硅接觸 的英文怎麼說

中文拼音 [guījiēchù]
硅接觸 英文
throughsilicon contactt
  • : 名詞[化學] silicon (14號元素符號 si)
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : Ⅰ動詞1 (接觸) touch; contact 2 (碰; 撞) strike; hit 3 (觸動) touch 4 (感動) move sb ; sti...
  • 接觸 : 1. (交往) come into contact with; get in touch with 2. (沖突) engage 3. (挨上; 碰著) contact; touch
  1. Basom observed the contact angle of water against silane-treated e glass to be about 1. 2 rad.

    巴索母觀察到水對烷處理的E玻璃角大約是12弧度。
  2. Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air

    本文針對目前泵用摩擦零部件材料發展的需要,在實驗室摩擦磨損試驗機上研究了按環/塊線方式作往復運動條件下的碳化和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
  3. Occupational exposure limit for wollastonite dust in the air of workplace

    車間空氣中灰石粉塵職業限值
  4. Basom observed the contact angle of water against silane - treated e glass to be about 1. 2 rad

    巴索母觀察到水對烷處理的e玻璃角大約是1 2弧度。
  5. The compound modification of silane wet method and stearic acid dry method modification combine the advantage of individual stearic acid modification and silane modification. the indices are listed as following : wetting contact angle 140, penetration time 200 minutes, oil absorption contents 1. 4, dispersion degree17. 5. on the basis of compound modification, silane and stearic acid cooperation modification simplify the modification craft

    試驗研究表明,單一烷改性,干法效果優于濕法;烷濕法與硬脂酸干法復合改性,結合了硬脂酸、烷單獨改性的優勢,改性后的指標分別為:角140度,滲水時間200min ,吸油值31 . 4 ,分散度17 . 5ml ;在復合改性的基礎上,烷與硬脂酸復配干法改性,進一步簡化了改性工藝,改性后的指標分別為:角145度,滲水時間220min ,吸油值28 . 2 ,分散度18 . 0ml 。
  6. The results of the uni - factor experiments and perpendicular experiments show their best mechanic synthesizing craft as followed : nvp ( 10 % wt ), kh570 ( 20 % wt ), hema ( 70 % wt ), initiator ( 0. 2 % wt ), crosslinker ( 20 % wt ), reacting 20 hours under 80 c. the factors which influenced organic silicon modified pvp hydrogel soft contact lens material ' s swelling capabilities were researched, which included temperature, monomer content, ion concentration etc. the experiments showed the equation swelling content ewc improved with the increase of nw, droped with the increase of kh570 and ion concentration, improved then droped with the raise of temperature, and hydrogels got the least ewc at 45 c. experiment carried on todiscuss water dehydration mechanism of organic silicon modified pvp hydrogel soft contact lens materials, which showed dehydration process could be divided into evaporating stage and diffusing stage

    正交實驗結果表明, nvp ? hema ? kh570共聚物的機械性能最佳時,其合成工藝條件為: nvp用量10 (質量百分含量,下同) , kh570用量20 , hema用量70 ,引發劑aibn用量0 . 2 ,交聯劑nmba用量0 . 2 ,反應溫度為80 ,反應時間16h 。討論了單體配比、溶脹溫度、離子濃度等因素對有機改性pvp水凝膠軟透鏡材料溶脹性能的影響。實驗得出:水凝膠材料的平衡溶脹度ewc隨單體nvp含量的增加而增大, ewc隨kh570用量的增加而減小,隨離子濃度的增大而略微降低,隨溶脹溫度的升高先稍微下降後有所提高, 45時平衡含水量最低。
  7. Abstract : to the principle and project that tu guangazhi proposed in 1990, the gold ore deposits in qinling ( shaanxi ) may be classified into fouowing types : archean high - grade gneiss type, fine grained fragmental rock - carbonate rock - silicilith type, metamorphic fragmental rock type, volcanic rock type, explosive breccia type, intrusive rock exo - and endo - contact zone type. inthis paper, the geological characteristics, metallogenic geological setting, the source of ore - forming materials, digenic mechanism and metallogenetic epoch of gold ore deposits are also discussed

    文摘:參照塗光熾先生( 1990 )提出的礦床類型劃分原則與金礦分類方案,將陜西秦嶺地區原生金礦劃分為太古界綠巖建造型、細碎屑巖-碳酸鹽巖-質巖建造型、變質碎屑巖型、火山巖建造型、隱爆角礫巖型和侵入巖內外型金礦,並對各類型金礦的地質特徵、成礦地質背景、成礦物質來源、礦床形成機制及形成時代等問題進行了論述和討論。
  8. Position the fuser film sleeve into heater, and the end of the film with ground ring should be in good contact with the conductive rubber gear of pressure roller or the conductive brush after installation

    請在安裝新定影膜前,在塑料架與定影膜的部位均勻塗上脂,盡量在有棱的地方多塗點,以保證定影膜與塑料架的充分潤滑。
  9. Workers exposed to silica dust receive regular physical examinations

