碎裂作用 的英文怎麼說

中文拼音 [suìlièzuòyòng]
碎裂作用 英文
cataclasis
  • : 動詞[書面語] (觸; 撞) strike; bump
  • : 裂動詞[方言] (東西的兩部分向兩旁分開) open
  • : Ⅰ動詞1 (使用) use; employ; apply 2 (多用於否定: 需要) need 3 (敬辭: 吃; 喝) eat; drink Ⅱ名...
  • 碎裂 : splintering; fragmentation
  1. The faults controlled the mineralization mainly and connected the deep with the surface by the upward migration of the deep - derived auriferous metallogenetic fluids via the fractured zones and by their later precipitation

    提出了斷構造對成礦的主要控製,它起著溝通深部與淺部的,並使深部的含金流體沿斷帶上升、沉澱而成礦。
  2. The fault controlled the magmatism and metallization relevant to the contact zone, and deformed successively and produced cataclastic rocks and two sets of joints ; the second stage was from late cretaceous to eocene. the fault zone deformed right - laterally under ne - sw striking transtention, and new joints zone was produced at the end of the two main faults because of local stress concentration. the fault produced inchoative cataclastic rocks, and two sets of typical joints in plutons ; the third stage of deformation was relatively faint and only a little of microcracks was produced and infilled with vei ns in the deformed rocks, which was during the himalayan movement

    其後的繼承性活動在斷帶內形成程度最強達到巖的巖系列構造巖,變形帶兩側發育兩組典型的共軛剪節理;第二次在晚白堊世?始新世,斷在北東?南西向近水平擠壓下右行張扭性活動,斷帶兩主斷在斜列重疊的端部由於局部應力集中進一步擴展形成節理帶,而斷在巖體區也發育兩組典型的共軛剪節理,斷內形成初巖為主的構造巖;第三次是喜山期以西側抬升、東側下降的強烈升降為主的活動,在基巖中,主斷層兩側圍巖出現微破
  3. The cataclastic rocks appeared in the fault zone include structural lenticles, fault breccias, protocataclasite and cataclasite. the microscopical cataclastic deformation mechanisms involved are microcracking, frictional sliding and pressure - solution, but there might have had ductile deformation relating to dislocation sliding in feldspar and quartz of the plutons

    帶內巖系列構造巖主要是化巖石(包括構造透鏡體和構造角礫巖) 、初巖和巖,顯微變形機制主要有破、摩擦滑動和壓溶
  4. The results show that the process of concrete sawing with diamond tools is that the impact of diamond sawblade induces the rupture and break of concrete surface layer during high speed sawing ; cement and carpolite become micro chips by the cutting of diamond grits ; steel fiber and steel wire are broken by plastic deformation or pulled out by forces

    結果表明:金剛石鋸片鋸切混凝土的過程表現為高速據切過程中金剛石據片的沖擊引起混凝土表層斷,水泥石子等在切削區內層受到金剛石磨粒的微切削形成粉屑,以及鋼纖維和鋼絲發生金屬塑性變形斷或被拔拉而斷的過程。
  5. This paper analyses the stress and deformation of the two lining structure types of the surge shaft surrounded with crush rock under the action of high water pressure by using fem, compares the two lining types ' s merits and demerits in stress, deformation, fracture state, the combining bearing of surrounding rock and lining structure, the safety and economics

    本文針對圍巖條件比較破隙發育的調壓井洞室結構,就兩種襯砌結構型式分別進行了高水頭下的有限元數值模擬,從調壓井襯砌結構選型角度分析對比了兩種襯砌結構型式在圍巖及襯砌結構應力與變形、襯砌結構鋼筋混凝土開、圍巖與襯砌結構聯合承載、結構安全儲備、經濟等方面的優劣。
  6. In numerical simulation, the elastic zone is only considered and the effect of blasting waves on the rock medium, after attenuating through crushing zone and ruptured zone, becomes an input load

    數值模擬僅考慮彈性區域,爆炸波對巖石介質的經粉區、破區衰減后成為輸入荷載。
  7. Principle : it is adoping tattered dose to blend inner place the pouing perforate against water, utilizes such water action to come into being swelling the pressu ` re, by the rock, confuses soil forms piece and so on the brittleness substance distends to crack either cuts

