碳結合力 的英文怎麼說

中文拼音 [tànjiē]
碳結合力 英文
carbon combining power
  • : 名詞[化學] (非金屬元素) carbon (c)
  • : 結動詞(長出果實或種子) bear (fruit); form (seed)
  • : 合量詞(容量單位) ge, a unit of dry measure for grain (=1 decilitre)
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  1. Carbon dioxide combining power abbr. co2cp

    二氧化碳結合力
  2. Co2cp carbon dioxide combining power

    二氧化碳結合力
  3. Co2 combining power, co2 cp

    二氧化碳結合力
  4. In this paper, fluorocarbon films are deposited on polyetylene terephalate ( pet ) substrate by radio frequency magnetron sputtering polytetrefluoroethylene ( ptfe ) targets to examine the effect of discharge condition on the properties and mechanism of deposited films. the effect of the power, pressure and treating time on morphology is observed by means of scanning electron microscopy ( sem ) and atom force microscopy ( afm ). it is found that the fluorocarbon film particles distribute more uniform and join tightly with increasing power, the surfaces of films become closer and denser as pressure increases

    利用掃描電鏡( sem )和原子顯微鏡( afm )研究了成膜機理以及cf膜的表面形貌,觀察了不同功率、壓和時間下對氟膜表面形貌的影響,系統研究了氟膜表面構隨功率和壓的變化規律,發現功率提高使得氟膜顆粒分佈均勻,更加緊密,而提高壓,氟膜的顆粒更加密集,並且濺射條件不同,粒子的形態、粒子間構成的介觀構也不相同。
  5. Microstructure of the composite layer was analyzed with help of optical microscope, scanning electronic microscope ( sem ), electronic probe microanalysis ( epma ) and x - ray diffraction ( xrd ). the compacting of the billet and the forming mechanism of the carbide reinforcement were studied based on thermodynamics and kinetics of reaction, sintering theory and the result of dta. at the same time, the wear - resistance of the composite layer was studied under condition of dry sliding friction

    利用光學顯微鏡、掃描電子顯微鏡、電子探針以及x -射線衍射儀,分析了表面復層的基體組織構;運用反應熱學、動學、粉末燒理論和燃燒成理論,差熱分析果,探討了表面復層壓坯的燒緻密化原理和化物增強相的形成機理;利用坯塊在真空燒爐不同溫度下的燒出來的顯微組織分析,模擬出坯塊的燒過程中的化學反應過程。
  6. Thus, the system could be kept at a lower super - saturation state under the condition of higher concentration of ca2 + to obtain aragonite whisker. the surface of aragonite must be modified to overcome the shortcomings leading to poor dispersion and combination with polymer materials

    為了解決作為無機填料由於表面親水疏油而在聚物材料內部分散性差、與高聚物本體差等的缺點,必須對文石相酸鈣晶須進行表面改性。
  7. Test research and theoretic study on shear strengthening of reinforced concrete restrained beams using externally applied carbon fabrics reinforced plastics under concentrated loads is presented in this thesis, which is part of the project of construction bureau of hunan province

    本文省建設廳課題纖維加固鋼筋混凝土構的受變形性能及加固方法研究,對鋼筋混凝土約束梁斜向貼cfrp抗剪加固進行了試驗研究和理論探討。
  8. In the paper, the study of strengthening reinforced concrete beam using prestressed carbon fiber reinforced plastic is introduced, which is the subsystem of repairing and strengthening reinforeed concrete structure using carbon fiber reinforced plastic, undertaken by college of civil engineering of hunan university

    本文省建設廳課題纖維加固鋼筋混凝土構的受變形性能及加固方法研究,對預應纖維布加固受彎構件進行了試驗研究和理論分析。
  9. In this paper, 4 types of vegetation ( broad - leaved, masson pine, chinese fir and phyllostachy pubescens ), which are widely distributed in subtropical area of southern china, were selected to investigate cotent and spatia - temporal, characteristic of wsoc. two kinds of bamboo { phyllostachy pubescens and phyllostachys praecox ) were used to test the effects of intensive management on soil loc

    本文採用野外調研和定位試驗相的方法,比較研究了亞熱帶具代表性的常綠闊葉林、馬尾松林、杉木林和毛竹林四種森林類型土壤活性有機的含量、空間變異、年動態變化規律及其與土壤其他肥指標的關系。
  10. Abstract : a preliminary investigation was made on hearth damage of a number of furnaces in china, and the analysis and discussion are presented for reasons of hearth damage in this paper. the main reasons of ring crack of the hearth are : 1. improper physical and chemical properties of baked carbon bricks. 2. the thermal stress existing in carbon bricks, alumina bricks and the furnace shell. the formation of the ring crack aggravates the abnormal erosion of the hearth

