碳化鈣 的英文怎麼說

中文拼音 [tànhuàgài]
碳化鈣 英文
acetylene lime
  • 碳 : 名詞[化學] （非金屬元素） carbon （c）
  • 鈣 : 名詞[化學] calcium （20號元素, 符號 ca）
  1. Chemicals. calcium carbide for the generation of acetylene

    化學製品.碳化鈣
  2. Water. carbon dioxide. sulphuric acid. calcium hydroxide. alpha. beta

    水。二氧化碳。硫酸。氫氧化鈣。阿爾法。貝塔。
  3. Soil caco3 eluviation and deposition process is the most important development and evolution process of soil, from parent material to mature soil in the loess plateau, arid and semiarid area

    土壤碳酸鈣（ caco _ 3 ）的淋溶淀積過程是黃土高原以及乾旱和半乾旱地區土壤形成發育的主要過程之一，也是地球化學過程的主要內容。
  4. The distribution and change pattern of soil co2 concentration in soil profile data are analyzed as well as its effect factors. a model for soil caco3 eluviation - illuviation is developed based on mechanism of soil chemical thermodynamic principle and applying other modeling experience for reference

    本文以磚窯溝流域為例研究和分析了土壤剖面co _ 2濃度的分佈變化規律及其影響因子；對土壤碳酸鈣淋溶錠積進行了定性、定量研究。
  5. Caco3 not only affects soil physical and chemical characteristics but also causes co2 change in the air, because caco3 is main components among the total pool of inorganic carbon of soil. this paper systematically summarized and analyzed general development characteristics of soil profile caco3 in loess hill gully area including source, content, forming - condition, distribution and illuviation - depth of caco3, which will have the most important significance for the further studies on global soil and climate change

    碳酸鈣在土壤剖面中淀積的深度和類型是黃土高原土壤發育的重要標志，鈣積層是黃土高原土壤發育環境的歷史信息庫，同時土壤碳酸鈣作為土壤無機碳庫重要組成，它通過溶蝕后再結晶與大氣co _ 2之間進行物質交流來影響全球氣候變化。
  6. In this thesis, aragonite whisker was synthesized by introducing co2 into ca ( oh ) 2 suspension mixed with mgcl2. the hyphenated technique of microscope - microcomputer was used to examine the morphology and microstructure of the products. the effects of reaction temperature, concentration of mgcl2, ph value of the initial suspension, flow velocity of co2, and stirring strength on the formation of the polymorphs of calcium carbonate were examined

    本文利用改進的碳化法制備了文石相碳酸鈣晶須，採用高倍顯微鏡一計算機聯用技術、掃描電鏡和x射線衍射儀進行產品形貌觀察和晶型分析，討論了溫度、 mgcl _ 2濃度、初始ph值、 co _ 2的流速、攪拌速度等因素對制備文石相碳酸鈣晶須的影響。
  7. For collecting sand blasting powder, molding powder, mineral stone powder, plastic pigment powder, medicine powder, cosmetic powder, bakelite powder, wood dust, brass powder, ceramic powder, melamine powder, shoe - sole powder, brake lining powder, clutch powder as well as dust produced from grinding chopsticks and metallic articles

    噴砂粉、翻砂粉、礦石粉、水泥粉、碳酸鈣粉、塑膠顏料粉、制藥粉、化妝品粉、電木粉、木器粉、銅鋼器粉、陶器粉、美耐皿粉、鞋底粉、煞車來令粉、離合器粉、筷子、金屬研磨等、收塵、集塵用。
  8. He postulated that the carbon reacts initially with the sulfate to form calcium sulfide.

    他認為碳最初和硫酸鹽反應生成硫化鈣。
  9. " overuse of recycled plastic and materials such as talcum powder and calcium carbonate can generate chemicals that can cause cancer if they come in contact with hot food and oil. " the newspaper said

    報導指出，過度使用回收塑膠及滑石粉和碳酸鈣等材質，一旦讓它們接觸到熱食和油，就會產生致癌化學物質。
  10. The two constituents were compatibilized in - situ by mechanochemical reactions induced by pan - milling and the microstructure of the blend can be controlled conveniently by adjusting processing conditions. polyamide 6 / ground limestone powder ( pa6 / caco3 ) and polyamide 6 / silicon dioxide ( pa6 / sio2 ) composites were also prepared through this method. those pa6 blends and composites exhibit improved microstructure and superior mechanical properties to the systems mixed by conventional mixing methods

