石墨炭 的英文怎麼說

中文拼音 [dàntàn]
石墨炭 英文
graphitic carbon
  • : 石量詞(容量單位, 十斗為一石) dan, a unit of dry measure for grain (= l00 sheng)
  • : Ⅰ名詞1 (寫字繪畫的用品) china [chinese] ink; ink cake; ink stick2 (寫字、繪畫或印刷用的顏料) ...
  • : 名詞1. (木炭的通稱) charcoal 2. (像炭的東西) sth. resembling charcoal3. [方言] (煤) coal4. (姓氏) a surname
  1. The allotropes of carbon include diamond, graphite and charcoal, all with the same chemical properties.

    碳的同素異形體包括金剛和木,所有這些物質都具有相同的化學性質。
  2. The structures and characteristics of several graphite samples are measured by means of powder x - ray diffraction ( xrd ), brunauer - emmer - teller ( bet ) surface area measurement, inductively coupled plasma ( icp ) spectroscopy, particle size analysis and electrochemical measurements. the effects of origin, structure, impurity, particle size, specific surface area of carbon materials on the electrochemical characteristics are studied. a synthetic graphite with abundant resources, low cost and favorable performance is determined as the raw material for modification of graphite

    採用xrd 、 bet 、 icp 、激光粒徑分析及電化學性能測試等方法,對國內外多種典型樣品的結構與性能進行比較,研究材料的來源、晶體結構、雜質含量、顆粒大小、比表面積等因素對其充放電性能的影響,確定一種性能較好、價格低廉、來源廣泛的普通人造粉作為熱處理與摻雜改性、以及復合結構材料研究的原材料。
  3. Test method for moduli of elasticity and fundamental frequencies of carbon and graphite materials by sonic resonance

    用音響共振法測定精和的彈性模量與基本頻率的試驗方法
  4. The so-called "lead" in a pencil is not lead at all, but chiefly a different form of carbon called graphite.

    鉛筆中所謂的鉛,並不是「鉛」,而主要是一種不同形態的,稱為
  5. Standard test method for thermal diffusivity of carbon and graphite by thermal pulse method

    用熱脈沖法測定的熱擴散系數的標準試驗方法
  6. Chinese graphite and carbon product product memoir 05 edition

    中國素製品產品研究報告07版
  7. The results show that the properties of the graphitized samples based on high quality eca and quantitative low ashes raw materials produced by proper carbon technics have reached to the demand of the cathode materials for high - current aluminium electrolysis cell

    結果表明,以無煙煤為主要原料,配以一定比例的少灰料作為骨料,通過適當的素工藝制備的化陰極材料試樣,其常規理化性能可以滿足大電流鋁電解槽用陰極材料的要求。
  8. The pyrolysis process of the cmf aerogel was investigated firstly by means of ir technique. the results showed an infrared active vibration occured in the temperature range of 400 - 600 " c, which was corresponding to the tubstatic graphitized structure formed hi these aerogels

    採用ir分析技術跟蹤c _ mf氣凝膠的熱解過程,發現400 600之間樣品中出現化結構的紅外活性振動,表明氣凝膠的微結構中開始有亂層化微晶出現。
  9. The graphitized cathode block samples have been trial - produced using high quality eca ( electrically calcined anthracite ) rationed petroleum coke and pitch coke and quantitative pitch used as raw materials by the conventional carbon technics concluding moulding, baking, high pressure impregmating, after - baking and graphitization

    摘要選取優質電煅無煙煤,分別配以一定比例的油焦和瀝青焦作為骨料,與煤瀝青混合后按照模壓成型、焙燒、高壓浸漬、二次焙燒和化等常規素製品生產工藝流程制備化陰極材料試樣。
  10. Standard test method for bulk density of as - manufactured carbon and graphite shapes

    加工精及型材松密度的標準試驗方法
  11. Standard test method for sonic velocity in manufactured carbon and graphite materials for use in obtaining an approximate young ' s modulus

    為獲得近似楊氏模量測量加工的精及材料中音速的標準試驗方法
  12. The present problems and further research directions in the preparation high density and strength carbon / graphite materials from mesocarbon microbeads were put forth

    並對中間相微球制備高密高強材料中存在的問題和研究方向提出了自己的見解。
  13. In order to make investigators know about the current research state of preparation of the carbon / graphite materials with high density and strength from mesocarbon microbeads, and direct the research, development and production, in this review, the influence of preparaed mesocarbon microbeads from various raw materials and methods of preparation, ball diameter of carbosphere, preoxidation temperature and time, moulding pressure and time, heat treatment temperature and heating rate, holding time on the mechanical properties and microscopic structure of carbon / graphite product were discussed by us

    摘要為了對中間相微球制備高密高強材料的研究現狀有所了解,並且對實驗和實際生產起到指導作用,本文通過參閱大量中外文獻,討論了不同原料及制備方法制得的中間相微球、微球的球徑、預氧化溫度及時間、成型壓力及時間、熱處理溫度及升溫速率、保溫時間對製品的力學性能及微觀結構的影響。
  14. The mechanism of storing lithium - ions was to store lithium ions in the micropores of the samples. since the micropores which formed in the process of liquid phase carbonization had different sizes, the smaller the micropores, the lower the potential to overcome the resistance for inserting lithium ions. the charging - discharging curves looked like the letter " v " and had no flat plateaus, the charging - discharging capacities were high but faded rapidly

    Htt _ ( max ) = 2000以前,微晶尚未出現,貯鋰機制為「微孔貯鋰」 ;由於微孔的大小不同,插鋰時克服阻力所需的電位也不同,微孔愈小,所需電位愈低,因此充、放電曲線為「 v 」字形,無充、放電電位平臺,充、放電容量高,但容量衰減快;隨著htt _ ( max )的增大,液相化過程中所形成的微孔逐漸變小、變少,因此充、放電容量也逐漸變小。
  15. In order to avoid the influence of trace metal to the stability of ferrate ( vi ), carbon fiber was more suitable, but it led to the problem of being prepared of the cathode, of emerging of the electrode ' s ear and of connecting between the base and shell

    所以直流電解法是制備電池級kzfoo4較為理想的方法。六、將電池級固體kzfzo4與膠狀的混合物塗覆于玻電極、或填充于泡沫鎳基體上,在0 ? 0
  16. Standard test method for flexural strength of manufactured carbon and graphite articles using four - point loading at room temperature

    在室溫下用四點負荷法測定加工品及製品撓曲強度的標準試驗方法
  17. Products include fine zirconium silicate, and a range of metal oxide pigments and metal acetates

    -生產電極塊糊類產品和碳化硅等製品。
  18. Standard test method for electrical resistivity of manufactured carbon and graphite articles at room temperature

    室溫下加工品及製品的電阻率的標準試驗方法
  19. Partially graphitiferous cathode carbon block for aluminium electrolysis

    鋁電解用半質陰極
  20. The absorbing oil nature of carbon black, the lubricated effect of graphite and the bad dispersion of carbon fiber limit their application in ecac respectively

    黑的吸油性、的潤滑性及碳纖維的分散性分別限制其在導電瀝青混凝土的應用。
分享友人