短時負載 的英文怎麼說

中文拼音 [duǎnshífùzǎi]
短時負載 英文
short-time load
  • 短 : Ⅰ形容詞（空間、時間兩端之間的距離小） short; brief Ⅱ動詞（缺少; 欠） lack; owe Ⅲ名詞1 （缺點） we...
  • 時 : shí］Ⅰ名1 （比較長的一段時間）time; times; days:當時at that time; in those days; 古時 ancient tim...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 負載 : [電學] load
  1. If the total test duration is shorter than the time that is required to step up to the maximum user load, then the test stops after the elapsed duration and does not reach the max user count target

    如果總的測試持續時間比逐步增加到最大用戶負載所需的時間短，則經過測試持續時間后，測試將停止，並且不會達到「最大用戶計數」目標。
  2. My research paper can be divided into five parts : i. practical mathematical models have been derived and equations are also derived ( includes field excitation system, governing system ), which are used in generator three phases short circuit and by adding large loading. ii. simulation of the generator ' s shunt - wound run

    發電機組實用數學模型的推導（包括勵磁系統和調速系統） ，並由此推出了用於發電機三相突然短路和突加異步電機大負載模擬的差分方程；並進行了突卸負載、突加負載時調速系統的模擬過程； 2
  3. Studied the liquid - phase synthesis of butyl acetate from n - butyl alcohol and acetic acid using the supported heteropoly blue as catalyst. examed several factors imposing on esterification. the results revealed : using this catalyst, the reactions conversion percentage reaches nearly 100 %, product yield is 98. 9 %, selectivity is 98. 9 %. reusing it 10 times, the efficiency is still well. in addition, using this catalyst, the reactions temperature is mild, the reaction time is short and the equipment hasnt any erosion. furthermore, there is no “ threewastesdischarge

    對以負載型雜多藍為催化劑的乙酸與正丁醇的液相酯化反應進行了研究.考察了影響酯化反應的因素.結果表明：以負載型雜多藍為催化劑，酯化反應轉化率接近100 % ，收率可達98 . 9 % ，選擇性為98 . 9 % ，重復使用10次催化效果仍好.該催化劑還有反應條件溫和、反應時間短、對設備無腐蝕、無三廢排放等優點
  4. Over current protection in circuit design helps to control short circuit in loading and over current promptly to avoid further damage

    具備過流式保護電路功能，對負載的短路及過流及時控制，免除待修電子產品進一步損壞。
  5. Improvements in performance include reductions in specific fuel consumption ( 4 % ), take - off distance ( 10 - 20 % ), minimum speed ( 100 kias ), time to climb and increase in specific excess power, sustained load factor and sustained turn rate ( 15 % )

    性能改進方面包括減少4 %的耗油率，縮短10到20 %的起飛距離，減少最低速度大約一百指示空速節，縮短爬升時間和增加單位剩餘功率，提升15 %的持續回轉率與持續負載系數。
  6. In use, the battery is not short joined directly, so the short current can not indicate the battery ' s function

    電池短路電流值並不能很好的代表，電池工作時的電流性能。因為電池實際工作時並不會直接短路，而是接入一定的負載。
  7. This method has three merits : first, reduce the harm to the battery ; second, this current is stable ; the last, the current may represent the battery ' s current function better. in order to study this problem, we design a install to make lots of experiments to prove this result. the install can use in the factory as a automation instrument if it be perfected

    此方法和原有方法比較有三大憂點：一是減少了直接短路時大電流放電對電池的損傷：二是此迴路電流值穩定存在，可以對其進行比較準確的測量：三是此電流值更能代表堿錳電池實際工作時的放電性能c為了本研究的順利實施，本課題提出了一個堿錳電池四參數檢測的實驗平臺，做到對電池的開路電壓、負載電壓、電流指標、電池重量四參數的檢測。
  8. Isolated boost converter has advantages of high frequency electrical isolation, multi - output solutions, lower input ripple current and high reliability for the short circuit of load, etc. it is attractive in applications such as high voltage multiple outputs with isolation requirement, single stage power factor correction and bi - directional dc / dc converters

    電氣隔離型boost變換器具有高頻電氣隔離，易於多路輸出，輸入電流紋波小，負載短路時可靠性高等優點。它適用於有隔離要求的高壓多路輸出、雙向pwm直流變換和單級pfc等場合。
  9. The mathematical model of multi - loop, which is improved through selecting new stator loops in this paper, can be used to simulate the transient behavior of external short circuit at machine ' s terminal and internal short circuit in the stator, not only under no - load condition with single machine but also under load condition connected to power network

    本文改進了原來的多迴路數學模型中對定子迴路的選擇，不僅可對同步發電機機端各種外部短路故障和單機空載下的各種定子內部故障進行暫態過程的模擬，還實現了負載時內部各種故障的暫態模擬。
  10. In web and in load testing, smoke testing is short, light test

