矩形膜 的英文怎麼說

中文拼音 [jǔxíngmó]
矩形膜 英文
rectangular membrane
  • 矩 : 名詞1. （畫直角或正方形、矩形用的曲尺） carpenter's square; square2. （法度; 規則） rules; regulations 3. [物理學] moment
  • 膜 : 名詞1. [生物學] （像薄皮的組織） membrane 2. （像膜的薄皮） film; thin coating
  1. The best optimum mathematical model is constituted. scalar factor of structural parameter on loop rectangular negative pressure and adsorption slide is calculated. structural parameter, air gas source pressure carrying capacity and thickness of air cell are made sure by hydrodynamics and the theory of gas lubrication

    詳細論述了導軌副的設計過程，運用數學上的拉格朗日條件極值求解法，建立最優化數學模型，求出環矩形負壓吸附導軌的結構參數的比例情況，並運用流體力學和氣體潤滑理論確定了環矩形負壓吸附導軌的結構參數、氣源氣壓、承載能力和氣膜厚度的確定性結論。
  2. In this thesis, mainly by fmr, combined with moke and magnetic measurement, systematical studies have been made on the magnetic properties, especially magnetic anisotropy in epitaxial single crystalline fe ultathin films on gaas and inas substrates in polycrystalline thin films and in polycrystalline nife and nifeco patterned films of micron and submicron rectangular elements arrays

    本論文以鐵磁共振為主要研究手段，輔助以磁性和磁光測量，對外延于gaas及inas上的不同厚度的單晶fe超薄膜、不同厚度的nife多晶薄膜和電子束光刻的多晶nife和nifeco單層利三明治結構的微米及亞微米矩形單元陣列圖形薄膜的磁性，特別是磁各向異性進行了較為系統的研究。
  3. The light guiding unit on the surface is composed of sub - micron gratings whose transmission wavelengths are red, green and blue in order. the light source are red 、 green 、 blue led or semiconductor laser array. to enhance the light utilization, the surfaces of light guide plate except the incident and transmitted surfaces are coated with metallic film

    本文設計的亞微米光柵型導光板為矩形狀的，導光板上表面的導光單元是由三套出射光主波長分別是紅光632 . 8nm ，綠光521nm ，藍光441 . 6nm的亞微米光柵組成，光源採用的是紅、綠、藍三色發光二級管或者半導體激光器陣列，為了提高光能利用率，除入光面和出光面外，導光板其餘面都鍍上金屬膜。
  4. Detail specification for polystyrene film dielectric capacitors, extended foil - rectangular non - metallic case, unidirectional terminations - full plus additional assessment level

    聚苯乙烯薄膜介質擴展箔電容器詳細規范.單向終端矩形非金屬殼.全面附加評定級
  5. Chapter two constructed the mathematical model of robot and its environment solved by the fem analysis. the functions or relations between the robotic parameters and its drive forces, thickness or its velocities were given, and also the functions or relations between the environment and the robot force, friction, robot velocity, minimum thickness of film or sustain force of dynamic films were given

    論文第二章通過建立機器人和環境的數學模型，利用有限元方法求解其中的n - s方程，得出管道中微型機器人的各種設計參數與機器人的驅動力、形成的最小潤滑油膜厚度和機器人的運行速度之間的關系曲線，研究了管道環境與機器人驅動力、摩擦阻力矩、機器人運行速度、形成的最小潤滑油膜厚度、油膜的承載能力之間的關系。
  6. Due to great advantage of the excimer laser in photoelectron material, photoelectron technology research, so in this thesis, a xecl excimer laser is designed in order to solve some problem in semiconductor film, cmr film, quartz film and other kind of film application, optical etching field, interaction between laser and material, material plasma study. the parameters of the excimer laser is e also measured and analyzed

    因此本文以氣相沉積、外延生長、巨磁薄膜、金剛石及其它薄膜制備及后續的光刻，激光與物質的相互作用，等離子體研究為目的，研製獲得了激光脈寬18ns ，單脈沖能量150mj ，矩形光斑大小2cm 1cm ，束散角3mrad ，最高重復頻率5hz的xecl準分子激光器。
  7. In chapter 5, using coordinate graphs, the influences of rectangular screw, trapezoidal screw and serrate screw on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are compared and analyzed

    第五章，通過坐標圖對比分析了微型機器人在矩形螺紋、梯形螺紋、鋸齒形螺紋下，各螺紋參數對軸向摩擦牽引力、最小粘液膜厚度、粘液膜承載能力、周向摩擦阻力的影響。
  8. In chapter 2, an accurate modified reynolds equation is derived. the modified reynolds equation is solved numerically with the finite different method, the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction under the rectangular screw are obtained. at last, using numeral methods and coordinate graphs, the influences of rectangular screw parameters on the generated axial thrust force, minimal mucus film thickness, load capacity of hydrodynamic pressure and circumferential friction are studied and analyzed

    第二章，首先推導了非牛頓流體的變形雷諾方程，化簡了雷諾方程，得出了矩形螺紋下有限差分方程；還推出了矩形螺紋作用下軸向摩擦牽引力、粘液膜厚度、粘液膜承載能力、周向摩擦阻力無量綱表達式，最後用數值計算方法求解，通過坐標圖分析了矩形螺紋參數對軸向摩擦牽引力、最小粘液膜厚度、粘液膜承載能力、周向摩擦阻力的影響。
  9. When in experiment, the air was heated by the film heater installed on the above and below surface of channel, adopting various air velocity of flow, test import ' s and export ' s temperature, wall temperature, fluid flux and the drop of pressure, and the other parameter. adopting nu and nu0 to analyze the baffle ' s situation of heat transfer and fluid flow, which baffle was holed various diameters

