短路電流計算 的英文怎麼說

中文拼音 [duǎnlùdiànliújìsuàn]
短路電流計算 英文
dldl
  • 短 : Ⅰ形容詞（空間、時間兩端之間的距離小） short; brief Ⅱ動詞（缺少; 欠） lack; owe Ⅲ名詞1 （缺點） we...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 短路 : [電學] short; short circuit; cutting out; direct short; short out; short pass短路保護（裝置） sho...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  • 計算 : 1 （求得未知數） count; compute; calculate; reckon; enumerate 2 （考慮; 籌劃） consideration; pla...
  1. The development of a visual short circuit software under ptcad2000 is presented in this paper, as well as the system structure, the definition of the data structure, the interface to ptcad2000, the conversion of the original wiring diagram of power network to calculable power network, the implement of three sequence network, the implement of impendence matrix and admittance matrix of power network considering the zero sequence mutual inductances among lines, and the implement of short circuit calculation by using computer

    本文介紹了在ptcad2000平臺下短路電流可視化計算軟體的開發。介紹了軟體的系統結構、數據結構定義、與ptcad2000平臺的介面、電力系統原始接線圖轉成等值可計算網路、序網的生成、考慮零序互感線路阻抗時電網導納矩陣和阻抗矩陣的生成，以及故障點短路電流計算的計算機實現。
  2. The problem about neutral - point - grounding mode is an all - around technical problem which associated with not only power system reliability ， insulation coordination ， electromagnetic interference ， but assault safety 。 in china ， the neutral grounding modes of the 10kv net involved of none grounding, grounding by arc suppressing coils, resistance grounding or reactance grounding in the past 。 with the development of civic power network ， low resistance grounding mode was used to restrain the over voltage, particularly in guangzhou, shanghai ， beijing ， and zhuhai etc. it was reported that the over - voltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way 。 at substations in guangzhou and shanghai it was found that the low resistance grounding mode is successful 。 but in some areas ， such as zhuhai ， substations grounding with low resistance revealed some problems ， including power supply reliability rapidly dropping ， transmitting line often tripping ； and person safety being threatened 。 so interiorly the grounding mode selection of the 10kv network was disputed, which mainly focused on the fault form of 10kv net grounding, the apply area of suppressing arcing coil grounding mode, power supply reliability level of the two modes, person safety, communication interfere and the workload of maintenance

    爭議點主要是在10kv電網接地故障的形式、消弧線圈接地的應用范圍、兩種運行方式供電可靠性的高低、人身安全、通訊干擾和運行維護工作量等諸多方面。 11 17本論文就是針對以電纜為主的城區10kv電網中性點接地方式的選擇問題進行研究。論文首先對10kv電網的中性點運行各種方式進行分析，比較各方式的特點，然後以重慶儲奇門變電站10kv電網的實際參數來建立數值計算模型，在考慮了電網接地電容電流變化、中性點電阻取值大小、接地點接地電阻值變化等多種影響因素的情況下，對中性點經消弧線圈接地和經小電阻接地方式下電網的過電壓水平和接地點短路電流大小進行了數值計算，其計算結果與電科院所作現場試驗進行了比較。
  3. The influence of stray inductance in the module circuit to turn - off transient over voltage of igct has been investigated systematically, the surge current calculation has been done by simulation, and the short circuit failure once occurred in experiment has been analyzed by computer simulation, reproduced the breakthrough failure happened in experiment by means of simulation

    充分利用計算機模擬的優勢，詳細分析了模塊電路雜散電感對igct關斷過電壓的影響，進行了短路浪涌電流計算，對試驗中發生的短路故障進行計算機模擬分析，重現了試驗中出現的誤觸發貫穿短路故障現象。
  4. Short - circuit current calculation in three - phase a. c. systems

    三相交流系統短路電流計算
  5. Discussion on calculation method of three - phase short - circuit current

    三相短路電流計算方法的探討
  6. Short - circuit currents. calculation of effects. examples of calculation

    短路電流.效應計算.計算範例
  7. Short - circuit currents in three - phase a. c. systems - calculation of currents

    三相交流系統內短路電流.電流的計算
  8. The basic software consists of topology analysis, on - line load flow computation, state estimator, security analysis, dispatchers training simulator, short circuit current computation, and voltage / reactive power optimize, etc. the derived softwares consist of load control, capacitor optimizer configuration, transformer and feeder load distribution, impedance computation of generator, etc. network analysis software is powerful dispatch tool, though witch the current state of the power system can be realize, then improve the security and economic potential