    原理:它是採劑與水混合灌入鉆孔中內,利其水化產生膨脹壓力,將巖石、混泥土構件等脆性物體脹或切割。
  8. Fractal scalings of rock fragmentation

    巖石碎裂作用的分形尺度
  9. Sheets of newly formed sea ice break into pieces under stress of wind and waves

    大塊新形成的海冰在風和海浪的片。
  10. Based on the results of particle size analysis and sem observation as well as microstructural characterization of pp / fe co - powders, a pulverizing mechanism is proposed. the mechanical properties of pp / fe composites indicate that izod impact strength increased from 2. 86 kj / m2 to 4. 52kj / m2, 68. 7 % higher after 25 cycles of milling

    Bet比表面積、粒度分佈和sem分析表明, pp wtr共碾磨初期主要發生顆粒破細化,粉為主;碾磨後期,碾磨主要起混合,碾磨導致復合粉體比表面積下降,碾磨20次后比表面積下降為0
  11. It is found that the great cracks on the coarse surface are initiated easily than on the smooth surface by the sem observation and the crack size obtained at the dynamic indentation experiment is bigger than at the static indentation experiment under the same load. it is showed the single crystal silicon is easier to initiate the crack and fracture under dynamic load, the single crystal silicon ’ s

    然後通過sem觀察單晶硅試件表面壓痕形貌,發現粗糙表面比光滑表面容易生成大紋,在相同載荷下單晶硅材料在動態壓痕試驗得到的紋要大於在靜態壓痕試驗得到的紋,表明在動態加載條件下單晶硅材料更容易生成紋和破
  12. This is the direct reason of bad reservoir property of sandstone, especially lower permeability. the influence and control factors of reservoirs include : deposition, diagenesis and tectogenesis. the deposition is the basic factor, it control the shape and distribution of sand body, and influence the type and the intensity of the diagenesis ; the diagenesis is the key factor, it control the process of pore evolvement, so the diagenesis control the sandstone ' s storage space and reservoir quality directly ; the fracture of the tectogenesis formation could improve the porosity and permeability of sandstone

    其中沉積是基礎,控制了儲集砂體的形態特徵和分佈范圍,同時由於不同沉積類型砂體在屑成分組成、泥質含量、顆粒粒度、砂體厚度、砂體內部的非均質性、孔隙介質的物理化學性質等方面不盡相同,從而也影響著砂巖所經歷的成巖路徑、類型和強度,因此沉積是控制儲層發育的主導因素;成巖是關鍵,直接決定了砂巖的孔隙演化過程,從而決定了儲層內部儲集空間特徵和儲集性能;而構造形成的縫對改善砂巖的儲滲性能具有一定
  13. The results show that the reinforcement phase plays a wear - resistant role. under the dry friction, the wear of the composites is caused by the co - effects of various mechanisms such as adhesive wear, micro - plowing and micro - cutting of abrasives on the matrix and separation of the composite phases

    研究結果表明,由於增強相具有抵抗磨損的,使得復合材料具有很高的耐磨性;在干摩擦條件下復合材料的磨損主要是粘著、顯微切削以及復合相脫落、等多種機制綜合的結果。
  14. When the psb amplitude is weak, a series of hair - pin vortex will be formed. the formation, diffusion, breakup of the front edge of hair - pin vortex and the break of the head of hair - pin vortex lead to the first instability and form the slug structure

    在一定幅值的psb弱擾動下,圓管流動中出現一系列發卡渦,發卡渦前緣處環形渦的形成、擴散和破以及發卡渦頭部的破導致了流動的第一次失穩,產生塞流結構。
  15. Above 450, the formation of low density u ( al, si ) 3 phase, together with the release of the impurity gas and fragmentation of u3si2 particles, will cause fuel meat to swell, al matrix to crack and u3si2 particles to invade to clad. as a result, the thickness of the meat increased, the thickness of clad decreased and the deformation of fuel plates increased, and the leakage probability of the radioactive mass increased reasonably

    同時,由於芯體膨脹及鈾硅顆粒的綜合,使u _ 3si _ 2顆粒向包殼侵入,最終使燃料板芯體厚度增加較大,芯體及燃料的體積也顯著增加,包殼厚度減薄;高溫將加速芯體u _ 3si _ 2顆粒、芯體開、包殼以及燃料板變形,從而使燃料芯體與包殼脫開,最終可能導致放射性物質泄漏。
分享友人