客服務完畢時如發現系統中的顧客數超過n值時就以速度2服務后續顧客直到系統變空的可修排隊系統，通過構造各種向量馬氏過程和吸收向量馬氏過程，獲得了瞬態、穩態隊長分佈、等待時間分佈、逗留時間分佈、更新周期分佈等一系列排隊指標以及可用度、可靠度等一些可靠性指標，在本章最後又從系統如何更好節省費用角度出發討論了門限n的最優取值問題，並利用mathematic軟體對費用函數進行了數值模擬。
  2. In this method of measuring time - resolved spectrum, a special light beam modulator translates the time - distribution of an optical spectrum into a space - distribution of light intensity of the light beam, and the space - distribution spectrum is dispersed by a multi - spectrometer, then it is detected by an ordinary 2 - d ccd array detector

    瞬態時間分辨譜測量方法的主要思想：使用特殊光束調制器把光譜隨時間的變化過程轉化為光強的空間分佈，經色散后，以二維探測器接收並轉換光信號為電信號，用通用計算機控制採集並處理光譜數據。
  3. Then after analyzing the heat conduction in laser diode array, we simply simulate the transient thermal behavior of high power laser diode array and build a two dimensional static model of temperature distribution of it by fem ( finite element method )

    接著分析激光器陣列中熱的傳導，簡單的模擬工作工程中瞬態溫度的變化。然後通過有限元分析法，建立二維溫態分佈，得到穩態工作時，大功率激光器陣列中晶元和載體的溫度的空間分佈。
  4. In this paper, spindle fem computation model taking solid as basic unit is established. based on this model, firstly, static stress is analyzed and the stress distribution of spindle under various static woking condition is attained ; secondly, transient analysis is carried out

    本文建立了以實體單元為基本單元的大軸有限元計算模型，在此模型基礎上首先進行靜應力分析，得到各靜工況下的應力分佈；隨后進行瞬態的沖擊載荷分析。
  5. After simulating the model of water hydraulic valves, the velocity distribution, pressure distribution, energy distribution can be obtained and relations between the valve channel and the energy loss, the negative pressure distribution can be analyzed, which offers the theory foundation for designing water hydraulic valves with the high efficiency, low energy loss and low noise

    通過對水壓閥模型的cfd穩態和瞬態解析，可以得到水壓閥內流場的速度分佈、壓力分佈及能量分佈，據此定性分析流道結構（速度、壓力、流動的分離與再附壁，旋渦的產生與消失等）與能量損失、負壓分佈等的關系，從而為設計出高效率、低能耗、低噪聲的水壓閥提供理論依據。
  6. The paper establishes mathematics model of electromagnetic heating system of eddy current field and temperature field, and gives corresponding discrete format with elements as eight nodes, hexahedron equal cell, through calculating eddy - current field to gain the internal heat source that the temperature field needed, to use discrete method to solve the problem of induction - heating part ' s temperature field by axial symmetrical electromagnetic, and then to analyze the characteristic of instantaneous temperature field

    本文建立了電磁加熱系統的渦流場和溫度場間接耦合的數學模型，分析了不同頻率下渦流和溫度的分佈情況，並以八節點六面體等參元為例給出了渦流場對應的離散格式，通過計算渦流場獲得溫度場所需要的內熱源強度，加熱部件的溫度場以軸對稱格式進行離散求解，並對瞬態溫度場有限單元法的求解特點進行了分析。
  7. Firstly, a finite element approach combining the temperature parametric method with real fictitious elements scheme was proposed for simulating the winding tension process ; secondly, in accordance with the cure kinetic and heat transfer theory, a corresponding finite element method was employed to calculate the distributions of temperature, cure degree and thermal stress fields during the cure process

    根據固化反應動力學理論和熱傳導理論，對具有金屬內襯的復合材料纖維纏繞壓力容器在固化工藝過程中瞬態溫度、固化度和熱應力場分佈及其變化規律進行了數值分析。
  8. The transient temperature and thermal stress distribution in disk of heat capacity laser pumped by high power lda are simulated by use of finite element methods, optical distortions and birefringence were computed subsequently

    摘要利用有限元數值方法，模擬計算了熱容模式下片狀激光介質的瞬態溫度分佈和熱應力分佈及其波前畸變和應力雙折射。
  9. Based on a 3 - d transient thermal model with inhomogeneous heat generation, the temperature and thermal stress distribution in the disk of heat capacity laser pumped by high power laser diode array ( lda ) are simulated and analyzed by means of finite element methods

