石墨電阻 的英文怎麼說

中文拼音 [dànmòdiànzǔ]
石墨電阻 英文
graphite resistance
  • 石 : 石量詞（容量單位, 十斗為一石） dan, a unit of dry measure for grain （= l00 sheng）
  • 墨 : Ⅰ名詞1 （寫字繪畫的用品） china [chinese] ink; ink cake; ink stick2 （寫字、繪畫或印刷用的顏料） ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 阻 : 動詞（阻擋; 阻礙） block; hinder; impede; obstruct
  • 石墨 : black lead; graphite: [礦]plumbago石墨棒 graphite rod; 石墨電極 graphite electrode; 石墨潤滑劑 aq...
  • 電阻 : （物質阻礙電流通過的性質） resistance; electric resistance （電路中兩點間在一定壓力下決定電流強度...
  1. The boracic acid was used to prepare flexible graphite and the effect of amount of boracic acid addition on expanded volume, oxidation resistance, specific resistance and tensile strength of the fexible graphite obtained were analysed

    摘要初步探討了製造柔性石墨材料過程中加入添加劑硼酸的方法，並就硼酸的加入量對其膨脹倍數、抗氧化性、電阻率、抗拉強度等的影響進行了比較和分析。
  2. Method for resistivity of colloidal graphite for kinescope

    顯象管石墨乳試驗方法電阻率試驗方法
  3. The chemical compositions of sei films formed on the interfaces of a3000 samples in different electrolytes during the first charging process are mainly li2co3 and lioco2r, but their textures are different. the sei films formed in ec - based electrolytes are thin and compact, which can prevent the solvated lithium ions from cointercalating between two graphene layers of the graphite crystallites effectively, therefore samples a3000 have small irreversible capacities and good compatibilities with this kinds of electrolytes. however, the sei films formed in pc - based electrolytes are thick but defective, which could not effectively prevent solvated lithium ions from intercalation, therefore sample a3000 shows large irreversible capacities in pc - based electrolytes and bad compatibilities with this kind of electrolytes

    A _ （ 3000 ）試樣在六種不同的電解液中，首次充電過程中所形成的sei膜，其化學組分均為碳酸鋰和烷基碳酸鋰，但在ec基電解液中形成的sei膜薄而緻密，可以有效地阻止溶劑化鋰離子插入石墨層間，不可逆容量少，表現出與a _ （ 3000 ）試樣有良好的相容性；在pc基電解液中形成的sei膜厚，且有缺陷，不能有效地阻止溶劑化鋰離子嵌入試樣中石墨微晶的層間，不可逆容量大，與a _ （ 3000 ）試樣的相容性極差。
  4. Four kinds of c / c composites with different preparation techniques were graphitized at 2400 - 2880. the relations between magneto - resistance and orientation ( the angle between surface of samples and magnetic field ), measure temperature, the intensity of magnetic field ( b ) were studied for each sample. the micro - structure and x - ray diffraction pattem were investigated too

    本論文在對制備工藝不同的四種碳/碳復合材料樣品進行2400 2880的石墨化處理后，應用ppms （ physicalpropertymeasurementsystem ）研究了測試位向（試樣某特定面和磁場方向夾角） 、測量溫度以及外加磁強對材料磁電阻特性的影響，同時研究了各試樣的微觀結構和x射線衍射譜圖。
  5. Alloys are melted in intermediate frequency furnace and graphite crucible respectively. si and mn are alloyed to improve properties

    試驗中，合金分別在中頻感應爐和石墨坩堝電阻爐中熔煉。
  6. Test method for electrical resistivity of manufactured carbon and graphite articles at room temperature

    室溫下人造碳和石墨製品電阻率的試驗方法
  7. The charging - discharging curves look like the letter " v " and have no flat plateaus due to the different sizes of the micropores. increasing the httmax, the micropores in ant samples become fewer and smaller, therefore the charging - discharging capacities decrease. when httmax = 2100, the charging - discharging capacity reaches the minimum since the number of the micropores reaches the minimum and the size of them become very small, the number of graphite crystallite in ant samples is still few and the size of them is also small