    研究了磨盤碾磨對尼龍6的粉碎機理，制備了就地增容、微相結構可調的聚丙烯/尼龍6 （ pp / pa6 ）及尼龍6 /碳酸鈣（ pa6 / caco _ 3 ） 、尼龍6 /納米級二氧化硅（ pa6 / nano - sio _ 2 ）共混復合材料，各體系混合效果、微相結構及力學性能均明顯優于採用傳統混合設備制備的試樣。
  11. When fillings is other materials ( unprocessed montmorillonite, powder coal ash, co - composite of powder coal ash and organo - montmorillonite, co - composite ofcarbonizing calcium and organo - montmorillonite ) in the binder and content of organo - montmorillonite in the binder is five percent decided by tensile - shear experiment, tensile - shear strength of binder is up to tiptop ; at the same time, this paper carries out abrasion experiment, and, by comparison, concludes abrasion property of coating is optimum when content of organo - montmorillonite in the binder coating is five percent, and observes abrasion sample under set

    當膠粘劑中填料為其它物質（未處理蒙脫土、粉煤灰、粉煤灰和有機化蒙脫土共復合、碳化鈣和有機化蒙脫土共復合）時，通過拉伸剪切試驗確定膠粘劑中有機化蒙脫土含量為5時，膠粘劑的拉伸剪切強度最高；同時進行了沖蝕磨損試驗，通過比較得出，當膠粘劑塗層中有機化蒙脫土含量達到5時，塗層的耐沖蝕磨損性能最佳，並對沖蝕磨損試樣在掃描電子顯微鏡（ set ）上進行觀察。
  12. The results show that they have good concertedness, making the nanometer caco3 particles receive very good dispersiveness and stability in the oil

    結果表明這幾種活化劑同時使用產生了很好的協同效應，使得納米碳酸鈣粒子在潤滑油中得到了很好的分散性和穩定性。
  13. Effects of placing time and carbonization time of lime white on dehydration process of calcium carbonate suspension

    石灰乳放置時間和碳化時間對碳酸鈣懸浮液脫水過程的影響
  14. Standard test method for field determination of water moisture content of soil by the calcium carbide gas pressure tester

    用碳化鈣氣壓檢驗器法現場測定土壤中水含量的標準試驗方法
  15. Standard test method for rapid determination of carbonate content of soils

    快速測定土壤中碳化鈣含量的標準試驗方法
  16. Chemicals used for treatment of water intended for human consumption - calcium carbonate

    供人用的水處理時用的化學物質.碳化鈣
  17. Extenders for plastics - part 6 : precipitated calcium carbonate, specifications and methods of test

    塑料的填料.第6部分:沉降碳化鈣.要求和試驗方法
  18. Extenders for plastics - part 5 : natural crystalline calcium carbonate, specifications and methods of test

    塑料的填料.第4部分:天然結晶的碳化鈣.規范和試驗方
  19. Considering the different physical and chemical properties between magnesium granules and calcium carbide powders, the thermodynamics, mechanism and kinetics of desulphurization in hot metal by magnesium injection were mainly discussed

    鑒于金屬鎂粒和碳化鈣粉這兩種脫硫粉劑的物理和化學性質有著本質的區別，作者重點分析研究了鎂粒在脫硫過程中的熱力學、反應機理和動力學。
  20. Based on the analysis about the influences of the mixing time, the penetration ratio of injected powder and the residence time of injected powder in the bath on the desulphurization process, a mathematical model which taken these three parameters into account was developed to simulate the desulphurization rate of hot metal by co - injection of magnesium - cac2 mixture, and the coupling effect between magnesium and cac2 was discussed

    在具體分析熔池均混時間、粉劑穿透比及粉劑停留時間這3個基本參數對脫硫過程影響的基礎上，建立了能體現這3個參數影響的模擬鐵水噴吹鎂粒和碳化鈣復合粉劑脫硫處理的數學模型，並討論了兩種粉劑在脫硫過程中的耦合效果。
分享友人
分享到 Line

分享到臉書