    摘要為了研究激光介質熱畸變對固體熱容激光器的影響，數值計算了高功率激光二極體陣列抽運片狀激光介質的瞬態溫度場和熱應力分佈。
  10. Using data - collecting system developed by ourselves and controlling different parameters, the author monitors the phenomenon of transient boiling and measures the temperature signal. in order to verify the experimental results, numerical simulation of the steady temperature field is carried out before the transient experiment

    利用自行開發的數據採集程序系統對瞬態沸騰現象進行監控和溫度信號的測量；並對瞬態試驗前的穩態溫度場進行了數值模擬，通過與穩態試驗數值的比較，來驗證實驗件的溫度場分佈。
  11. The field in large - aperture photoconductors is mainly composed of bias field, space - charge field formed by transient distributing of carriers

    光電導體內的電場是偏置電場、光電導體內光生載流子的空間瞬態分佈所形成的空間電荷電場等疊加形成的合電場。
  12. Computation of the transient temperature distribution of the spar - rib of the rlv during the reentry

    可重復使用飛行器翼肋的再入瞬態溫度分佈計算
  13. Moreover, the theoretical formula were applied in combination of practical example, with the temperature distribution along the radial direction in a transient state proposed

    並結合算例給出了在短時超高溫條件下煙囪筒身沿徑向的瞬態溫度分佈。
  14. In this paper, the repairable queuing system with police is studied. some important queuing quantities and reliability quantities are in detail discussed as follows : ( 1 ) using the renewal process theory and the method of stochastic decomposition, both the transient and equilibrium distributions of the queue length from any state are discussed, and the recursion expression of the equilibrium distribution is given by furthermore, the generating function of equilibrium queuing length distribution is given by ( 2 ) the distribution of waiting time is discussed, and the mean waiting time is given by ( 3 ) the departure of the system is discussed, and the mean value of departure customers when is given by

    具體如下： （ 1 ）利用更新過程理論和隨機分解方法，討論了從任意初始狀態出發隊長分佈的瞬態解和穩態解，得到了隊長平穩分佈的遞推公式：並進一步求得了系統的穩態隊長分佈的母函數（ 2 ）討論了穩態等待時間分佈，求得了平均等待時間： （ 3 ）討論了系統的輸出過程，求得了長期單位時間內離去顧客的平均數： （ 4 ）討論了服務臺的不可用度，得到了穩態不可用度: （ 5 ）討論了內服務臺平均故障次數，求得了長期單位時間內的平均故障次數
  15. In chapter 5, we make numerical calculation, then analyze the properties of the population distribution, the gain, the coherence term and population difference, and validate the transient light amplification mechanism of this system

    第五章我們根據數值計算結果分析了粒子數分佈、增益、相干項和粒子數差的瞬態演化過程，驗證了系統產生增益的機制。
  16. In this paper, the wind loading time history of the truss structure is simulated according to the data of wind tunnel experiment and pulsating wind spectrum, and the transient dynamic analysis is used on the fem

    本文依據風洞試驗數據模擬了靜風壓的空間分佈，依據脈動風譜模擬了網架結構的風荷載時程，並對有限元模型進行了有限元瞬態動力學時程分析。
  17. Applying the method studied in this thesis, theoretical calculation of certain container ship in regular wave has been done on ship motion and hydrodynamic pressure. it also has the results compared with those obtained under multipole conditions in the model tests. as a consequence, we abstract some characteristics of the distribution of instantaneous hydrodynamic pressure on ship wet surface, and the distribution changes with forward speed and wave parameters

    利用本文方法對某集裝箱船進行了規則波中的船舶運動和水動壓力的理論計算，並與船模水池試驗所提供的多狀態的壓力分佈數據相比較，得出船體表面瞬時壓力的分佈及其隨航速和波浪參數變化的某些規律。
  18. Prediction of hydrodynamic pressure. the thesis presents a practical engineering method to predict the hydrodynamic pressure on instantaneous wet ship surface

    關於水動壓力預報：本文提出了基於二維擾動流場頻域穩態解的一種預報船體瞬時濕表面壓力分佈的工程實用方法。
  19. Mean velocity distribution, mean length of recirculation region and the structure of instant stream are presented by the experimental data, which help us understanding character of this flow further

    實驗給出時均流速分佈、時均迴流區長度和瞬態流動結構，探討了后臺階分離流流動特性。
  20. The maximum heating rate of absorber is o. skw. ? h / ? inside experiment fuel rod is much lower than that outside experiment device. influence of absorber movement on thermal neutron flux decreases, as radial distance between absorber and measuring point increases

    給出了硼不銹鋼和銀分別做為吸收體的兩種方案的計算結果，即有效增殖因子keff 、中子通量密度分佈、燃料棒功率、吸收體組分及其發熱，並進行了分析、比較，為瞬態試驗裝置的設計提供了參數。
分享友人
分享到 Line

分享到臉書