碳化鋁 的英文怎麼說
中文拼音 [tànhuàlǚ]
碳化鋁
英文
aluminium carbide
-
碳 :
名詞[化學] (非金屬元素) carbon (c)
-
鋁 :
名詞[化學] aluminium (13號元素, 符號al)
-
Refractory products. chemical analysis of aluminous, siliceous, silicon carbide, carbon and metallic silicon refractory products
耐火材料製品.
鋁礬土硅質材料
碳化硅
碳和金屬硅耐火材料製品的
化學分析
-
Preparation of nano aluminium trihydroxide by high gravity carbonation
超重力法
碳分制備納米三水合氧
化鋁的研究
-
Composed of micro diamonds, aluminum oxide, and silicon carbide, the isotopic distribution of these grains bore the telltale marks of their birth : ancient supernovas and red giant stars, that shone brightly and then flickered out, billions of years ago, before the birth of the solar system
由微金剛石、
鋁氧
化物、
碳化硅組成的這些微粒的同位素分佈透露出它們的誕生:那些數十億年前,在太陽系尚未誕生時,曾經閃耀並最終熄滅的古老超新星和紅巨星。
-
Chemical analysis methods and determination of physical performance of alumina determination of chromium sesquioxide content - diphenyl carbazide photometric method
氧
化鋁化學分析方法和物理性能測定方法二苯基
碳酰二肼光度法測定三氧
化二鉻含量
-
The key products of the company are high alumina brick, fireclay brick, phosphate - bonded wearable brick, exfoliation - resistant high alumina brick, high refractoriness under load brick, corundum brick, magnesite brick, magnesite ? chrome brick, series of corundum, sic furnace chamber and pipe, ceramisite brick, corundum - mullite brick, corundum - chrome brick, sillimanite brick, magnesite alumina spinel brick, acid - resistant brick, alkali - resistant brick, zirconia - corundum brick, alumina bubble products, series thermal insulating refractory products, high alumina castable, corundum castable, corundum ramming, brown - corundunm castable, sic castable, low - cement castable, alkali ? resistant castable, light silica alumina products, stainless steel fibre reinforced castable, etc
主要產品有:高
鋁質磚、粘土質磚、磷酸鹽耐磨磚、抗剝落磚、高荷軟磚、剛玉磚、
碳化硅磚、鎂磚、鎂鉻磚、各種剛玉、 sic爐膛、爐管製品、陶粒磚、剛玉莫來石磚、鉻剛玉磚、硅線石磚、鎂鉻尖晶石磚、耐酸磚、耐堿磚、鋯剛玉磚、氧
化鋁空心球製品及各種輕質保溫材料、高
鋁質澆注料和剛玉澆注料、搗打料、棕剛玉澆注料、
碳化硅澆注料,低水泥澆注料、抗堿性澆注料、輕質硅酸
鋁製品、鋼纖維增強澆注料等80餘種系列耐火材料。
-
Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air
本文針對目前泵用摩擦零部件材料發展的需要,在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的
碳化硅和氧
化鋁基陶瓷材料摩擦副在水、
化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。
-
Compared to silicon carbide materials, fused alumina materials are of more softness and toughness as well. fused alumina powder is composed of mainly aluminium oxide
與
碳化硅相比,剛玉材料相對柔軟並且富有韌性,以氧
化鋁為主要
化學成分的人工研磨材料。
-
0 - gw is made of high aluminum ceramic, corundum or carborundum. it is favorable of corrosion - proof and high temperature - resistant. with operating temperaturearriving at 0 to 1600 forthermo electrodes use ptrh - pt noble metal wire
M - wr - 4g0 - gw耐高溫熱電偶外套管採用高
鋁管剛玉管或
碳化硅管,有較好的耐腐蝕性,耐高溫,使用溫度01600 ,熱電偶採用鉑銠鉑貴金屬絲。
-
Abstract : this paper studied the damage effects of sic fiber reinforced al matrix ( sic / al ) composite irradiated by a highpower continuous laser
文摘:研究了
鋁基
碳化硅纖維增強復合材料在連續波強激光輻照下的破壞效應。
-
The results show that under the same lapping conditions the si3 n4 ball has the lowest material removal rate and the best roundness and roughness, followed by zro2, al2o3, and sic ball
結果表明:在相同的研磨條件下,具有長柱狀晶粒的氮
化硅陶瓷球加工速率最低,但圓度和表面粗糙度最容易控制;氧
化鋯和氧
化鋁陶瓷球表面質量次之,
碳化硅陶瓷球加工速率最高,圓度和表面粗糙度最難控制。
-
Study on the effects of the characters related to the grai n weight per plant on breeding high yield soybean
利用堿熔融法生產高
碳石墨廢水制備堿式氯
化鋁的試驗研究
-