    在htt _ （ max ） 2100的范圍內， ant試樣屬于亂層結構，石墨微晶尚未出現或數量很少，貯鋰機制為「孔隙貯鋰」 ，由於孔隙的大小不一，插鋰時克服阻力所需的電位也不同，因此充、放電曲線呈「 v 」字形，無平穩的充、放電電位平臺；隨著htt _ （ max ）的增大，試樣中孔隙逐漸變小、變少，充、放電容量也逐漸變小。
  8. The mechanism of storing lithium - ions was to store lithium ions in the micropores of the samples. since the micropores which formed in the process of liquid phase carbonization had different sizes, the smaller the micropores, the lower the potential to overcome the resistance for inserting lithium ions. the charging - discharging curves looked like the letter " v " and had no flat plateaus, the charging - discharging capacities were high but faded rapidly

    Htt _ （ max ） = 2000以前，石墨微晶尚未出現，貯鋰機制為「微孔貯鋰」 ；由於微孔的大小不同，插鋰時克服阻力所需的電位也不同，微孔愈小，所需電位愈低，因此充、放電曲線為「 v 」字形，無充、放電電位平臺，充、放電容量高，但容量衰減快；隨著htt _ （ max ）的增大，液相炭化過程中所形成的微孔逐漸變小、變少，因此充、放電容量也逐漸變小。
  9. Standard test method for electrical resistivity of manufactured carbon and graphite articles at room temperature

    室溫下炭加工品及石墨製品的電阻率的標準試驗方法
  10. First, it is associated with the prepared conditions of spectral pure graphite electrode ; second, compared with the untreated graphite, the surface functional groups of ? oh and ? cooh on the treated one increased dramatically with hot concentrated h2so4 and the impurities on electrode surface decreased significantly with ultrasonic rinse. a sequence reaction mechanism was proposed for the eis of mn ( ) / mn ( ) on different graphite electrodes. the spectral graphite and the treated one can be suitable for the inert electrode of mn ( ) / mn ( ) cathode

    分析原因認為：一方面與光譜純石墨電極的制備條件有關；另一方面，與未處理石墨電極相比，處理石墨表面含氧官能團? oh 、 ? cooh明顯增多，而且超聲清洗又使其表面雜質含量減少，並提出了一個反應機理解釋mn （ iii ） / mn （ ii ）電對在三種石墨電極上阻抗譜的不同，說明光譜純石墨和處理石墨均可以作為mn （ iii ） / mn （ ii ）正極電對的惰性工作電極。
  11. Use : it is adequate for senior airproof material and fire retardant in fire control. and worm powder use in battery, deadening, heat preservation

    用途：可做高級密封材料，消防阻燃材料，膨脹石墨粉末可用於鋰電池材料，隔音，保溫材料。
  12. By the addition of copper coated carbon fiber, the bend strength and hardness of cf / cu ( c ) - cu composites increased, the volume density and electrical conductivity of the composite have no apparent change

    與銅-鍍銅石墨復合材料相比，碳纖維鍍銅石墨-銅復合材料的硬度和抗彎強度有了進一步的提高，密度和電阻率變化不大。
  13. In this paper, the volume density, hardness, bend strength and electrical conductivity of cf / cu ( c ) - cu composites have been tested. the results show that, after graphite is coated by copper, the electrical conductivity, bend strength and volume density of cu ( c ) - cu composites is remarkably increased. with the increase of copper coated graphite, the static characteristics are reduced

    本論文通過對不同成分復合材料試樣的密度、硬度、抗彎強度和電阻率等靜態性能的測試發現，石墨粉表面鍍銅提高了材料的導電性能，同時材料的硬度、抗彎強度都有顯著的提高；但當鍍銅石墨粉繼續增加時，材料的導電性能降低，密度、硬度和抗彎強度下降。
分享友人
分享到 Line

分享到臉書