    的工人定期檢查身體。
  10. Occupational exposure limit for precipitated silica dustin the air of workplace

    車間空氣中沉澱二氧化白炭黑粉塵職業限值
  11. For the sake of the best reflectivity, the optimized zno : al film thickness of 1000a was achieved by theories calculation and exprimental analysis. the n - c - si, which could endure the grain bombard, was used as n - layer of the solar cell with znoral / al back reflector well

    與背電極緊密的n ? si中, n ? c ? si的耐轟擊能力較強,與背反射電極的匹配較好,所以在非晶電池上應用n ? c ? si可以提高背反射電極的增反效果。
  12. The lower member of typical ophiolite suit is exposed at outsides of the qimanyuter ophiolite melange and in between, there distribute the basalt, deep sea limestone and silicalites. these different litho - members contact to each other with ductile shear zones

    帶內蛇綠巖套下部單元出露于兩側,玄武巖和相關的深水灰巖、質巖等分佈於中部,各單元間均以韌性剪切帶
  13. Besides, it was founded that the compatible of the system consisted of mts - mma copolymer and pmma was better than that of pmts / pmma

    應用dma , dsc , uv及水滴角等測試手段表徵了有機聚合物-聚甲基丙烯酸酯梯度膜的性能。
  14. Research on surface and grain boundary passivation mechanism obtained effects of surface recombination on crystalline silicon solar cell performance and the theoretical expression of grain boundary recombination velocity. the limit ratio of short - circuit current increment for anti - reflection coating utilization on solar cells was obtained. the crystalline silicon solar cell spectral response, contact resistance and minority carrier lifetime measurement systems were established

    鈍化機理研究獲得了表面復合對不同表面摻雜濃度晶體太陽電池性能的影響、表面和界面復合速度的理論表達式;研究得到了減反射膜對太陽電池短路電流增量比的極限;建立了太陽電池光譜響應、柵線電極電阻和少子壽命等測試系統。
  15. Studies on metal - semiconductor contacts of 6h - sic and some interrelated processes condensed - state physics postgraduate : wu ruibin director : gong min the manufacturing processes as well as electrical and thermal characters of 6h - sic ohmic contacts have been studied in this work. in addition, we fabricated au and ni schottky barrier diodes ( sbds ) on silicon surface of n - type 6h - sic

    本文討論了n型6h - sic歐姆的制備工藝及其基本電學及熱學特性,並在此基礎上採用金屬au及ni在n型6h - sic面( 0001晶向)上制備了具有一定特性的肖特基勢壘二極體。
  16. Test method for resistivity of silicon epitaxial layers by area contacts three - probe techniques

    外延層電阻率的面三探針.測試方法
  17. Materials and articles in contact with foodstuffs. silicate surfaces. part 1 : determination of the release of lead and cadmium from ceramic ware

    與食品的材料和器具.酸酯表面.第1部分:從陶瓷器具中釋放的鉛和鎘的測定
  18. The different ratio and dosage of composite surfactants were researched about the polymer latex ' s stabilization and structure. afterwards, the emulsion polymerization of tris, mma, and p ( mma - co - ptris ) were carried out. some different monomer ratio copolymer latex and homopolymer latex are prepared by emulsion polymerization used self - made organosilicone monomer - [ tris ( trimethylsiloxy ) silyl ] propylmethacrylate and mma

    用ir , tem , dma ,水滴角測試等方法表徵所制備的均聚物和共聚物膜發現:採用有機表面活性劑與十二烷基硫酸鈉復配使用,用量在6 8 (相對單體量)可得到粒徑分佈均勻且穩定的均聚和共聚乳液。
  19. In this paper, select li 3 # and grease 7014 as basis grease. select nano diamond and sio _ 2 are selected as additives, design 14 recipe using k and l10 as appraise norm study the dose of nano particle to the effect of contact fatigue of ceramic and steel friction has the conclusion that proper quantities nano particle which put in two grease can improve the contact fatigue life of ceramic using sem and edax, nano particles fatigue resistance mechanism are analyzed. which can improve the contact fatigue life of ceramic and steel friction

    本文選用3 #通用鋰基脂和7014號寬溫航空潤滑脂作為基礎脂,選取納米金剛石粉和納米二氧化微粒作為添加劑,設計了14種配方。利用威布爾斜率k和額定壽命l10作為評價指標,研究了納米微粒的用量對陶瓷球/鋼副的疲勞壽命的影響,得出在所選兩種基礎脂中添加合適用量的納米微粒添加劑可以提高陶瓷球的疲勞壽命。利用sem和edax ,初步揭示了納米微粒提高陶瓷/鋼副滾動疲勞的機理。
  20. But the quality of the lapis lazuli in these other mines, so far, have not been able to equal those extracted from afghanistan

    青金石是由交代變質作用形成,主要賦存於酸鹽-鎂質矽卡巖中和鈣質矽卡巖中。
分享友人