    在web測試和負載測試中，冒煙測試時間短，工作量也小。
  11. How your application performs under light loads for short durations

    確定在短時間內負載較小時應用程序如何執行。
  12. In order to drive a high impedance load such as hpm sources, it is necessary to commutate fcg ' s long pulse width, high - current and low voltage pulse to a short pulse with high voltage

    為用fcg驅動象hpm源這樣較高阻抗的負載，必須使用脈沖功率調制電路把fcg產生的低電壓、大電流、上升時間長的電壓脈沖轉化為高電壓、上升時間短的脈沖。
  13. This system has a lot of the prominent characteristics such as simple structure, and good efficiency, especially adapting to the large, middle power machine equipments that have the big qualities, periodicity, in the short time, constantly accelerating and applying the brake. it is very remarkable in energy - saving

    二次調節靜液傳動系統具有許多顯著的優點，比如：較為簡單的結構，並可得到較高的效率，特別適用於那些負載質量較大、具有周期性、在短時內需不斷加速和制動的大中功率場合（如車輛系統和升降系統） ，其節能效果十分顯著。
  14. With the 300mw turbo - generator as an example, the effects of saturation on operational characteristics and the stator and rotor ' s practical dimensions and configuration on the saturated characteristics have been studied ; some work on the grid division strategy considering the practical dimensions and configuration and the precision of the nonlinear finite element equation also has been studied. then the program for calculating and analyzing turbo - generaors " steady characteristics has been compiled and devised

    本文在系統地研究了汽輪發電機運行特性（飽和特性、短路特性、零功率因數負載特性和u形曲線） 、非線性有限元方程計算精度、定轉子實際結構對飽和特性的影響及計及定轉子實際結構時的剖分策略等問題之後，進一步研究開發了適于不同型號汽輪發電機穩態分析的通用性有限元軟體。
  15. In all cases, load on the server was such that response times never exceeded one second, and were generally much less the heaviest user test with 2 gb mail files and everything in the inbox had response times of 750 msec ; the lightest users had 11 msec response times

    在所有的情況下，服務器端的負載都是這樣的，響應時間從未超過一秒鐘，通常會更短（用2 gb的郵件文件和收件箱中的所有郵件進行測試，負載最大的用戶響應時間為750 msec ；負載最小的用戶響應時間為11 msce ） 。
  16. Interval routing scheme was introduced to reduce the size of routing tables, multi - dimensional routing scheme is the extension of interval routing scheme and it can represent all shortest paths between each pair of nodes, which turns out to be convenient when problems related to flow control aspects such as fault tolerance and traffic load balancing are considered

    區間路由方法是使用簡明路由表的一種路由方案，多維區間路由方法是區間路由方法的擴充，它能夠表示網路中每兩個結點之間所有的最短路徑。當我們需要考慮容錯、通信與計算量的負載平衡問題時，這將是很有用的。
  17. Technologies, including loading balance in distributed system, distributed transaction and oriented object methods, which discussed in this thesis, have been introduced in the designing and implementation of acs system. this thesis finish the following working : we analyze the theory of load balancing and provide a load balancing model. a load balancing agrithm based on overall expected delay routing is implemented in acs. the experiment results shows that the average response time of job and the system resource utilization can be optimized in acs, distributed transaction is designed and implemented for the roaming file ' s processing, two phase commit proctol is used, which can ensure the atomic of distributed transaction commit, recover the exception quickly and improve the system ’ s reliability

    應用控制系統acs （ applicationcontrolsystem ）是針對中國移動漫遊清算系統而開發的面向對象的分散式中間件產品，論文討論了負載均衡、分散式事務、面向對象技術並介紹其在acs中的設計與實現，主要完成了以下的工作:分析了負載均衡的原理，提出了一種分散式動態負載均衡模型，在acs系統中成功實現了總體最小期望等待時間任務分配的動態負載均衡演算法，實驗證明這種演算法縮短了作業的平均響應時間，提高了系統的資源利用率。
  18. With the increase of the electric power system capacity as well as the short lines, high currents will possibly occur in the transmission line when a fault happens at the end of the line. the iron core of the current transformer ( ct ) will become saturated easily because of the large current, or when the secondary load of the ct does n ' t match the 10 % error curve

    隨著電力系統容量增大以及短線的增加，在電力系統線路末端發生短路時，有可能出現很大的短路電流；在很大短路電流的作用下，或由於電流互感器二次側負載與10誤差曲線不匹配等原因，電流互感器鐵芯很容易飽和。
  19. It supports the energy requirement in long term acceleration process and as an energetic recovery system for braking process and downhill drive

    超大電容工作在尖峰負載區，為大加速度過程提供能量，在短時間內實現能量回收。
  20. After you are confident that your test runs well with a light load and for brief durations, you can run your load test on a

    確信測試在小負載情況下可以短時間正常運行之後，可以在rig上運行負載測試。
分享友人
分享到 Line

分享到臉書