石墨化程度 的英文怎麼說

中文拼音 [dànmòhuàchéngdù]
石墨化程度 英文
degree of graphitization
  • 石 : 石量詞（容量單位, 十斗為一石） dan, a unit of dry measure for grain （= l00 sheng）
  • 墨 : Ⅰ名詞1 （寫字繪畫的用品） china [chinese] ink; ink cake; ink stick2 （寫字、繪畫或印刷用的顏料） ...
  • 程 : 名詞1 （規章; 法式） rule; regulation 2 （進度; 程序） order; procedure 3 （路途; 一段路） journe...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 石墨化 : graphitization
  • 程度 : 1. （知識、能力的水平） level; degree 2. （事物變化達到的狀況） extent; degree
  1. The boracic acid was used to prepare flexible graphite and the effect of amount of boracic acid addition on expanded volume, oxidation resistance, specific resistance and tensile strength of the fexible graphite obtained were analysed

    摘要初步探討了製造柔性石墨材料過程中加入添加劑硼酸的方法，並就硼酸的加入量對其膨脹倍數、抗氧化性、電阻率、抗拉強度等的影響進行了比較和分析。
  2. This paper provides equipment optimization design - aside technical scheme of two - appulse - one hydrogen chloride synthesis furnace system by studying the relation of graphite cooling pipe length and productive forces with diversity graphite chiller

    摘要對二合一氯化氫石墨合成爐系統中採用不同形式石墨冷卻器條件下石墨冷卻管設置長度與系統生產能力的關系進行了工程研究，提出了系統設備優化設置的技術方案。
  3. By the analysis of coating ratio, oxidation ratio, micrograph and particle size of composite particle, it was found out that factors such as ph value, coating temperature, concentration of premonitory matter solution mainly affect the coating layer forming

    通過包覆率、氧化失重率、形貌觀察、粒度和比表面積等分析發現，非均勻成核過程中溶液ph值、包覆溫度、覆層前驅物濃度等這幾個因素對石墨表面覆層形成有著重要影響。
  4. Graphite anodes are improved by activation and deposition to some extent

    活化和沉積共改性時，在一定程度上可提高石墨材料的性能。
  5. The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer

    另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。
  6. Using xrd and raman spectrum, in the temperature range of 650 - 850, the rule of graphitization of multiwalled carbon nanotubes synthesized by catalytic decomposition of c2h2 was found : graphitization of multiwalled carbon nanotubes was improved with the increase of growth temperature

    採用xrd和raman光譜，在650 - 850溫度范圍內，研究了催化裂解乙炔法制備的多壁納米碳管的石墨化程度變化規律，結果表明納米碳管的石墨化程度隨生長溫度的提高而提高。
  7. At lower growth temperature, the lower extracting rate of carbon atoms from catalyst particles due to the lower activity of the catalysts resulted in more defects formed in carbon nanotubes. moreover, the lower transportation rate of carbon atoms in catalyst particles also made lots of carbon atoms deposited on the surfaces of grown carbon nanotubes, or on carbon wrapped catalyst particles, even to form amorphous carbon layers

    在較低溫度時，由於催化劑的活性較低，導致石墨面在生長過程中引入的缺陷較多；另一方面，碳原子在催化劑顆粒內遷移速率較低，使得多餘的游離態碳原子（或原子團）可能在納米碳管表面以非晶形式沉積，或者包覆催化劑使其「中毒」失去催化活性，或者直接形成非晶的碳納米顆粒。
分享友人
分享到 Line

分享到臉書