瞬態試驗 的英文怎麼說

中文拼音 [shùntàishìyàn]
瞬態試驗 英文
transient wave test
  • 瞬 : Ⅰ名詞（眼珠一動; 一眨眼） wink; twinkling Ⅱ動詞（眨眼） wink
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 瞬態 : transient; instantaneous condition; transient state
  • 試驗 : trial; experiment; test
  1. On the basis of experimental research, this thesis applies 2 - dimensional non - linear finite element method to the analysis of transient temperature field on the section by means of relatively high precision triangular element of six joints. when the temperature field is analyzed, finite element reseaus are divided in space field and finite difference reseaus are divided in time field, and then the program is compiled. the computing results are in good agreement with the test data

    在試驗研究的基礎上，本文採用精度較高的三角形六結點單元對構件截面二維非線性瞬態溫度場進行了有限元分析，即在空間域內採用有限元網格劃分，在時間域內採用有限差分網格劃分，據此編制了計算程序，計算結果與試驗數據符合較好，程序穩定性好，精度滿足要求。
  2. Based on a cone - shaped compound heatshield, a series of research work has been done from the investigation of theoretical analyses of ablative and insulating principles and technical experiments. 1 based on the exploration of improving material performances, a feasible scheme of adding insulating functional layer is proposed ; 2 a simplified calculation method is proposed via establishing fea ( fmite element analysis ) and instantaneous heat transmission is calculated with the mentioned method ; 3 a practical engineering scheme is proposed through a series of experiments ; 4 the interface problems of the function layer are solved through co - curing method and successful samples are manufactured ; 5 in order to estimate properties, the heatshield was anatomized engineering applied possibility is explored on the analyses of performance evaluation by testing mechanical properties, coefficient of heat conductivity and doing dynamic ablative experiments, also, the comparison with that of the required materials is done

    本文以一錐形復合防熱套為研究對象，從燒蝕、隔熱機理的理論分析和工藝試驗兩方面，進行了一下研究工作： 1 、通過對提高材料及製品通過對提高材料及製品隔熱性能的多種途徑進行探討，提出了採用添加隔熱功能層，研究復合型大面積防熱套是理論有效、工藝可行的方案； 2 、通過建立有限元分析模型，對防熱套的燒蝕隔熱行為進行了理論分析，提出了簡化的隔熱計算方法，並用該方法對復合型防熱套的瞬態傳熱模型進行了分析計算； 3 、通過復合型防熱套的工藝探索試驗，提出了一種工程應用上切實可行的工藝方案。
  3. Reciprocating internal combustion engines - exhaust emission measurement - test cycles and test procedures for field measurement of exhaust gas smoke emissions from compression ignition engines operating under transient conditions

    往復式內燃機.排放測量.壓燃式發動機瞬態工況時排氣煙度現場測量用試驗周期和試驗方法
  4. The innovation points in this thesis are : ( 1 ) before the collection of transient r - surface wave data, selected the parameter of impulse, receive, and observation in the experiment. ( 2 ) estimated the bearing capacity of foundation with multi - parameter

    本論文的創新點： （ 1 ）在瞬態瑞雷面波資料採集前，通過試驗重點討論和選擇了瞬態瑞雷面波採集的激發、接收方式和觀測因素等參數； （ 2 ）多參數神經網路綜合預估地基的承載力。
  5. Development and experimental investigation on the pt - film gas instantaneous temperature sensor

    鉑電阻瞬態氣體溫度傳感器研製及試驗驗證
  6. This paper establishes the linear model of hydro - turbine and deducts its transfer coefficients. then the optimized operation parameters are gained in the frequency disturbance and load rejection simulation. through comparing dynamically, this paper analyses the impact on its dynamic performance if some governing system parameter changes

    在研究小波動情形時，即系統在穩定工作工況點附近小瞬變時，可以把非線性系統進行線性化處理;本文建立了水輪機調節系統的線性化模型，推導了其中的傳遞系數;對水輪機調節系統的頻率擾動和機組突甩負荷工況進行了模擬試驗，整定了最佳調節參數;通過動態比較，分析了調節系統參數改變對其動態性能的影響。
  7. The outcome shows that such digital electronic speed governor is in possession of stable timing rate of 1. 0 % and instantaneous timing rate of 6. 2 %. and it is worth a wide popularization for its simple structure and low cost

    在對hondagx31汽油機進行了大量試驗后結果表明：在標定轉速6000r min時，該電子調速器可以達到1 . 0的穩態調速率和6 . 2的瞬態調整率，優于國家標準的要求。
  8. This paper presents the basic method of controlling fire sensitivity of eeds by the transient pulse test, reviews the further development of the nondestructive inspecting of fire sensitivity of eeds, and considers that there are more properties to devlop the method for predicting the property of one eed individually and its interrelated instrument