According to the application feedback of the past two decades, s - sic out - performed rb - sic and other engineered ceramic such as alumina, tungsten carbide and graphite
過去二十幾年的應用結果顯示,常壓燒結
碳化硅產品的性能明顯優于反應結合
碳化硅及其他工程陶瓷(如氧
化鋁、硬質合金、石墨) ,可直接取代這些產品的各種應用。
-
As the results, there are distinct hybrid effect between the steel fibre and kevlar fibre, carton fibre and aluminum silicate fiber, which is important to the friction coefficient. the carton fibre and kevlar fibre also have big influence to the friction coefficient for their good characters. the wood fibre has the same character as the carton fibre in the high temperature, being a kind of excellent filler y - 3 filler helps to improve the friction stability and wear - resistance of the friction material by increasing its content
結果表明,鋼纖維與芳綸纖維、
碳纖維與硅酸
鋁纖維之間有明顯的混雜效應,對摩擦系數起著十分重要的作用,
碳纖維、芳綸纖維自身由於其良好的特性,對摩擦系數也有較大的影響,木纖維在高溫時
碳化,起到與
碳纖維類似的作用, y - 3填料是一種優良的填料,它的含量增加可以提高摩擦系數的穩定性和耐磨性能。
-
It adopts the intermediate frequency power ; it not only can plate single films or multilayer membrane, such as titanium nitrides, titanium carbide, zirconium nitrides, chromium nitride, titanium, nickel, chromium and copper etc. but also can plate the ito, al2o3, sio2, tio2 and zro etc. furthermore, it can plate multilayer membrane after being equipped with multi - targets with top grade quality and fast speed, as well as advantages of other plating methods ; therefore it is one super - hard membrane equipment with excellent performance
採用先進的中頻電源,濺射速度快,不但可以鍍制氮
化鈦
碳化鈦氮
化鋯氮
化鉻及鈦鎳鉻銅金銀等等單一膜層或復合膜層,而且可以鍍制銦錫合金ito氧
化鋁al2o3二氧
化硅sio2氧
化鈦tio2氧
化鋯zro等等膜層,另外其配置多靶可以鍍制多層膜,不但鍍制膜層細膩而且鍍制速度非常快,兼有其他鍍法的優點,所以是一種性能非常優良的鍍制超硬膜設備。
-
Cooling system with arc source not only reduces the calorie coming from evaporation of arc source, but also filter large - granule liquid drop. so it is widely used in plated aluminum alloy as well as in titanium nitride, titanium carbide, zirconium nitride, chromium nitride, titanium, nickel, chrome, copper, gold, and silver
帶弧源降溫系統不但可以降低弧源蒸發過程中生成的熱量,而且可以過濾部分大顆粒的液滴,所以大范圍的用於鍍制
鋁合金製品,廣泛適用於鍍制氮
化鈦
碳化鈦氮
化鋯氮
化鉻及鈦鎳鉻銅金銀等等。
-
The equipments and the wall of diffusion pump are made of stainless steel with wearable performance and simple operation, fit for plating aluminum alloy products, such as the titanium nitrides, titanium carbide, zirconium nitrides, chromium nitride, titanium, nickel, chromium and copper etc
設備和擴散泵泵壁採用不銹鋼結構,持久耐用,操作簡單,非常適用於鍍制
鋁合金製品,可以鍍制氮
化鈦
碳化鈦氮
化鋯氮
化鉻及鈦鎳鉻銅等等。
-
The modified nickel - supported catalysts possess good reaction performance, conversion of propane and carbon dioxide as well as yield of hydrogen
採用稀土改性的氧
化鋁負載的鎳催
化劑顯示出較好的催
化活性,比氧
化鋁負載的貴金屬催
化劑有更好的丙烷二氧
化碳轉
化率和氫氣收率。
-
Finally, some efforts were employed to eliminate the support al2o3, which is very difficult to remove after the crystallization of al2o3 during the synthesis process. it is proved that hydrothermal process is an effective method to remove al2o3
由於a12o :在
碳管生長期間從非晶變為晶體,十分難去除,因而提純過程相對復雜,最終結果顯示水熱法對氧
化鋁的去除是比較有效的,可作為進一步優
化提純的基礎。
-
Compared with carbon, silicon nitride bonded silicon carbide has better oxidation resistance and bigger resistance ratio, which make it be a perfect line material of al electrolysis cell
在
鋁電解方面,氮
化硅結合
碳化硅遠較陰極
碳塊耐腐蝕、抗氧
化、電阻率高,是理想的電解槽側壁內襯材料。
-
Our main products are silicon carbide, alumina ceramic, tungsten carbide, and carbon - graphite seal rings
我們的主要產品是碳化硅、硬質合金、碳石墨密封環和氧化鋁陶瓷製品。