    Dms網路分析的基本軟體有：網路結線分析、潮流計算、狀態估計、負荷預報、短路電流計算、電壓無功優化等。派生軟體有：負荷控制、電容器優化配置、變壓器與饋線負荷分配、電源阻抗計算等。網路分析軟體是有力的調度工具，通過它可以了解和掌握當前的運行狀態，從而挖掘安全和經濟方面的巨大潛力。
  9. Application guide for calculation of short - circuit currents in low - voltage radial systems

    在低壓徑向配電制中短路電流計算的應用指南
  10. As an essential component of dms, the system will supplement itself in the following aspect, short circuit current calculation, theoretical losing, voltage / reactive power optimize, state estimation, load forecast, etc

    本軟體平臺是dms的重要組成部分，下一步將加入短路電流計算、理論線損計算、電壓無功優化、狀態估計、負荷預報等功能。
  11. Guide for short - circuit current calculation in three - phase a. c. systems of hydropower engineering

    水電工程三相交流系統短路電流計算導則
  12. Electrical network short - circuit current computation analysis and controlling measurement in baotou area

    包頭地區電網短路電流計算分析及其控制措施
  13. Short - circuit current calculation in three phase a. c. systems - electrical equipment ; data for short - circuit current calculations

    三相交流系統短路電流計算.電氣設備.短路電流計算數
  14. Short - circuit currents in d. c. auxiliary installations in power plants and substations - calculation of short - circuit currents

    發電廠和變電所直流輔助設備短路電流.第1部分:短路電流計算
  15. Electrical installations of ships and mobile and fixed offshore units - procedures for calculating short - circuit currents in three - phase a. c

    船舶和移動式及固定式近海裝置的電氣設施.三相交流短路電流計算程序
  16. Short - circuit currents in three - phase a. c. systems - part 1 : factors for the calculation of short - circuit currents according to iec 60909 - 0

    三相交流電系統中的短路電流.第1部分:根據iec 60909 - 0的短路電流計算系數
  17. Short - circuit current calculation in three - phase a. c. systems. data for electrical equipment for short - circuit current calculations in accordance with bs 7639

    三相交流系統短路電流計算.依據bs 7639短路電流計算用電氣設備數據
  18. This paper presents a novel method for short - circuit current calculation, using zero impedance branch to simulate electrical equipment ( such as circuit breaker )

    提出了將電氣設備（如斷路器等）用一條零阻抗支路模擬的短路電流計算方法。
  19. It utilizes zero impedance branch characteristic, combining structure - transform and structure - static short - circuit current calculation method to calculate the short - circuit current directly through the electrical equipment when short - circuit fault takes place at the two sides of the electrical equipment, and settles the problems that the traditional method cannot directly figure out the short - circuit current

    該方法利用零阻抗支路特點，結合定結構和變結構短路電流計算方法，能夠直接求出在電氣設備兩側分別發生短路時，通過電氣設備（如斷路器）的短路電流，從而合理地解決了傳統的故障分析方法不能直接求出流過設備的短路電流的問題。
  20. Secondly, the following two subjects are discussed according to the calculation of short - circuit current : ( l ) to verify the dynamic stability condition of wires by using simulated annealing algorithm ( sa ), the paper calculates the maximum value of rectangle wires " short - circuit electrodynamic stress and gets the conditions of their having the maximum value. furthermore, some concerned data about the verifying of copper wires are given by analysing vibration spectrum of the electrodynamic stress ; ( 2 ) in order to get the heat withstand conditions of wires, the paper discusses some common calculation methods, and then tries to study the problem applying artificial neural network ( ann ) based on heat principle of metals. the model is shown to be feasible

    其次，在電路中短路電流計算的基礎上， （ 1 ）進行母線的短路動穩定校驗計算：採用模擬退火演算法（ sa演算法）計算了矩形母線短路電動力的最大值及其取極值的條件，獲得了更為一般的結果，進而通過短路電動力的頻譜分析，給出了銅質母線的有關短路校驗計算數據； （ 2 ）進行母線的短路熱穩定校驗計算：討論了熱穩定校校的幾種常用計算方法，從導體或電器的發熱機理出發，運用人工神經網路理論對母線的熱穩定問題進行計算，通過算例比較，證明該方法用於熱穩定計算是可行的。
分享友人
分享到 Line

分享到臉書