    文摘:鞍鋼2號和7號等高爐和2號高爐的調查果,對國內部分高爐爐缸破損情況進行初步調查,對爐缸破損原因做了初步分析和討論,認為造成我國高爐爐缸環形斷裂的主要原因是由於磚自身物化性能差以及爐缸磚和高爐爐殼之間的熱應;環裂的出現加劇了爐缸的異常侵蝕。
  11. The calculated results are in agreement with the measured ones, indicating that according to the flow rate and composition of the exhaust gas and the mass and the carbon content of the liquid iron, the carbon content of steel bath can be dynamically determined ; with the aid of thermodynamic equilibrium analysis, the dynamic variation of temperature of the steel bath can be forecasted from the dynamic carbon content and the data from the exhaust gas analysis system

    該模型計算果與檢測果吻較好,這表明:通過煙氣流量、成分及鐵水質量和初始含量可動態地確定熔池中的含量;以動態確定的含量為基礎,爐氣分析數據,再經熱學平衡分析,可預測熔池溫度的動態變化。
  12. Such low carbon power projects use fossil fuels such as natural gas, petroleum coke or coal for power generation combined with carbon dioxide capture and storage technology

    此類低項目二氧化採集和存儲技術,利用天然氣、石化焦或者煤等化石燃料發電。
  13. As an important blood biochemical index, the concentration of in blood serum, which is carbon dioxide combinability, reflects on the metabolism enginery activity. it can be used in judging the clinic patient ' s acid - alkali balance and electrolyte foul - up

    =血清中濃度即二氧化碳結合力,是血生化中一項重要指標,反映了新陳代謝機能活動,可用於判斷臨床病人酸堿平衡和電解質紊亂。
  14. Based on the test of 3 concrete beams reinforced with surface adhering sand carbon fiber bar and 2 concrete beams reinforced with surface adhering sand glass fiber bar, the deflection, balanced reinforcement ratio, failure mode, and ultimate capacity were analyzed and corresponding formulas are recommended

    摘要以3根粘砂纖維聚物筋混凝土梁和2根粘砂玻璃纖維聚物筋的試驗為依據,分析了纖維聚物筋混凝土梁的撓度變形和破壞形式,以及界限配筋率和正截面承載;並我國混凝土構設計規范對梁的正截面承載計算公式進行了推導。
  15. In order to evaluate resource objectively, it is very important to find out the origin and the main source of co2 and to study the distribution pattern of hydrocarbon, nonhydrocarbon gas and probe the controlling factors, diagenetic evolution of different reservoirs ( rich in co2 or rich in cflo and the relation between diagenetic features and co2 have been studied systematically by using conventional and advanced techniques and the integrated the methods of petrology and geochemistry. based on the petrologic and geochemical data as well as dynamics reactions of carbonate ? lay minerals, the origin and distribution of co2 have been synthetically discussed

    論文中應用常規及先進的測試技術,採用巖石學與地球化學相的方法,重點研究本區淺層氣藏富co _ 2儲層與富ch _ 4儲層的成巖演化特徵及其與co _ 2的相互關系,並通過天然氣的地球化學研究以及酸鹽礦物與粘土礦物反應形成co _ 2的熱學分析,對co _ 2來源及分佈進行了初步分析和探討。
  16. Characters of the pyrolysis chars and residual carbons such as reactivity, turbostratic carbon structure and specific surface area have been examined by thermal gravimetric analysis, powder x - ray diffraction and mercury intrusion methods respectively. catalytic effect of minerals has been identified

    高溫下不同煤質焦構趨於一致和礦物質催化作用的失去在一定程度上證明了假定活化能不隨煤質變化的煤焦燃燒反應動學通用規律的理性。
  17. The author makes effort to the dynamic information in development, exploring the method to study and appraises the characteristic on carbonate rock. the major research is as follows. ( 1 ) combining tahe oil field information of static and dynamic state analysis and the practice, carbonate rock oil reservoir dividing making up the model for three kinds : crevices - cave system, double - crack system and crevices - pore system

    筆者求充分利用各種開發生產的動態信息,探索研究和評價儲層特徵的方法及思路,主要研究成果如下: ( 1 )塔河油田動靜態分析和實踐,將縫洞型酸鹽巖油藏劃分為三類組模型:縫?洞系統、雙裂縫系統和縫孔系統。
  18. In this paper, basic mechanics performances of cfrp and afrp ( aramid fiber reinforced plastic ) are analyzed contrastively by using finite element method ( fem ) and experimental method

    本論文採用有限元分析和試驗研究相的方法,對纖維布、芳綸纖維布加固混凝土梁進行了基本學性能的對比分析。
  19. In the study, several ways were adopted for surface oxidation treatment of carbon fibers to improve binding strength between copper coating and carbon fibers

    本研究嘗試多種方法對纖維表面進行氧化處理以提高鍍層與纖維之間的
  20. Based on the experiment of five model t beams, the ultimate flexural capacity of reinforced concrete t beams strengthened with different quantities of cfrp laminates was evaluated, and corresponding design method was formulated, in the experiment and theory analysis, initial loads were considered

    以五片t梁模型破壞試驗為基礎,非線性全過程分析,研究了纖維布數量和二次受對鋼筋混凝土t梁承載能的影響,並提出了相應的設計計算方法。
分享友人