碳化室高度 的英文怎麼說
中文拼音 [tànhuàshìgāodù]
碳化室高度
英文
chamber height-
The quality of buffer layer and thin films was analyzed by afm, xrd, rheed and xps respectively. the effect of the experimental parameters such as carbonization time, working pressure, c source gas flow rate, carbonization temperature, different carbonization gas and substrate on the carbonization process was studied firstly. it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite, but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too, and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low, but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough, and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature, the size of particles was increased, the rms is decreased and a good single - crystalline carbonization layer could be obtained, but a rough surface was formed at a excessive high temperature ; the rms of
對于碳化工藝，側重研究了碳化時間、反應室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影響，研究結果表明:隨著碳化時間的增長，碳化層的晶粒尺寸隨之變大，表面粗糙度隨之降低，但當碳化到一定時間之後，碳化反應減緩，碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應室氣壓的升高而變大，適中的反應室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小時，碳化層的晶粒尺寸隨氣體流量的變化不明顯，但當氣體流量增大到一定程度時，碳化層的晶粒尺寸隨氣體流量的增大而明顯變大，同時，適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低時，碳化層的晶粒取向不明顯，隨著碳化溫度的升高，碳化層的晶粒尺寸明顯變大，且有微弱的單晶取向出現，但取向較差，同時，適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ，以ch _ 4作為c源氣體時得到的碳化層表面平整得多;比起si （ 100 ） ，選用si （ 111 ）作為基片生長的碳化層的晶粒取向一致性明顯更好。X - ray diffraction spectrum, empa methods and several tests including mechanical properties, electrochemistry, corrosion wear, on - site plate hanging, the microstructure of steel has been observed and analyzed, performance has been studied, and corrosion - abrasion, fragility mechanism, and microalloy application in ferritic stainless steel have been explored comprehensively. the test results of electrochemistry, corrosion wear and on - site plate hanging have been analyzed. the analytical result shows that crsomo has enough corrosion resistance in phosphoric acid slurry because it has high chromium and low carbon
通過實驗室的電化學試驗、腐蝕磨損試驗和磷肥廠的現場掛片試驗結果分析，表明： cr30mo鐵素體不銹鋼高鉻低碳的配合，保證其在磷酸料漿中具有足夠的耐蝕性： cr30mo中（ fe ， cr ） _ 23c _ 6 、 （ fe ， cr ） _ 7c _ 3 、 mo _ 2c 、等碳化物硬質點從基體的彌散沉澱析出可提高鋼的硬度和耐磨性，使得鋼在磷酸料漿中具有良好的耐磨蝕效果。Especially applying hinge - based dual - cylinder control system to hauling ensures that the pressure imposed to the products is even and uniform so as to guarantee more stable hauling performance. it is widely used in the fields of architecture, traffic, and furniture, especially, in the production of hard pvc, pe, pp, ps, abs irregular materials products used in windows and doors
本公司生產的高透光性高強度的聚碳酸脂管，亦稱pc管，廣泛用燈飾特別是豪華燈飾橋頭燈飾霓虹燈水族燈等，同時適用於離子交換柱液位器醫療器械高奪電絕緣配件實驗室儀器化工管道等等。Since 1980s, our agricultural engineers and technicians have been studying on controlling technology of single environmental factors such as temperature, humidity, illumination, carbon dioxide consistency etc. in greenhouse
自80年代以來，我國農業工程技術人員在吸收發達國家高科技溫室生產技術的基礎上，進行了溫室中溫度、濕度、光照和二氧化碳等單項環境因子控制技術的研究。When change the component of adhesive its shear strength increased from 39. 3 mpa to 53. 5 mpa at room temperature and it have long - term usage at 180 with 25 mpa and can be served at 230 in short period. the addition of liquid rubber resulted in a 300 % increase in the peeling strength. the addition of polymer ether imide led to a 260 % increase in the peeling strength, a 15 % increase in shear strength and a 10 increase in tg ( tg = 195. 54 )
研究結果表明： bmi dds e ? 51 tde ? 85組成的膠粘劑體系的室溫剪切強度為39 . 3mpa ，當改變環氧樹脂的含量時，剪切強度提高到53 . 5mpa ；用無規羧基液體丁腈橡膠改性環氧樹脂膠粘劑時室溫剝離強度提高3 . 0倍；用聚醚酰亞胺改性環氧樹脂膠粘劑，室溫剪切強度最高可達45 . 2mpa ，剝離強度提高2 . 6倍，玻璃化轉變溫度tg = 195 . 54 ，比未增韌體系提高10以上；碳纖維耐磨材料與同步器圓錐環的粘接實驗結果表明，膠粘劑的使用工藝性能良好，滿足室溫剪切強度30mpa和180剪切強度12 . 5mpa的技術要求。Abstract : in experimental conditions, simulating reducing atmosphere in blast furnace, the samples of al2o3 - c brick is heated at high temperature. the microscopic structure of al2o3 - c brick is observed by scanning electric telescope before and after heating and compressive strength and rupture strength are measured. on the base of them, the reason resulting in the changes is analyzed
文摘:在實驗室條件下模擬高爐還原氣氛高溫處理鋁碳磚試樣，觀察處理前、后鋁碳磚的顯微組織形貌的變化，並測定其抗壓、抗折強度，分析引起這種組織變化的原因" the carbon dioxide from fossil fuels is distributed pretty evenly around the globe and not concentrated in the arctic, so it does n ' t look like we can blame greenhouse gases for the overwhelming bulk of the northern hemisphere warming over the past 27 years, " christy said
然而，熱帶地區溫度在過去27年中僅僅升高了華氏0 . 3度。 「燃燒釋放的二氧化碳非常均勻地散布在全球，並非只集中在北極。所以過去27年間出現的北半球加速變暖的情況，好像並不能僅僅責怪溫室氣體。This finding may account for the ability of peasant farmers in asia and elsewhere, who are extremely lean and active, to consume large amounts of refined carbohydrates without experiencing diabetes or heart disease, whereas the same diet in a more sedentary population can have devastating effects
這項發現也可以用來解釋亞洲與其他地區的農民，他們十分清瘦且高度勞動，食用大量精製的碳水化合物也很少發生糖尿病或心臟病；同樣的飲食，對坐辦公室的族群卻具有毀滅性的後果。Most scientists agree that the overall effect of the direct andindirect feedbacks caused by increased water vapor content of theatmosphere significantly enhances the initial warming that caused theincrease - that is, it is a strong positive feedback. ( [ 2 ], see b7 )
作為一種間接機制，水汽可以被認為處于溫室效應的正反饋環節中，即二氧化碳等人類排放的溫室氣體增加》導致地球平均溫度升高》加速水氣蒸發和增加空氣中水汽含量》溫度繼續升高= 》重復前面循環。 。 。Gases such as carbon dioxide and sulphur dioxide, known as greenhouse gases, in our atmosphere are effective agents to trap infrared radiation, resulting in a rise of atmospheric temperature
二氧化碳及二氧化硫等氣體稱為溫室氣體他們能有效地阻擋紅外線向外太空輻射從而令地球的溫度升高這便是分享友人