    實驗時，通過矩形通道上下壁面敷設的電加熱膜加熱通道空氣，改變空氣流速，測試不同工況時的進出口溫度、壁面溫度、流體流量和壓力損失等參數，並採用無量綱努謝爾特準則數nu 、 nu _ 0等分析了設置不同開孔折流板的換熱與流動情況。
  10. According to the integral characteristic of pvdf film, two pvdf sensors are designed to measure adjoint coefficient of sound radiation mode in this paper. based on the theory of sound radiation and two - dimensional modal sensors equation, and taking a simply supported plate as example, we measure mode l, mode 2 and mode 3 adjoint coefficient of its sound radiation by the sensors

    本文是在聲輻射模態理論以及兩維分散式壓電傳感器方程的基礎上，利用pvdf獨特的積分特性，以簡支矩形板為例，設計了pvdf壓電薄膜傳感器用於測量簡支板第一、二、三階聲輻射模態伴隨系數。
  11. This thesis presents the theoretical analysis about the design of the tunable antennas with multilayered structure theory and microstrip antenna ' s analytical methods. and it improves three typical kinds of antennas, and uses the voltage controlled ferroelectric materials. we analyze the tuning features of the antenna by simulation under the condition of different permittivity of the ferroelectric materials, and discuss the feasibility of improvement from microstrip antenna to tunable antenna

    本文結合多層介質理論及微帶天線的分析方法對可調諧天線進行理論分析，並對矩形貼片天線、圓形貼片天線、微帶振子天線三種典型的微帶天線結構進行改進，引入壓控鐵電薄膜材料，模擬分析在改變鐵電薄膜介電常數條件下天線的調諧特性，討論微帶天線改進為可調諧天線的可行性。
  12. A novel e - plane metal insert waveguide filter is presented in this paper. comparing to conventional e - plane waveguide filter, great improvments have been made in stop - band attenuation of a bpf

    為了提高e面全金屬膜片矩形波導濾波器的阻帶性能，本文對濾波器的結構做了改進，採用了混合膜片的形式。
  13. We testify limitations of the most famous two - dimensional pde for sound synthesis in its princilpes for rectangle and circle membrances. 4

    以矩形膜和圓形膜為例，從理論上詳細地分析了傳統二維阻尼振動方程的局限性。
  14. And designed a program used by this method to design a filter. the result complies with the analytic result. at the end of this paper, according to the project of airline broadcast, the author designd filter with high rectangular factor, five channelizing filter banks, saw programmable correlator implemented with multiplayer muti - chip technology, saw resonator

    本文的最後，結合某航空直擴數傳電臺的工程要求，設計了高矩形系數的前置濾波器、聲表面波濾波器組、採用多晶元組裝厚膜工藝技術的聲表面波可編程相關器和聲表面波壓控振蕩器，完成了解調解擴單元的硬體設計。
  15. Both the effect of substrate deformation and the state of large deflection of the microbridge are involved in the theoretical expression. furthermore, the distribution of axial stress in the micro bridge is discussed in detail by taking different shapes of cross section into consideration. and a shape factor is introduced into the expression, which simplifies the theoretical expression

    理論上對薄膜微橋法的公式進行了進一步的化簡，在考慮襯底變形貢獻和大撓度的基礎上，進一步探討了微機械加工過程中不同橫截面形狀的情形；並對矩形和梯形截面微橋的軸向應力分佈作了分析，補充和發展了薄膜微橋法的理論；引入了橫截面形狀修正因子，簡化了公式的表達和計算。
  16. The axial frictional pulling force and the minimum thickness of mucus film were analyzed and calculated in detail when rectangular or trapezoidal cylindrical screw was being adopted in microcomputer

    詳細分析計算了微型機器人在採用矩形和梯形圓柱螺旋時的軸向摩擦牽引力和最小粘液膜厚度。
  17. Five programs have been developed with the subroutines mentioned above. these programs are used to analyze rectangular waveguide inductive iris filters, rectangular waveguide e - plane metal - insert filters, h - plane rectangular waveguide right corners, h - plane rectangular waveguide t - junctions and waveguide diplexers, respectively

    論文利用矩形波導平面不連續性模式分析的這些子程序，編寫了5個程序，分別用來分析矩形波導電感膜片濾波器，矩形波導e面金屬插片濾波器， h面矩形波導直角彎頭， h面矩形波導t形結和矩形波導雙工器。
  18. According to the fact that iris images cannot be compared for their different resolutions, a new method for normalizing iris region into fixed resolution by using minimum inner boundary resolution and minimum radius difference of inner boundary and outer boundary is presented

    摘要針對虹膜區域圖像大小不同，難以實現虹膜的比較問題，提出了根據虹膜最小內邊界周長確定角度解析度和根據虹膜最小內、外邊界半徑差確定徑向解析度的方法，將不同分辨的虹膜圖像轉換為相同解析度的矩形區域。
  19. 3. then we improve the traditional iris normalization algorithm and work out the iris normalization algorithm based - on line picked - up to normalize the annular region of iris into a rectangle

    3 .在虹膜歸一化中，改進了傳統的虹膜歸一化方法，研究基於線段提取的虹膜歸一化方法把環形的虹膜區域歸一化映射為一個矩形。
  20. The proposed approach is compared with two commonly used ones by experimental results on the casia database and is proved its rapidity and precision. ( 2 ) in the image proprocessing, the located iris is transformed from an annual area to a rectangular area, then the image is enhanced and converted to some 1d signals which will facilitate the following work

    2 .對定位后的虹膜，採取了有效的歸一化方式，首先在極坐標下把虹膜從環行展成矩形，並對矩形圖像增強，再把矩形圖像化為多個一維信號，這樣，就將二維信號處理問題轉化成了較簡單的一維問題。
分享友人
分享到 Line

分享到臉書