    介紹了電火工品用瞬態脈沖試驗控制感度的基本方法，討論了電火工品發火感度無損檢測的發展前景，認為發展單發性能預測和相應的儀器有很大的可能性。
  9. We employed the saturated water as boiling medium to make tests with different liquid level. some conclusions were obtained and verified

    我們使用飽和水作為工質，在不同的液位下做了瞬態沸騰的對比試驗。
  10. Using data - collecting system developed by ourselves and controlling different parameters, the author monitors the phenomenon of transient boiling and measures the temperature signal. in order to verify the experimental results, numerical simulation of the steady temperature field is carried out before the transient experiment

    利用自行開發的數據採集程序系統對瞬態沸騰現象進行監控和溫度信號的測量；並對瞬態試驗前的穩態溫度場進行了數值模擬，通過與穩態試驗數值的比較，來驗證實驗件的溫度場分佈。
  11. Reciprocating internal combustion engines - exhaust emission measurement - part 10 : test cycles and test procedures for field measurement of exhaust gas smoke emissions from compression ignition engines operating under transient conditions

    往復式內燃機.廢氣排放測量.第10部分:壓力點火燃式發動機在瞬時工作狀態下排放的燃氣煙霧現場測量的試驗周期和試驗程序
  12. By using the data of the experiment, this dissertation has analysed the relationship between the dynamic parameter and the self - property, then based on the elastic half space theory of the dynamic foundation, this dissertation get the method to measure the density of silt or sand subsoil using instantaneous implusion

    本文通過試驗獲得的數據，分析地基土的動力參數與土體的本身性質之間的關系，並應用動力基礎半空間理論，得到了全新的利用瞬態錘擊法來測定粉砂土的密實度的方法。
  13. On the base of the whole model structure, it realized the dynamic display of the transient fluid parameters in the conduit according to data available

    在整體模型構建的基礎上，根據試驗數據和計算數據，實現了輸水系統中流體瞬變物理量的動態的演示。
  14. In this paper, the wind loading time history of the truss structure is simulated according to the data of wind tunnel experiment and pulsating wind spectrum, and the transient dynamic analysis is used on the fem

    本文依據風洞試驗數據模擬了靜風壓的空間分佈，依據脈動風譜模擬了網架結構的風荷載時程，並對有限元模型進行了有限元瞬態動力學時程分析。
  15. Applying the method studied in this thesis, theoretical calculation of certain container ship in regular wave has been done on ship motion and hydrodynamic pressure. it also has the results compared with those obtained under multipole conditions in the model tests. as a consequence, we abstract some characteristics of the distribution of instantaneous hydrodynamic pressure on ship wet surface, and the distribution changes with forward speed and wave parameters

    利用本文方法對某集裝箱船進行了規則波中的船舶運動和水動壓力的理論計算，並與船模水池試驗所提供的多狀態的壓力分佈數據相比較，得出船體表面瞬時壓力的分佈及其隨航速和波浪參數變化的某些規律。
  16. Reciprocating internal combustion engines - exhaust emission measurement - test cycles and test procedures for test - bed measurement of exhaust gas smoke emissions from compression ignition engines operating under transi ent conditions

    往復式內燃機.排放測量.壓燃式發動機瞬態工況排氣煙度試驗臺測量用試驗周期和試驗方法
  17. Two kinds of absorber, boron carbide and silver, are calculated respectively

    介紹了瞬態試驗的目的、內容及研究方法。
  18. Transient experiment is introduced, whose research method is that absorber is moved down and up with different speed, power of fuel rod changes with different speed as well, so behavior of fuel rod will be studied. physics design is most important in transient experiment

    本文簡述了國內外壓水堆高性能燃料棒研究的發展情況，提出了我國進行壓水堆高性能燃料棒瞬態行為堆內試驗（以下簡稱瞬態試驗）的緊迫性、必要性和可能性。
  19. The maximum heating rate of absorber is o. skw. ? h / ? inside experiment fuel rod is much lower than that outside experiment device. influence of absorber movement on thermal neutron flux decreases, as radial distance between absorber and measuring point increases

    給出了硼不銹鋼和銀分別做為吸收體的兩種方案的計算結果，即有效增殖因子keff 、中子通量密度分佈、燃料棒功率、吸收體組分及其發熱，並進行了分析、比較，為瞬態試驗裝置的設計提供了參數。
  20. In the experiment of testing instantaneous characteristics for circuit breaker, the transient current exists in the experimental circuit because of the closing making angle, which has serious influence on the testing precision

    斷路器進行瞬動特性試驗時，由於合閘相角的原因，試驗電路中會產生暫態電流，暫態電流的存在對試驗精度產生嚴重的影響。
分享友人
分享到 Line

分享到臉書